0
Scooters and Mini-Bikes
A scooter is a two-wheeled motorized vehicle with a small engine, providing an economical means of transportation. Minibikes (sometimes called "pocketbikes") have the same purpose, though they are normally used for amusement.
4,489 Questions
Do you need a motorcycle license in Arizona for a three wheel cycle?
Yes you do. Please see the following:
http://mvd.azdot.gov/mvd/formsandpub/viewPDF.asp?lngProductKey=2235&lngFormInfoKey=2013
My 2 month old 49cc pocket bike won't stay running is it my gas filter line or carburetor or what?
check air filter.if u have a filter for the gas on the line, make sure its not clogged up
Do you need a star nut for a scs clamp for push scooter?
yes, you should get one with the clamp but if not, buy one and insert it into your forks
50cc pocket rocket build plan's?
THATS NOT A QUESTION, A QUESTION WOULD BE WHERE CAN I GET 50cc POCKET BIKE PLANS ? OR WHICH POCKET BIKE FRAME IS THE BEST FOR 50cc, OR WHICH IS THE CHEAPEST TO MAKE ?
Where can you find wire diagrams for a 49cc mini chopper?
I searched FOREVER and this is what I come up with... its for super pocket bikes but its best I can find.
http://www.sdscooters.com/Tech/Super_Pocket_Bike_Wiring.html
Where can one buy some cheap but quality scooter handlebar grips?
One can buy some cheap but quality scooter handlebar grips from Skate Hut, Razorama, Skates, eBay and Amazon online stores. Having a quality scooter handlebar grips is very important, as it allows one to have a proper grip when one goes on a jump with the scooter.
The weight of a razor can vary depending on its type and design. A typical disposable razor usually weighs around 20 to 30 grams (0.7 to 1 ounce), while a multi-blade cartridge razor can weigh between 50 to 100 grams (1.8 to 3.5 ounces). Electric razors tend to be heavier, often ranging from 150 to 300 grams (5.3 to 10.6 ounces).
How can you make an electric razor scooter go faster?
To make a razor electric scooter go faster preferably an e300 you can buy a motor which goes on a e500 scooter this is a 500w motor which will fit on an e300 nicely but also if you get the 500w motor you need to get a 36v battery pair also used on e500 and a 36v battery charger if you get the motor and use a 24v battery you could risk blowing the battery or blowing the motor so in this case you have to get both so that everything will be equal on your scooter. You will need to get the charger because if you don't the battery will only charge up 24v out of 36v and won't last as long. If you are wandering if this is successful well then i will tell you it is because i have actually done this to my scooter and it works fine and is pretty cool. I did this to my scooter because i didn't like the look of the e500 and i couldn't afford the e500 at the time so i decided to do up my e300 if you like and do this to it and as i say it works perfectly fine and is awsome when people think you just have a normal e300 all my mates were shocked that it actually worked and the 36v battery lasts so much longer even when you are at full speed. also if you get the motor,battery and charger from America instead of it all costing £100 aprox it will cost $100 approx which is our equivelent to £45-£50 aprox when you calculate the currency becayse it is a very good exchange rate for us.
OR, get a +5kit from mykwilwin.... this wire adapter allows you to ad an r/c or airsoft battery (8.4volt) to you electric razor e100 e200 e300 or even the pb200 pocket bike and electric dirt bike's without major modifications or expense....
What does the re-stricter plate look like?
the restrictor plate is usually located inside of either the exhaust pipe, or manifold. it will typically look like an inset washer, and is used to restrict air flow from the header and to create backpressure on the engine, thus impeeding performance.
it is a small pocket inside a larger pocket on your trousers or shorts or and other items you wear on your bottom half.
How can you make a 1999 Yamaha jog faster?
You can make your 1999 Yamaha go faster by turning the fuel pump adjustment screw to the left. Make sure you do not turn it too far, as you can ruin the engine.
Do you have to have oversized bars for hic?
Oversized bars are not a strict requirement for a high-intensity interval training (HIIT) workout, but they can enhance stability and grip during certain exercises. The choice of bar size often depends on personal comfort and the specific movements being performed. Using standard-sized bars can still be effective, provided they are appropriate for the individual's strength and technique. Ultimately, the goal is to ensure safety and proper form during the workout.
What is the cc bike that one can ride without a license in Washington State?
in Washington state the largest cc motorized vehicle you can ride is a 50cc or smaller and just a tip you should get a state id just in case a cop pulls u over hope that helped
Does a 3.5 HP push lawn mower have a Chan to make a motorbike?
A push-type lawn mower does not normally have a chain. Dunno that you might want to use that type of engine to make a motorbike as the engine has a vertical shaft. You would need something to convert the vertical force to horizontal force to drive the gear on the motorbike.
How heavy is a madd gear pro scooter?
MADD gear pro scooters are really heavy and are amazing for a nice firm ride on the ramps but horrible for attempting good tricks like double tail whips bri flips and so on
