0
GMC Sonoma
The GMC Sonoma, also known as the Chevrolet S-10, is a small pickup truck manufactured by General Motors from 1982 to 2004 in North America and 1995 to the present in Brazil. It features a front engine and rear/four-wheel drive.
926 Questions
What is the towing capacity of a 2000 gmc Sonoma?
Maximum towing capacity on the 2000 lineup has been increased by 400 pounds and is now up to 6,400 pounds (when equipped with a 4.3-liter V6 engine, automatic transmission, 3.42 or 3.73 axle ratio and aftermarket weight-distributing hitch). The standard step bumper is capable of handling trailers of up to 3,500 pounds. Two final drive ratios are available, one for standard duty and a shorter ratio for heavy hauling.
How do you replace a transmission filter on a gmc sonoma?
unbolt transmission oil pan, if it has drain plug drain oil first, if not unbolt it and drain it, filter will be right in sight, pull it off, push new one up there
How do you change clock on 02 GMC Sonoma?
Depending on the type of stereo is in the truck, I have a AM FM Stereo, CD, Tape system. At the lower left hand corner of the unit there is two little buttons one labled with an H the other with an M. Pressing either one of them for more than 5 seconds will start the time adjust sequence.
Is the GMC Sonoma efficient on fuel?
The GMC Sonoma is not very fuel efficient. It gets 19 miler per gallon city and 25 miles per gallon highway, for a combined score of 22 miles per gallon. This is not very high compared to many newer vehicles.
The above answer may be true when you are comparing the Sonoma to cars but within the truck category where it competes this is good fuel mileage for a truck.
no it does't disturb the freon . the clutch comes off with puller and the coil comes off with a little lube and pry bars slowly. .
How much horsepower does a 95 gmc sonoma have?
Below are the options for 1995;
Standard:
2.2L I-4 118 HP
Available:
4.3L V-6 165 HP
4.3L V-6 195 HP
The V6's differ, One is Throttle Body injection the other is Multiport Injection
T/B 165 HP
M/P 195 HP
What is the engine oil capacity on a 1995 GMC Sonoma 2.2L engine?
You need 4.5q of 5W-30 for an oil change.
im asuming you have a 2.2 4cyl, if you do it is more accessable to remove the motor in order to drop the oil pan. i have tried to battle a 2001 with a 2.2 myself without removing the motor and its verry imposible. the pan sets on a skid plat with less than a inch of room between it and the pan. even with taking out the motor mounts and jacking up the motor my transmission hit the engine wall.
Where is the horn relay switch on a 1995 gmc sonoma?
It is in the rear left side in a removable panel in the glovebox of my 1995 [manufactured 8/94] GMC SLS Sonoma, 4x4, 4.3 vortex; hopefully, it is in the same place in yours...
Where is the horn relay on a 1994 gmc sonoma?
Under the dash towards the center, you have to remove the lower dash cover and it should be just to the left of the two accessory power outlets. Hope this helps
What is the head bolt torque on a 2002 gm 2.2 liter 4 cylinder engine?
according to chilton repair manual. long bolts- 46 lbs short bolts- 43 lbs then after torqued, tighten an additional 90 degrees. the long bolts are the bolts under the valve cover. the short bolts run along the exhaust side of head
Where is the fuel filter located on a 1993 GMC Sonoma?
The fuel filter is on a 1993 Sonoma is under the truck bed between the drivers seat and the driver's rear wheel. It is almost always easier to replace the entire filter can than opening it up and replacing the guts.
What does a code 25 mean on a 1991 gmc sonoma 2.5 engine?
Code 25 indicates a MAT sensor. In my case, I have changed the MAT sensor and several other sensors and I still have the intermittent 25 code. I am currently trying to track down a vacuum leak. (Which I should have done immediately after realizing that the sensor wasn't the problem.
Where is the blend door actuator located on 95 gmc sonoma?
The temperature valve actuator is located on the front of the heater case
Replace the fitting.
Where is the 02 sensor located on a 2001 GMC Sonoma?
exhaust everyone should have a manual for their vehicle, and a professional shop manual should be available at the library in the reference section for FREE...make copies of the right pages and fix your vehicle like a PRO! :) good luck Dave :)
How do I remove the Wiper Arm on A 2000 GMC Sonoma?
Remove wiper cap. Then take a 13mm wrench and take off the nut. the pull wiper in the up position and jiggle back and forth and wiper will come off
Why do i have Very high fuel consumption?
Binding brakes, choke sticking, clogged air filter, fuel leak, injectors (if fitted), slipping clutch (manual), transmission slip (auto). too much right foot. Kids taking the car when you are asleep.
How many gallons of gas does a GMC Sonoma 91 hold and what is the mileage via highway per gallon?
The miles per gallon on the highway for this car is between 21 and 26 miles per gallon. The gas tank capacity for it is 20 gallons.
How do you replace spark plug wires on a 1995 Chevy Cavalier?
The manual does not show or tell how to change the spark plug wires.It's like they purposely left that information out. I am trying to replace the wires on a 1996 cavalier and the ends that connect to the coil packs go through a space in the intake manifold pleneum (Top part of intake).I removed wheel thinking I could reach it through wheel well but can't reach. Possible if raised car high enough off ground could reach. Can't easily get arm through next to firewall to reach. Only other way is to remove the intake manifold.What a hassel just to replace spark plug wires. Wish I could find an easier way. Sorry...I can't believe it's this hard either. Joey(bjobotts)
You may want to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.
I just replaced the spark plug wires today in a 1996 Chevy Cavalier 2.2 Liter. After saying some choice words about engineers placing the distributor coil at the rear of the engine. I decided to look at it from different angles as mentioned above with removing the wheel and then trying from above between the engine and firewall. I couldn't jack the car up high enough to get underneath. So I drove the car up on ramps and had ample room to manuever under the vehicle. If you enter from the front of the vehicle on your back and slide towards the rear, you will see a hole and through there you will have a direct shot at the distributor. My wife helped me by feeding wires ONE AT A TIME as I unplugged the wire from the distributor coil and let her pull it up and then would feed me a wire and I would plug it in and then so on with the other three. This process took about 20 minutes after, of course, finding the proper way to get at the distributor. Make sure to have a light shining down the space between the firewall and the engine so you can see what you are doing. Make sure to mark the wires before on the old wires and after on the new wires. You do not want to change your firing order! If you do some how unplug two and don't have them marked. The order is easy. Looking at the engine from the front of the vehicle - 1 2 3 4. When you are underneath the vehicle, the numbers are on the distributor. , it saved me about $200 by not going to a mechanic. Not too bad for a couple of hours of getting dirty. Brian
How do you change the time on a 2002 GMC Sonoma clock?
Depending on the type of stereo is in the truck, I have a AM FM Stereo, CD, Tape system. At the lower left hand corner of the unit there is two little buttons one labled with an H the other with an M. Pressing either one of them for more than 5 seconds will start the time adjust sequence.
Which side of engine is Bank 1 for oxygen sensor on GMC Sonoma?
Assuming the engine is a 4.3L, bank 1 would be on the drivers side.
