answersLogoWhite

0

🚗

Chevy Impala

Launched in 1958, Chevy Impala is a full-size vehicle built by General Motor’s Chevrolet division. It is Chevrolet’s most expensive vehicle and US best selling automobile through 1965. It is distinguished by its triple symmetrical taillights.

4,997 Questions

How do you open fuse box on Chevy Impala?

The fuse box on a Chevy Impala is opened by pressing the release on the side. It contains most of fuse which control the vehicle's electrical system.

Where is the knock sensor located on a 2001 Chrysler Sebring LXI 2.7L engine?

The knock sensor is in the V or valley of the engine. Its on the drivers side. Basicly its under the throttle body. To get to it you have to pull the intake off and the fuel injection plate. It seems hard but it really isnt, just time consuming. The car will run without it, but you wont be protected from detonation or bad gas. Dan,

Why does your 2001 impala squeal when engine cold?

Most common cause is a drive (serpentine) belt for alternator, water pump etc slipping a little. Check tensioner, replace belt if glazed. A HVAC supplier should be able to sell you an anti-slip spray on aerosol can, if you're into crude fixes.

Where is the ac evaporator drain located on 2005 Impala?

The 2005 Chevrolet Impala air conditioning evaporator drain is located on the bottom of the air conditioner compressor. The evaporator drain should have a tube attached to it.

What is the MAF on a 2002 Chevy Impala LS?

MAF on a 2002 chevy. This is a Mass Air Fow sensor. Located in the air intake on the air vent to the engine from the air cleaner. This tells the computer the volume of air to gas ratio and the computer compenates for the incomming air to the gas being accelerated throu the throttle body.

Why is your 2000 Chevy Impala ticking before you crank?

your fuel pump is in your tank.

its electric that's probably what you hear

What size carburetor was on the 1963 Chevrolet Impala SS 283?

I would say a 500 CFM but no bigger than a 600 CFM.

I don't know if you are looking for an answer on flow (CFM) or just a generic answer like "two barrel" or "four barrel".

As I recall, in 1963 the 283 was only offered with a two barrel carburetor. I believe the rated horsepower was 195. The carburetor was either a Rochester or a Carter. Flow was likely not more than 400CFM.

How do you put 22's on a 2005 Impala?

put a air suspension all the way around on the car.

Where are the O2 sensors on a 2004 Impala SS?

1 up stream before the converter rear exhaust manifold (closest to fire wall )

2 down stream is after the converter.

Where is the radiator drain plug located on a 1998 Chrysler Sebring JXi V-6?

The drain plug is located on the passenger's side of the radiator, all the way at the bottom of the face towards the motor. There is a small 1/4" hose connected just beneath it.

Remove head rest from Mercedes 380sl?

NO! they don't just "pull out". There is a button behind the seat under the back cover. Feel right under one of the posts, you will feel a "hole" in the hard back cover. It is very hard to push the button, so I remove the back cover, then you will easily see the metal rectangular spring button. Push it. The rails are pretty long so pull all the way first, then a firm tug should pop them off while depressing that button.

Why does your gauges and horn does not work on 2004 Chevy impala?

There was a recall on the "cluster pack" for that year and model so I was told by the Chevrolet dealership. I had to take mine in to be replaced (for free) at the dealership. Spedometer didn't work, gas gauge didn't register etc. etc.

P0113 code for 2001 Chevy Impala?

Trouble code P0113 means:Intake air temperature circuit high input

What size alternator is in a 96 Impala?

All 96 Impalas came with RPO code KG9 140amp CS144 alternator. The case diameter is 5 5/8" (144mm) diameter.

Location of thermostat 3.4 impala 2000?

At the end of the top radiator hose in the housing under the throttle plate.

How do you remove the door panel on the rear door on a 1996 Infiniti I30?

To remove rear door panelOne button in handle hole - not the door open lever handle but the hand hole, Philips screw underneath, several push pins around the outer perimeter to pry with flat blade or body style tool, lift panel up - remove door lever cup - lift out the panel upward

Where is the fuel pressure release valve on a 92 eclipse?

No valve that I know of. Take off gas cap. Remove fuel pump. Start motor and let it stall. Should be depressurized.

Your 1999 sable keeps overheating and there is much smoke coming from under the hood right behind the fire wall neer the stearing wheel you are trying to find out what is over ther themostat water pum?

It's probably the metal "T" fitting where the heater hoses are connected. I had to replace the fitting with a plastic one after the original metal one started to corrode. It would leak tiny streams of water when the temperature reached a normal level. The fitting is under the hood near the steering column.

Which is faster 2005 impala SS or a 2006 impala SS?

Both are quite fast, but i believe the 2006 would be faster than the 2005. 2005 Impala specifications, Horsepower (hp @ rpm): 240@5200 Torque (lb-ft @ rpm): 280@3600 2006 Impala specifications, Horsepower (hp @ rpm): 303@5600 Torque (lb-ft @ rpm): 323@4400 The 06' Impala has a higher displacement 5.3 Liter V8, where the 05 Impala has supercharged 3.8 Liter V6. More power = Faster car Most of the time more power means your car is faster, but sometimes weight, gear ratios, ect. make a diffrence.

Can you put supreme unleaded after you put regular unleaded in an impala?

You can but you shouldn't use supreme unless the car is specified for supreme and if it is you shouldn't put regular in it.

What type of engine did the 1965 Impala SS have?

The 1965 Impala SS was given a more streamlined look. It has an eight cylinder engine and it can max out at 250 horsepower with a maximum of 4,400 revolutions per minute.