What is the color scheme of the audio wiring harness for a 1994 Chevrolet Camaro?
what is color scheme?
How do you change the front end turn signal in a 2002 Chevrolet Camaro?
Raise the front of the car and look underneath the front facia (bumper). You'll see a plastic cover on the bottom of the car. Located at each side in front of the tires you'll find access doors. Remove the screws. Now you can reach up and behind your front turn signal lights to change the bulbs. You can also get to the mounting screws this way to remove the light housings
How to change oil pan gasket on a 1993 silverado 4x4 w 5.7 sm block?
Since I don't know how to re-direct the answer to your post, Please see the answer to the question: "Do you need to drop the transfer case to change oil pan gasket on a 93 Chevy Silverado K1500 4x4 with 5.7L?" I had to change the oil pan on my 94 Cheyenne K2500, 5.7L 4x4 yesterday.
--------------- 1/15/09 ----------- You have 2 choices, either lower the front axle assembly a few inches, or remove the motor mount bolts and raise the motor a few inches. Take off the distibutor cap or it will crush against the firewall when you lift the motor. Either way it is still a tight fit to clear the oil pump and screen with the pan. You would get the most clearance by removing the front axle.
I am in desperate need to find out how to change an oil pan on a 2002 Camero can you please help?
You need to purchase a Haynes Manual at a parts store as it will have all you need to do the job.
How do you locate the Heater Fan blower motor on a 1979 Camaro?
"if it is the same as a firebird it is inside the left front fender. i had to remove the inside fender linear to get access to it on the firebird."
it is not on the left side, it is on the right side which is the passenger side of the vehicle. You have to remove the tire, then the fender well and then look way back up towards the fender wall next to the fender and you will see it. there are approx. 3 or 4 screws holding it in. if you raise your hood it will give you more light and you can see it better. I just replaced mine yesterday on my 1979 Camaro, I did the work myself so that is how I know where it is.
How much horsepower does a stock 2002 Chevy Camaro 3.8L V6 have?
200
The 3.8 in my 1996 put out 200 from the factory. This is the same 3.8 you have. It also puts out 197 lb/ft torque.
i have a stock V6 '02 camaro and it was dyno'd at 224 hp w/ 205 lbs of torque n@ 5500 rpm.
They have 231 horsepower off the showroom floor i know a person that works for GM with camaro's but it also depends on the condition of the engine, how new it is or how many miles it has on it. Power decreases over time.
Its 200hp.
The 231 is the size of the 3.8L engine in cubic inches.
Now 200hp is of course an average, and most cars will be close, but you may get one with a little more or less, although automakers will usually aim low on HP ratings to aviod embarassment, as Ford had over Cobras a few years ago and had to compensate by recalling them to give a larger gear ratio.
Where is the low pressure line for recharging the AC on a 1999 Ford Escort?
It is on or at the receiver dryer or shimy can looking thing at the rear of the engine compartment. You need gauges and refrigerant recycling machines to properly service the a/c
Where is the ecm on 1986 Camaro?
remove the panel from the bottom of the dash on the passenger side and look up into what would be inside of the dash and its right above you.
How can you change out an automatic and put in a manual tranny for a 76 camaro?
You will need a flywheel assembly, Clutch assembly, Through out bearing assembly, Bell housing and Clutch peddle assembly. A lot of hard work. Why just not beef up the automatic that's in it?
Will the fuel pump for a 1991 Z28 fit a 1998 Z28?
no the style of cammoro changed in 1992 from 2nd to the 3rd generation
How do you replace a fuel pump on a 1999 z28 camaro?
very large job. release the fuel pressure. remove fuel tank. disconnect the fuel feed, return, and vapor line as an assembly from the top of the fuel tank.remove the 5 nuts around the ring washer holding the pump in place.lift fuel pump out of the tank. CAUT-ION. do NOT bump the float or unit againstt the tank or it will alter the accuracy of your gas gauge.I recomend replacing the rubber gasket around the opening of the tank. remove the strainer from the lower end of the pump.if it's dirty, clean it. if it is too dirty to clean, replace it. lift the locking tabs to release the fuel pump cover from the frame. if you need to separate the pump and sending unit, disconnect the electrical connector and note position. disconnect fuel line from pump. separate pump from assembly. installation is reversed.
No street version like the mid 80's Camaros. IROC used Camaros from 1974-1989.
What is the horsepower in a 2015 Chevrolet Camaro?
Depends on the model: