Heater only working on number 4?
It sounds like the blower resistor assembly is defective. All fan speeds except for
high go through resistors (that is what controls the speeds from low to high).
Number 4 is high and has the full 12 volts going to the fan.
Why is the engine light on in your Ford Fiesta?
The engine light comes on to show that there is a fault. Usually it is caused by a faulty sensor. You would need to have a diagnosis done of the Engine Management Unit to find out what the fault is.
Taking your car to the dealer will cost between £60-£80 but you can buy a diagnostic tool quite cheaply from Ebay or Amazon which will give you a fault code telling what the fault is, if it is a minor fault you can reset it and the engine light will go out.
Change oil filter on a Ford Fiesta 14 tdci?
Oil filter change - Fiesta 1.4Tdci.
The oil filter on the 1.4tdci is mounted on the right-hand side of the engine block (as you look in under the bonnet) and is in a black plastic housing which unscrews to expose a replaceable paper element filter. The filter housing points upwards at a slight angle, and looks like a fat black bottle with a hexagonal cap.
To get at it, first remove the front section of the air pipe which passes over it. This section of pipe can be taken out by removing the single screw and flexing the end of it out of the bracket above the radiator, then twisting and pulling it out of the connecting collar next to the air-filter.
Stuff some rag or kitchen roll around the base of the filter housing.
I find a 11/16" socket fits the hexagon, so a 27mm socket should fit. I read that this diesel engine is actually a Peugeot design, and Peugeot, being cleverer than Ford, seem to use those sizes where Metric or Imperial will both fit - for instance, the sump plug can be removed with a spark-plug socket, which can be a new 21mm or old 7/16" Whitworth.
Use a socket and extension and unscrew the complete housing. It'll take bit of gentle force to get it moving, and because it's plastic, it tends to flex. The housing may come off complete with the paper filter plugged into it.
The new filter will come with a new rubber-band seal which fits into a groove above the screw-thread. Push the new filter into the housing, offer it up to the engine and rote it until the plastic lug drops into its socket. Then screw the housing in by hand for a few turns to ensure it isn't cross-threaded, then tighten it with the socket spanner. Replace the air hose. Then use that kitchen roll to wipe that black oil off your hands!
Start the engine and ensure that the housing isn't leaking. (It won't be).
Where is the 02 sensor on a mk3 fiesta?
Look on top of the exhaust manifold. there should be a big nut with wires going into it. Hope this helps
How do you use a word finesse in a sentence?
You use the word finesse in a sentence by saying something like; the girl had a dissapointing performance which lacked finesse.
High level brake light on a fiesta 2003?
High-Level brake lamp bulb change.
Open the hatch back.
Remove the two rubber grommets behind the stop lamp.
Insert the flat blade of a screwdriver into each hole and press down the spring clip. The light unit will pop out of its seat.
Close the hatch and change the 16W wedge fitting bulb.
Click the light unit back into place and replace the two rubber grommets.
Easy when you know how!
Where can you get a diagram of a Ford Fiesta cooling system without spending any money?
Here is a video featuring a Ford Fiesta cooling system: https://www.youtube.com/watch?v=It87NHoX7ws
Fuse box on a Ford Fiesta 2001 where is it?
To bottom right of steering column small holder under dash, the back is removable and fuses in there if I remember correctly :D
Where is the jack or handle in a Ford Fiesta?
In the wifes Zetec its in the boot inside the offside panel just to the side of the light cluster access, if you getb were i mean.
What is the correct tire pressure for 1.25 Ford Fiesta zetec 2001?
29 front 28 rear
32 rear 29 front for Ford Fiesta Zetec 1.25 car 2001
try turning the wheel and unlocking the key at the SAME TIME ..back and forth on the wheel as you try to turn the key... if it doesn't work...call a locksmith.. also, read up on replacing the assembly... ...everyone should have a manual for their vehicle(parts store or dealer), and a local library should have professional shop manuals available in the REFERENCE section for free...make copies of the appropriate sections...read up and good luck :)
What is the curb weight of the 2011 Ford Fiesta?
The curb weight of the 2011 Ford Fiesta is 2578 lbs..
Does a 1998 fiesta 1.25 LX zetec have a timing belt or chain drive?
belt driven engine 10 years or 100k which ever comes 1st
What oil to put in Ford Fiesta v reg?
5w30 A1 semi synthetic or better still, fully synthetic oil. I use castrol magnatec 5w30 fully synth in my 2002 1.25 zetec and it runs sweet with it. Use a ford oil filter though.
How to change front wheel bearing on fiesta?
To replace the front wheel bearing on a Ford Fiesta, you will need to remove the wheel. Then with a hammer you can pull the old bearing out.
Where is the starter motor on a MK5 Fiesta back or front of engine cant find it?
Towards the rear of the engine, near the bottom. If you are under the car you can see it between the front axel and front exhaust mount.
If you are looking over the engine, look between the bulk head and the engine, right down.
[img]http://i423.photobucket.com/albums/pp320/pimpslider/starter_1.jpg[/img]
[img]http://i423.photobucket.com/albums/pp320/pimpslider/starter_2.jpg[/img]
Clutch fluid replacement 2002 Ford Fiesta?
It shares the reservoir with the brakes so it will be brake fluid to DOT 4 or DOT 5. If you don't have the owner's handbook contact Ford for the original type used. Be very specific about asking the DOT number. DOT 4 and DOT 5 do not mix.