0
Chevy Camaro
This category covers general questions about the Chevrolet Camaro, a pony car manufactured by General Motors and sold through its Chevrolet division. The Camaro was designed to compete with the Ford Mustang. Production of the model began in 1966.
4,208 Questions
What are the speaker size's in a 1995 camaro?
Standard radio: * Front door: 6 3/4" (6 1/2" will work) * Back seat: 6 3/4" (6 1/2" will work) Monsoon: * Front door: 6 3/4" (6 1/2" will work) and 1" tweeter * Back seat: 6 3/4" (6 1/2" will work) * Trunk: 4" and 1" tweeter
Where is the clutch slave cylinder located on a 1994 Chevy Camaro?
should be located on the bell housing
What years is the third generation Camaros?
'Third Gen' refers to both Camaros and Firebirds from 1982 to 1992. Both are built on a GM "F" body chassis.
What is the compression ration on a 1991 camaro rs 5.0 v8?
The lowest reading cylinder should not be less than 70% of the highest and no cylinder reading should be less than 689 kPa (100 psi). Perform compression test with engine at normal operating temperature, spark plugs removed and throttle wide open
Dash vents won't blow in 95 Chevy?
what could be wrong is you might have a vacuum leak somewhere or something is disconected in the dash that switches to the vents. I had a problem with my 97 blowing air threw the floor and it was a little vacuum leak that caused it
consult it with your electrician.
Make sure your just not losing water that was in the exhaust before you replaced the head gasket.
How do you change the turn signal light on a 1995 Chevrolet Camaro?
You will have to remove the lens either the front or rear. you did not say which.
How do you increase the hp in a 1988 iroc z?
Cold air intake, nitrous 75 hp system. exhaust, don't forget to beef your tranny, add a transgo shift kit.
Whats the average insurance price for a teenager with a Chevrolet Camaro?
Depends on the year of the vehicle and where you live. There really isn't an "average" nationally.
Where is the coolant temp sensor on a 89 camaro with a 2.8l v6?
It si right beside your thermostat housing
How much oil does a 3.8L V6 take?
most cars produced in the USA take 5 liters, your best bet is to put in 4 and check your dip stick, if low add some more, if alittle high dont worry about it. Your engine will push it out
What is a security resistor on a 92 Chevy Camaro key?
it is part of a security system called vats vehicle anti theft system it used a unique calibrated resistor for each car. multiple no start problems dirt and skin oils were getting on chips causing car not to recognize key amd module failures. the best thing to happen to this systen was a bypass kit made buy summit racing and jegs.
Will a 1982 Camaro rear end fit a 1983 firebird?
Yes... all third generation F body cars had the same crappy 7 - 5/8" rear end. I guess they were like 7.5" and updated to 7.625" later but it was the same housing so it all works anyway. I have an 83 camaro and blasted my rear and replaced it with an 87 that had 4.11's in it... now its a horribly fast accelerating one wheel wonder. I don't know who put those gears in it before junking it, but man is it a strange combination.
Abbott Enterprises offers a transducer with an ERA that converts mechanical to a electronic signal for your speedometer. They are located in Arkansas and can be reached at: 1-800-643-5973
How do you make your Chevy Camaro rs with a 2.8l v6 fast?
get a v8 engine lolz.....um try a intake, take off the powersterring ( addes more hourse power) get a supercharger (if automatic) or turbo (stick)....get a straight pipe....those are jus the basic but dats a good start
If the button(metal tab on windshield) is off there is a glue you can buy to reglue it. After following the directions on the glue package take youe mirror and slide it from bottom up using a strong even force while wiggling it into place, also keep an eye on any electrical wiring which needs to stay in place(ie rain sensor and auto dim mirrors) professional techs break about 1 out of every 50 windshields during this repair so be careful.
The good news about yellow or cloudy headlight lenses is that they are correctable. Cars were originally built with glass headlights that were easily broken. Most vehicles built since 1990 have polycarbonate lenses. This is a type of clear plastic that bounces back from considerable impact, making it an ideal choice for the front of a vehicle. The problem with polycarbonate is its tendency to yellow and cloud over time as a result of UV exposure. Fortunately, a number of products have been formulated to remove this haze and clarify damaged lenses with minimal cost and effort. In most cases, replacement can be avoided. There are many products on the market to accomplish this. Plastic Polishes made by 3M, Mequires, Wolfgang, just to name a few. Visit you local auto parts store and see what they have. You will need a polish pad for your drill. Follow the instructions carefully and you should be happy with the results.
