0
Cleaning
There are many types of cleaning that need be done around the house. There are also many methods, tips, and tricks on how to clean. These question and answers about types and ways of cleaning.
11,817 Questions
How do you remove green mold from the exterior of a masonry wall?
Bleach ! Wash it with dish soap water and bleach.... I spray bleach directly on and then use a scrubby brush with dish soap and water in a bucket to scrub ..it wont take long and bleach will help keep it from returning if you mix water and bleach and spray occasionally
How do you clean stainless steel refrigerator?
I have a stainless steel refrigerator, dishwasher, and stove. Surprisingly, the best way to clean it is with Pledge and a furniture polishing cloth. I use orange Pledge, it smells great. Be careful though, I have tiled floors. If you have them too, wipe off any excess Pledge if it gets on the floor, as it can be very slippery. Good luck!
How do you remove scotch tape from a wall?
I had doubled sided tape across two large walls. I've read other posts and tried just about everything on the circa 200 pieces I had to get off. Every situation is different.
This post is in reference to my situation, which was:
- 200 pieces of double sided tape
- untouched for about 3 years . . . no consistency left (i.e. no "peeling it off" with a blow dryer)
- matte latex interior wall paint on relatively new drywall
I tried a number of options including goo gone, magic erase pads, soap and water, the old thumb rub, and goof off. They all work to varying degrees and with stipulations.
HAIR DRYER - First off, the hairdryer does work if your double sided tape still has some form left to it. I was able to peel off a couple of pieces and it was a fabulous relief. I didn't even need a hairdryer . . . I just got my spackle knife under the corner and went for it.
THUMB RUB - Thumb rub worked the best in that it had the least amount of damage to the dry wall. If I hadn't already committed to repainting, I would have done this out of desperation. I, however, got a huge blister on my thumb after one piece of tape and couldn't deal.
MAGIC PADS (available at Bed Bath and Beyond) - Didn't work on the real problem, but are good for a final run through. I felt to some degree that they were just moving paint around gently across my drywall. Which was good for smoothing out the surface but not for taking care of the real issue.
GOO GONE - Worked, but it about 4 applications with the spackle knife and I REALLY doused it.
GOOF OFF - My choice. It worked in about 2 applications but the downside is that it also takes off a lot of paint. I did notice, however, that when it hit my molding (which I assume is a satin) it didn't do hardly as much harm.
* SOAP and WATER doesn't work. Surprise! But it does help clean off the goof off and goo gone mess once you're done.
These instructions are for my preferred method, Goof Off.
I started with the smaller can, then reverted to the aerosol, which I liked better but it doesn't really matter. I had a huge roll of paper towels at hand and sprayed each piece of tape one at a time. I tried a soft cloth but the nasty glue wouldn't stick to it.
1. Spray and wait 30 seconds to a minute.
2. Push off with a spackle knife.
TIPS: a) wipe the spackle knife often, b) try to stay in a straight line . . . the double sided tape will stick to clean wall in a second if you wander at all, c) the goof off takes off some of your paint, so the more parallel your spackle knife is to the drywall, the better.
3. Do it again. I had to spray each piece a second time and wipe off with spackle knife. Afterwords, rub paper towel over gently so as to remove as little paint as possible while taking off the remaining residue.
4. Wash it off with a damp cloth. It's not going to be perfect and there are going to be some gray metal marks from the scraping. You can wipe that off with the magic pads or you commit to repainting. If your situation is anything like mine, you're repainting.
5. I followed up the goof off procedure with some spackling and sanding.
How do you remove candle wax from a satin dress?
soak it, spray with anti sticker spray and don't chew gum wearing a satin dress!!
What is the best way to clean glass shower doors?
Try a toilet bowl cleaner. Sounds weird, but it works. Answer I used "the Works" Tub & Shower Cleaner. Just drip down shower door and go over with a sponge. I did not need to scrub. Works very well. Important to read back label.
How do you get rid of a glue smell in a mattress?
You might try a normal dryer sheet.
ALL THE GLUES I USE (WOOD, 2-PART EPOXIES, WHITE, INSTANT, AND GORILLA GLUES, THE ODOR FROM THESE GLUES DISSIPATE THRU THE CURING PROCESS. IF ITS THE ODOR FROM THE GLUE WHEN YOUR GLUING THINGS TOGETHER, MOVE CLOSER TO A WINDOW AND PUT A FAN IN THE WINDOW TO EXHAUST THE ODOR.
How do you get streak-free windows and mirrors?
Usually best results are achieved by using a glass cleaner product such as Windex. You can use a paper towel or other lint free cloth such as a old t-shirt. Most times for things like a mirror, a couple sprays will do the trick. For larger surfaces that tend to have more dirt, spray cleaner evenly over the surface. After spraying your surface, take your paper towel or lint free cloth and wipe the surface until dirt is gone and surface is dry.
How do you remove labels from glass?
One of the best ways to remove price tags from glass is to use dish detergent which will easily remove the price tag quickly. One can also remove it by taking off slowly.
How do you clean moldy lampshades?
Vertical venetian blinds help filter the amount of sunlight that comes into a room and provide privacy, when needed. When vertical venetian blinds are exposed to warmth and moisture for prolonged periods of time the result can be mildew stains and odor. You can use:
White Vinegar
Lemon Juice
Tea Tree Oil
Scrub the surface of the blinds with a clean sponge and rinse the blinds off with a garden hose or a clean cloth, soaked in plain water. For more help, contact superblindsmart.com.au
How do you get black ink out of carpet?
