Dashboards

== == Under the bonnet next to the battery. It is located in a black box, once cover is removed replace all blown fuses with correct fuses.

One of the car's fluids is running low, can be coolant or even window washer.

i dont drive but good luck

No, power inverters aren't good enough for Home audio equipment and the power supply inside your amp/receiver will buzz like it's going to blow up due to the power inverter. Trust me, been there, tried that.

safety restraint system

see www.fronteraowners.org site

The bonnet release cable breaking is a common problem in the Ford BA Falcon, and if done incorrectly removing or replacing it can result in having to replace the fuse block as well. It is best to have this done by a qualified mechanic.

First, make sure that the player is on (most usually have lights, signaling if their on.)

Then, unplug everything, and turn off you'r TV for about 30 sec

After that, plug it back in (make sure you get the cords in the right places)

then, press the eject button

If you do that several times and it doesn't work, contact a technichian

For anyone who answers this, reference http://forums.nicoclub.com/zerothread/337573 The second picture from bottom is my problem. Thank you!

This vehicle will still be in warranty,if you have a problem,vauxhall should sort it.You could void the warranty if you start delving into it for any reason.If you should be thinking of a speaker upgrade,suggest you have a I.C.E specialist do it.

I have a 1995 Chrysler intrepid and my dash lights do not go off when i turn on my lights but I may know why yours go off. Either right beside or below the knob used to turn on the headlights is a little dile that can only go up and down. This dile is used to dim or brighten the dashlights at night. The reason your dashlights may go off is because you have the dashlights dimmed way down (gotta love little perks Chrysler came up with) so try adjusting that dile. If that doesn't work, you may have an electrical problem or the light may be blown behind the dash. This could be really expensive to fix, so be prepared. .

by the dashboard!!

first you want to get in your truck put your key in the ignition and turn, once started stop turning key, put your seatbelt on and put in drive or first (manual transmissions only) now drive as you would nomally to your local dealer. they should be able to help you out for I'm sure what is a very reasonable price

Thanks

For the record I am not qualified to answer this question. Here it goes:

I have a 93' 318i and I've had similar problems with my dash. I took my car to a mechanic who said it could mean you have corrosion interfering with the plug ins in the back. Solution my mechanic offered to try and clean it for 50.00$. In my case that wasn't the problem since he tried it and it didn't work. He later recommended I get a new "Instrument Cluster." I checked my local "Pick a Part" aka junk yard to find one for about a $100.00. My mechanic said he'd install it for $35.00. Prices may vary where you're from. Hope this helps. Good Luck

E6000

Answer If it is the same as a 2000/2001 - You will need a "Torx/Star" drill bit or driver to remover these screws.

(STEP1-)Open drivers door

(STEP2-)Use flathead screwdriver to pop-off panel where the fuse door is. (Pop the whole thing off...not just the fuse door) (

STEP3-)Unscrew the screw closest to the A/C vent

(STEP4-)On top of your dash, there are 2 or 3 screws with the Defrost vent...remove them and the vent

(STEP5-)Open passenger door

(STEP6-)Repeat step 2 (minus the fuse door

(STEP7-)Repeat step 3

(STEP8-)Open glove compartment

(STEP9-)There are 2 or 3 screws on the top perimeter of the glove box...remove them

(STEP10-)Using a long screwdriver or nutdriver, unscrew the two "brass-looking" screws INSIDE the glove box(on the roof of the glove box) they are right in the middle. DONT DROP THEM OR THEY WILL BE GONE FOREVER!

(STEP11-) Just start pulling it off (If you here snaps, its normal. Because it is also held in by clips) (STEP12-)Unscrew the screws all along the top of the front dash trim

(STEP13-)Now start pulling the dash trim away from the dash

(STEP14-)While it is off, you will have to unsnap the dimmer control (from behind) and unplug the cig lighter (From the back. Also, the actual lighter stays in the dash trim)

You have to remove the calibar which is removed by the two pins that is held on by the two pins on the calibar. Most times these bolts are 3/8 heads Allen wrench. Then the calibar should lift off.

== == == == == == Go to LMCtruck.com

It depends on what you mean by "replacement dash."

If you want to cover up the unsightly dash then a dash cap from a place like LMCtruck.com will work fine. They actually look pretty good. If you want to actually replace the dash - for example yours is so cracked you can no longer attach the instrument bezel - then you need a place like wholesaleparts.com and input your year model etc. and look under "Instrument panel" and look for either "Upper Pad" or "upper Panel." Good luck!

pull up on it its held by clips

^There's a few screws, genius ;)

Click the "Courses" link. Hope this helped! :)

It's not easy. You have to: 1: unscrew the three bolts above the clear plastic cover of the dash 2: Unscrew the two black bolts that hold the stereo in then pop that panel out 3: Unscrew 4 gold bolts for the large panel below the steering wheel, these are just above your ankles, two of them are hidden behind the hood pull, and unsnap that panel 4: Under this panel there is a metal plate. Remove the top two screws and loosen the middle set. this allows you to access the next two screws. 5: Under the top of the metal plate are two bolts that hold the top panel in place, remove these. 6: Pull out the top panel, be careful to disconnect the two clips that latch behind the light knob before you pull the panel completely off. 7: Unscrew the bolts that hold the dash piece on, I'm sure you can figure it from here...