Where is the fuel tank pressure sensor location on 2003 GMC sonoma?
IT IS LOCATED ON THE FUEL PUMP ASSEMBLY. It is the smaller electrical connector on top of the fuel tank
Why a 1995 Sonoma 4.3L Cranks no fire?
i would start with control mod and from there maybe a crank senser
Will doors off of a 94 s10 fit a 94 sonoma?
The doors off a 94 Chevy S10 will fit on a 94 GMC Sonoma with minor modifications. Both use a very similar body design which is largely only different in cosmetic features.
Oil pressure drops to zero at idle an goes back up with engine speed?
1. low oil
2. probably have a electronic oil pressure sensor, senor can fail. mechanical gauges have a oil line running to the back of the gauge and don't fail unless the oil line is cut, and that would leak lots of oil fast, running your engine out of oil.
3. short in wireing
What are safety features of the GMC Sonoma?
"Some of the safety features of the GMC Sonoma include: Driver airbag, ABS brakes, traction control, stability control, power windows, power locks and first aid kit."
How do you replace the headlight bulb located on a 2003 GMC Sonoma?
If its anything like my 04 sonoma, there should be two flat pins which hold the headlight assembly in place. the pins come out, the socket for the bulbs become acessible. twist out and replace. .
My 97 Sonoma was doing the same thing and a good tech found it was a bad ignition switch. The truck runs great again.
Where is thermostat cooling sensor in 2002 gmc sonoma?
Coolant Temperature Sensor/Switch (For Computer)Locations View
How do you unlock radio on 2000 sonoma I have the code?
In order to unlock the radio of a 2000 Sonoma, first start the car. Then turn on the radio. Using the minute and hour buttons, enter the code that you already have. Then, press the AM/FM button.
Why does the brake indicator light stay on in a S10 pickup?
The brake indicator light is for the EMERGENCY break, release this break.
Where is the tach signal connector in 1999 Frontier?
Tach signal?
To install a Tachometer?
I did it 2 days ago! finnaly got a Tach on my 1998 Nissan Frontier By concept 1 4 cylinder 2.4 right?....Yep if you would still light to know Email me at
x31diablo31x@aol.com
or myspace is
myspace.com/diablo31
peace!
What is the firing order of a 1992 GM Sonoma?
"No Sonoma in 1992, It was called S-15", is not true. i have a 92 sonoma, the owners manual calls it a sonoma, all of the badges call it a sonoma, and the sticker on the drivers side door calls it a sonoma. it was built in 10/91 which makes it a 92. the trucks were allready being called "sonoma" in 92 but is true that the distributor rotates clockwise on all engines. 2.5L --1-3-4-2 2.8L --1-2-3-4-5-6 4.3L --1-6-5-4-3-2
Where can you camp in sonoma county?
Check out 101things.com.It tells you everything you need to know about planning a trip to Sonoma County. They're really the best I've come across for info. They also have a printed magazine you can pick up most anywhere in SOnoma County. Enjoy your trip!
How do you install a transmission on a 2000 sonoma?
the best thing for you to do is go to your local Parts House and pick up a service manual on your truck. It will tell you how to go about removing and replacing your tranny.
How to adjust the parking brake on a 1995 GMC Sonoma pickup truck?
The adjustment is on the cable running along the outside of the left frame rail, it is located about even with the door. There is a threaded rod that you screw in or out to adjust it. You will have to spray it WD40 or someting like that to get it to turn if it has never been adjusted before.
How do you fix the taillights on a 1991 GMC Sonoma if it keeps blowing the fuse?
install a test light in place of fuse and then check each tailight/parking light socket for bare or shorted wire - could be under vehicle in harness that runs to any of the light sockets--could also be under dash, I think dash lights are common to this circuit
the selector switch is a vacume and electric switch that activates the pnumatic vents, ac and fan. on the back of the selector there are tubes that feed a vacume to the vent flaps and a three wire plug for ac and fan control. if you lose vacume the vent flaps stay in the defrost and floor position but the ac and fan will still work. on my sonoma the vacume line came disconected under the hood. the vacume feed exits the firewall on the drivers side right next to electrical harness.
Where is the fuel filter 2001 gmc sonoma?
The fuel filter is under the truck on the frame. Near the drivers door.
How do you change heater core in 1992 GMC Sonoma?
The entire dash must be removed. There are visible screws inside the cab and then there are more fasteners on the firewall side. It is a very difficult process. I bought a core from a local business and after struggling with it for about a week I took the truck in and had it done. It isn't an easy job. There are a few sites on the net with pictures of the process but I can't find them right now.
Where is the clutch bleeder valve on a 1998 gmc sonoma?
Concentric slave cylinder mounting-1996-99 vehicles equipped with the New Venture Gear transmission.Its mounted in your transmission,but the bleeder screw is assible because theres a hole in transmission,where bleeder is,just put wrench on and loosen,have someone one push clutch pedal to floor and hold,then open valve,do this till air is gone,theres another hole next to hole where bleeder screw is,a metal tube comes out of that one,its the clutch fluid line,good luck.
Is there a adjustment for rear brake pads on a 2000 GMC Sonoma?
If your rear brakes are disces you cant adjust them but if there drum brakes they can.There is a small oblong hole at the bottom of the backing plate.Jack up one side and try adjusting one wheel at a time.You can use a flathead screw driver to do this.
1994 GMC sanoma 2.2 engine distributor wiring diagram?
where are the coil wires located, and where do they hook up
Where are the oxygen sensors located on a 2003 GM Sonoma?
on the drivers side underneath the engine by the front tire. You will notice a pigtail leading to the exhaust in this area. This o2 sensor is the main sensor, there should be a catalytic o2 sensor located after the converter.