Makeup is one of the hardest things to get out of carpet. One of the best things to remove cover up is peroxide, but you'll need to make sure that the dye in the carpet can withstand it. Most carpet cleaners, like Resolve, will eventually remove the stain.
How do you get ink stain off marble?
The Amodex Ink and Stain remover works great on all surfaces. It will work particularly well on a finished Marble, used in countertops. Simply pour the Amodex on the stain and rub in very well with an old toothbrush. It should lighten considerably, and once the stain is gone just wipe away the residue with a rag or paper towel.
How do you remove soot stains from brick?
Try Oileaters. It is a wonderful product.I have used it on my driveway concrete with wonderful results..no more oil stains! I purchased it at Costco or Sam's Club, but I have seen it also at Auto Part stores and supermarkets. If that does not get the stain out completely, try Oil Gone Easy S-200, a new bioremediation product that literally eats the oil. I got good results.
How do you clean silly putty off of fabric?
Put it under hot water and use a fingernail bristle brush with soap and it should come right off with a little scrubbing. I got it off of my I Heart Boobies Bracelet its rubber so it should come right off.
P.S. don't leave silly putty sitting around on the table. :-)
How do you remove Super Glue from leather and will it damage the leather?
Acetone will dissolve super glue, but it will probably also remove any finish from the wood, including stain. If you try this, be very careful to do it in a well ventilated space and be aware that acetone is very highly flammable, so don't have any flame or sparks anywhere around.
ANS 2 - Carefully use a very sharp craft knife to slip under the edge of the superglue and flick it off.
How can you remove scuff marks from a linoleum floor?
Even though rubber soled shoes leave the marks, you can rub the marks with your shoes and they will go away.
How do you get dried glue off wood and aluminum?
Try gasoline or acitone but there is no guarentee.
ANSWER:A couple of different ways. I use sandpaper to remove glue off of wood. I use a wet cloth to get it off before it dries. On aluminum, use a paint scraper or putty knife.ANS 3 - It depends on the type of glue - you haven't said which. -Aluminum is no problem, almost any glue will be removed with careful use of a thin blade ( eg.craft knife ). - Wood IS a problem. Very thin liquid glues will penetrate the surface and will be very difficult to remove.
What is the best way to sand hardwood floors?
I work for someone part time who has over 20 years experience installing and finishing hardwood floors, and honestly the best thing to do is hire a professional to do it. The tools available for rent to average consumer will take you over a week to do something we can do in one day, and also get your inferior results. I'm a big fan of DIY, but this is one thing where the pros have a distinct advantage of knowledge and equipment. You can do it, but if you want done quickly and properly (with good results), leave this job to the pros. you don't!!! or you get a profesinal! good luck!
What type of cleaner is best for removing magic marker from a painted wall?
Try hairspray or a magic eraser by mr clean .
How do you clean glue from cloth?
Depends what kind of glue it is. Most glues can be removed with Goof Off. Some others,particularly any white or yellow glues can be removed in the washer.
How do you remove sticky residue off of a cutting mat?
The best way to remove a sticky residue from plastic is to use a gentle emulsifier. A gentile antibacterial soap and a soft bristle brush can normally get rid of a sticky residue.
How do you clean brass candle holder?
Clean your brass with hot soapy water and a soft cloth. An old toothbrush will help out in tight spots. (If you're cleaning a lamp: unplug it before you start, and keep water away from the cord and socket area).
Never use anything abrasive -- no baking soda, wire wool, brushes, or acidic solutions -- on plated brass.
Cleaning dried scotch tape residue off wood furniture?
i used hairspray and a cloth takes a bit of elbow grease and quite a bit of hairspray but it works and after you have removed the stain then get a clean damp cloth and wipe down so it doesnt become sticky.
How do I clean heavily tarnished antique brass knobs and handles?
Firstly, ensure the item you want to clean, is actually brass. If it isn’t brass, you could end up tarnishing it rather than cleaning. The easiest way to check is to see if a magnet sticks to it. If it’s real brass, the magnet will not stick. If it does stick – do some further investigating and don’t clean it until you’re sure of the metal. You should also check the the brass has not been lacquered. Lacquer was sometimes added to prevent tarnishing, but it can start coming off in patches.
What will I need?
Lemon
Baking Soda
Small bowl
Spoon
Soft cloth or cotton wool
How do we clean the brass?
Cut your lemon in half, and squeeze into a bowl. Remove any seeds.
A spoonful at a time, add the baking powder to the lemon juice. Your mixture should end up with a toothpaste like consistency, so the amount of baking soda you end up using will depend on the amount of lemon juice you have. Ensure you mix the two ingredients together in the bowl. Don’t mix directly on the brass or you could up with patches.
Take a soft cloth or cotton wool and apply the mixture to an area of your brass object. You may want to test a small patch on the bottom or back of an object to help you decide whether to carry on.
work the mixture into the brass. A soft cloth may work better for you, as you could end up going through a lot of cotton wool.
Use warm water to rinse the brass and dry it off.
Use your second cloth to polish. Don’t be afraid to put some hard work in – the more gleam you want, the more you’ll need to polish.
kernowfurniture.co.uk/blogs/news/how-to-clean-antique-brass
