What tractor gets the worst mpg?
Any doing super heavy haul especially while pulling hills... Might average 2-3 mpg on flat, depending on the hills less than a mile a gallon... We had one in Arizona do 300 miles on day up and down hills and went through 400 gallons of fuel... But it's expected when you are pulling anywhere from 250,000 to 1 million plus pounds.
In tata lpt 2516 what describes lpt?
LPT means L stand for LOAD P stands for PASSENGER and T stand for TRUCK it means full form of LPT is LOAD PASSENGER CUM TRUCK.
How do you disassemble compact tractor Hydraulic cylinder?
disconnect the hyrolic lines first after arranging the equipment to the maximum clearence for the removal of the cylinder.
a vice helps.
spin the top of the cylinder below the shaft to allow the pin to start to be seen and pry it up and allow it to come out while spinning the top of the cylinder. pay careful attention to the arrangement of the seals.
1,000lbs or 1,500lbs
What rpms are used to upshift and downshift a eaton fuller 18 speed?
You can do it at pretty much any RPMs, so long as your timing is right. I can hit gears upshifting at 1300 or 1900 RPMs with no problem. What the ideal shift range is will depend on the engine. As a general rule of thumb, most people say 1400 - 1600 RPMs... personally, I like to shift a bit higher, and drop back down into the powerband when I go into the next gear, so that the engine isn't as prone to bogging down.
It could be spelled out for you, but the simple answer is to practice. This is something you really need to get hands-on with to learn - reading about it isn't enough.
Slack variable is a variable that is added to a constraint to switch form an inequality to equatlity equation.
Largest motorized SuperMarket Cart?
The Largest Motorized shopping cart measures 9 ft. 10 in. long, 11 ft. 6 in. tall and 5 ft. 11 in. wide. It was made by Edd china.
How much weight can you load into a 53 foot trailer?
Assuming you're referring to a 53' semi trailer, 41,000 - 43,000 lbs. for an 80k combination is typical.
mjfiihdguhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhjfffffffffffffffffffffffffffffffffffffffffffffffffffffffffffffffffffffffffffffffffffffffffffivvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvseeeeeeeeeeeeeeeeeeeesssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmccccccccccccccccccccccccccccccccccccccccccccccccccccccccccccccccccccccccccccccccccccccccccc
How many axels for 53 feet trailer and tractor?
Normally there will be 5 or 6 axles. 1 steering axle 2drive axles and either 2 or 3 trailer axles.(Some states do allow more trailer axles.)