Computer Hardware

i have the same problem

the main difference is:

in drum printer paper and pen(which r used to draw on paper and it can be one or more than one) moves simultaneously to draw..the movement of drum gives vertical positioning and movement of pens give horizontal positioning.

but in flatbed..paper does not move..all the movement is done by the pen and able to draw complex graphics..

Computer use continues to grow as more and more people rely on them for business and recreation. This trend isn't going to go away any time soon. Since the only thing that can replace a computer is a more advanced computer, both the hardware and software industries will continue to flourish.

It depends on how it's set up. If the wireless router is connected directly to the service, you should be able to connect the laptop without the desktop being turned on. If the desktop is connecte directly to the service and the router feeds from the desktop... no, you'll need the desktop to be running. No Its Doesn't.
You Just Need A Modem To Be Connected To The Desktop Computers Ethernet Port

A zip drive is a storage device similar to a floppy disc but of a larger capacity, 100, 250 or 750 megabytes.

Dual core is bassicaly two processors on ONE chip: Advantages The close proximity of multiple CPU cores on the same die allows the cache coherency circuitry to operate at a much higher clock rate than is possible if the signals have to travel off-chip. Combining equivalent CPUs on a single die significantly improves the performance of cache snoop (alternative: Bus snooping) operations. Put simply, this means that signals between different CPUs travel shorter distances, and therefore those signals degrade less. These higher quality signals allow more data to be sent in a given time period since individual signals can be shorter and do not need to be repeated as often. Assuming that the die can fit into the package, physically, the multi-core CPU designs require much less Printed Circuit Board (PCB) space than multi-chip SMP designs. Also, a dual-core processor uses slightly less power than two coupled single-core processors, principally because of the increased power required to drive signals external to the chip and because the smaller silicon process geometry allows the cores to operate at lower voltages; such reduction reduces latency. Furthermore, the cores share some circuitry, like the L2 cache and the interface to the front side bus (FSB). In terms of competing technologies for the available silicon die area, multi-core design can make use of proven CPU core library designs and produce a product with lower risk of design error than devising a new wider core design. Also, adding more cache suffers from diminishing returns. Disadvantages In addition to operating system (OS) support, adjustments to existing software are required to maximize utilization of the computing resources provided by multi-core processors. Also, the ability of multi-core processors to increase application performance depends on the use of multiple threads within applications. For example, most current (as of 2006) video games will run faster on a 3 GHz single-core processor than on a 2GHz dual-core processor (of the same core architecture), despite the dual-core theoretically having more processing power, because they are incapable of efficiently using more than one core at a time. The situation is improving: for example the American video game developer Valve Corporation has stated that it will use multi core optimizations for the next version of its Source engine, shipped with Half-Life 2: Episode Two, the next installment of its Half-Life franchise.[ Integration of a multi-core chip drives production yields down and they are more difficult to manage thermally than lower-density single-chip designs. From an architectural point of view, ultimately, single CPU designs may make better use of the silicon surface area than multiprocessing cores, so a development commitment to this architecture may carry the risk of obsolescence. Finally, raw processing power is not the only constraint on system performance. Two processing cores sharing the same system bus and memory bandwidth limits the real-world performance advantage. If a single core is close to being memory bandwidth limited, going to dual-core might only give 30% to 70% improvement. If memory bandwidth is not a problem, a 90% improvement can be expected. It would be possible for an application that used 2 CPUs to end up running faster on one dual-core if communication between the CPUs was the limiting factor, which would count as more than 100% improvement.

Creating a section on a drive to store data. You could have a partition to run XP and another to run Vista for example. You could have a partition just to store pictures as opposed to a file ECT.

It is best to wipe the hard drive before you remove it from the first computer and do a new install for the new computer. Then add your operation system.

Since a computer is not a liquid, it would not freeze in the sense that water freezes and turns into a solid (ice) when it gets cold enough. A computer that is not turned on will be at the temperature of its surroundings and if left in an unheated room in the winter in a cold climate, the parts of the computer may be colder than the freezing point of water. Computers, like many other machines, have optimum operating temperature ranges. If you try to operate a computer in an environment outside that range it may work poorly or not at all. If cold enough, a computer will not work well. In particular, if a computer has a liquid crystal display screen, cold temperatures will slow screen response and if the temperature is cold enough, the screen will not work at all.

I think the Question is how to recover images deleted from recycle bin? My answer is to use data recovery software from Recovery Bull Software... Jake Bull Recovery Bull Software http://www.recoverybull.com/

Foods composed of parts of whole foods, such as butter (from milk), sugar (from beets or cane), or corn oil (from corn).

If you are sure there is no other connection (they are often concealed under a flap) then the audio and video out are probably providing an analogue signal for play back on a TV. You will need a video capture digitiser (See links below for example but there are many available) that converts the signals into a digital form and passes these to the computer.

VIRUS!

No, not quite. I've run several virus scans with different software, none of which gave me an answer... plus, it's loading windows that is the problem, not running other software.

The "M" you are referring to would usually mean Model.

Heatsinks don't necessarily absorb heat. They usually act to divert heat away from sensitive components, and the heat is dissipated by fans.

The software that helps a computer perform essential operating tasks and enables other software to run is the operating system.

The Z1 contained around 20,000 parts and weighed about 1,000 kilograms. This is equal to 2,205 pounds. The designer of the Z1 was Konrad Zuse of Germany.

read only memory - information stored on R.O.M is permanent and cannot be deleted, but can only be accessed or read. random access memory-is volatile[rebooted,started up again] all the information that is held in R.A.M will be lost.

DOS is a program, so it's software. Hardware is the physical machine parts.

4GB, minimum size is 256mb.

Overclocking a computer too far out of its specifications can cause any number of problems. The most likely reason for the computer not powering on correctly after overclocking is that the memory bus has been pushed too high and the RAM cannot be written to properly.

You should be able to boot the computer by moving the recovery jumper on the motherboard, so you can access the BIOS and change the settings back. Alternatively, most BIOS these days will automatically revert the overclocked settings if it detects that the system has not booted three or more times consecutively. There may also be a button on the board to do this manually without moving the jumper.

a port for the IDE cable to connect the hardrive and cddrive to the motherboard.

1. Gently wipe the disc with a lint-free cotton cloth. Never use paper or any material that may scratch the disc or leave streaks.
2. Wipe from the center of the disc outward. Never use a circular motion.

A DVD Super Multi drive has the ability to both read and write DVD discs. This type of drive does not support LightScribe.---- according to the HP website,,,,,,,,,, The super multi drive does support LightScribe. And this is a program that adds a picture or information to a cd or dvd after writing/burning it by flipping the disc over after the burn is complete.... And YES you can read and write both cds and dvds with the super multi drive...IN MY OPINION....... Use Dual layer DVDs when burning because they have more storage space, just under 9GB on a single DVD. Web addresses cannot post here, but go to h10032 dot www1 dot hp dot com slash ctg slash Manual slash c00774531 dot pdf....... lol