Ford Fiesta

For a 2002 Ford Fiesta, the ignition coil leads typically follow the firing order of 1-3-4-2. The cylinder numbering starts from the front of the engine, with cylinder 1 being the closest to the timing belt. The leads should be connected to the ignition coil in that order, ensuring proper engine operation. Always refer to the specific service manual for your vehicle for accurate information.

To address an EAC (Electronic Accelerator Control) failure in a 2005 Ford Fiesta, first, check for any diagnostic trouble codes (DTCs) using an OBD-II scanner. Inspect the accelerator pedal position sensor and wiring for damage or corrosion, as these can contribute to EAC issues. If necessary, reset the system by disconnecting the battery for a few minutes, then reconnecting it. If the problem persists, it may require further diagnosis or replacement of the throttle body or related components.

well each radio has a different code u dick. otherwise itd be pointless

The rear doors are a pain to open if they deadlock (Mondeo 93 on inc facelift)

I found that by releasing the screws that I could get to (about 2) and removing the inner handle and pull and the screw buried in the lower part of the door card

with the window in the lowered position using a screwdriver to lever the door trim up and over the lip at the top I could just get my hand inside to put back the lever beside the inner door lock actuator fiddly but I sorted it i disconnected the c/l wires and the door opened manually damage to the trim was minimal and the problem could then be sorted in the normal way

check the TPS (throttle position sensor) check the TPS (throttle position sensor)

IT DEPENDS ON THE ENGINE TYPE,ZETEC IS SIMPLE,PTE ALSO EASY,HCS NOT SO EASY AS COIL PACK IS AT THE BACK OF THE ENGINE AND IS BETTER DONE ONE AT A TIME BY FEELING AROUND AT THE BACK ITS EASIER WITH THE AIR FILTER OFF TOO.

a common fault on some ford is that the earthing points for the electrical system corrode, and cause a bad earth. this can play havock with the light etc. Try cleaning them up. they are usually postioned on the

* front - inside the engine bay on the left an right hand sides, behind the headlights * rear, somehwre around the rear lights. An easy way to tell if this is your problem would be to get another person to stand behind the car, and put the side lights on, indicators and brake lights at the same time, you may find that all the light go mental, in which case it is your earths!

Torque head to 50-55 ft/lbs

A '98 Fiesta uses H7 bulbs, which comprises both your dipped beam and your main beam.

90 to 100 lbs