0
GMC Suburban
Also known as GMC Yukon XL, the GMC Suburban is a full-size sport utility vehicle manufactured by General Motors Company from 1935 to the present. It has been one of General Motors’ most profitable vehicles.
904 Questions
What is the gear ratio on a 1994 suburban?
There are four ways to find a ratio.
1 A dealer can normally tell from the vin number.
2 There are normally tags or labels on the axle that have part number, gear ratio, and fluid requirement
info.
3 You can count how many times you have to turn the driveshaft to get one complete turn of the tires.
4 You can divide the number of teeth on the ring gear and divide by number of teeth on the pinion.
How do you fix a P0300 on a 1999 suburban?
You have to find out what is causing random misfires in the engine.
See related question below.
What type of freon came stock in a 1993 GMC Suburban?
R12 is stock but most people convert to r134...personally I feel the r12 cooled better in my suburban
How do you remove a stock CD player from 99 suburban?
alright, i have a 99 Tahoe, and its the same way.. what you gotta do is turn the key on.. but don't start the truck, drop your shifter all the way down to first (shifter likes to get in the way) and pull the dash cupholder out. afer this has been done you just pull on the front part of the dash and it pops off (no screws, just clips) then you need to unsnap the headlight switch.. pretty easy if you just look at it. (unplug the 4x4 cables if you have a push button 4x4 system) now the dash should be removed. there are two plastic clips that hold the stock radio in the covey hole. press these down while pulling back. the radio will just slide out. then you just unplug the main wire harness and the antenna.. and that's about it. you will need to get a size adaptor to fit a smaller deck in your truck. its a 1.5 DIN.. just go to walmart or a stereo shop and they'll hook u up with one. and instead of cutting your vehicle's plug off. get a wire harness adaptor. bout $10 and all the wires are labled. and you can just unplug your aftermarket and throw your stock back in if you ever sell this truck. and you need an antenna adaptor.. not sure what size it is.. but just go to walmart or a stereo shop.. tell em that u got a 99 burban and they can look it up.. if you want to sell this stock radio.. please email me about it.. the Tahoe of mine has a stock tape player... anyways my name is Rivers K and my email is rivbro91@gmail.com
this should be it!!
RiversK
How do you time 93 gmc suburban?
This is for timing a 93 suburban with a throttle body carb.
On the passengers side firewall in the engine compartment there is a cover with three
plastic nuts. Take off cover and look for a cylindrical plug about 2 1/2 " long it usually has
a tan or brown wire going to it with a dashed lined with another color. Unplug this wire,
then start truck and set timing to 0 degree TDC . Turn the truck back off after setting
timing and disconnect the positive terminal to battery. Wait about 10 to 20 seconds and
reconnect battery, now plug the cylindrical plug back in and check timing again, it should
still be at 0 degrees TDC. If not repeat process again to ensure you didn't miss a step.
This procedure resets the computer.
Where is the fusible link for the ignition on a 1986 GMC suburban 6.2 diesel?
1973-86 C/K and 1987-91 R/V GM Pickup, Suburban, and Fullsize Blazer Fusible links are attached to the large starter lug along with the battery cable.
They run from the main harness on the firewall down to the starter "battery" lug, along with the "start" and "power with start" wires, through a wire protector attached to one or more bellhousing bolts.
Original GM fusible links can be identified by a large diameter molded rubber or PVC ring on the wire.
You may need to check the hoses connected to your heater core. Or you may have sprung a leak in your heater core.
Why is my 89 suburban with a 350 surging?
Try your throttle body gasket...before the IAC ;)
NEW ANSWER: The most common cause of that is the EGR VALVE. Check it first and make sure it is working right.
Where is the starter motor on a 1999 Chevrolet suburban?
below the engine, passenger side, at the rear. 1 small trigger wire, 1 heavy battery cable, 2 starter mounting bolts.
How do you unlock a suburban when keys are locked inside?
The easiest way to solve that problem is to call a locksmith to unlock it for you.
How do you unlock a 454 with water damage?
First. Remove all the spark plugs. Drain all the oil. Turn the engine over by hand VERY SLOWLY. Squirt some oil down the spark plug holes. Light oil. (Marvel Mystery Oil) Turn the engine over again. Refill with fresh oil & new filter. Install new spark plugs. If the fuel system was not compromised FIRE THAT BABY UP!!!
What is the little speaker for on the headliner above the drivers seat on my 2002 Yukon XL?
Onstar and/or hands free cell phone speaker.
Extremely worn or loose shocks, bad upper or lower ball joints, worn control arm bushings.
How do you change the rear transmission seal on 2002 suburban?
output shaft seal
It should just pop out with a screwdriver once the drive shaft is out, the new one presses in, use a hammer and a socket the same size as the metal part of the seal.
93 suburban knox sensor location?
It is screewed into the side of the engine block. It is over by the starter.
Fuse keeps blowing on 95 Suburban for tail lightsdash board?
had similar problem ended up being pigtail for my trailer lights had a bad connector and a spot where insulation rubbed off creating a short and blowing that fuse
How do you reset the ABS light on a 1996 Suburban?
Bring to a shop that has an ABS scanner to determine the problem
Where can oil leak out of in a 1993 suburban?
Need to check the oil cooler lines, there are 2 of them that are hooked to the oil filter adapter just above the oil filter and they run up the side of the engine and go into the radiator. Driverside. They are probley leaking.
Do you have to change the spark plugs when you change the O2 sensor on a 1995 5.7L Suburban?
No, the spark plugs and O2 sensor are totally different things.
that is not right!! they are the same things!!
What other years of Suburban engines can i use in my 1999 suburban Will a 1995 match up?
Assuming that you have a 5.7L 350CI engine you need to find a 96+ VIN R engine, to replace it with.
Why is ECM-1 blowing fuses on 1999 suburban?
If the ECM-1 (Engine Control Module) is blowing fuses on a 1999 Suburban, it may be due to a short circuit in the wiring, a faulty ECM, or an issue with connected sensors or components that are drawing excessive current. Inspect the wiring harness for any signs of fraying or damage, and check for any aftermarket modifications that could overload the system. Additionally, it’s advisable to test the ECM and associated components for faults to isolate the cause of the blown fuses. If the problem persists, consulting a professional mechanic may be necessary for a thorough diagnosis.
1990 gmc suburban 2500 ac blower not working fuses are good.?
Check at the blower motor itself. Have it turned on and tap the end of the blower motor with a hammer. I did this and found out that the blower motor was going out.
The blower motor is on the top passenger side under the hood. Also check the wire connections. Make sure they are seated good. If this includes for the heater then I would say the blower motor is bad.
Why does your 93 Suburban shake at 65 to 70 mph I have new tires?
It could be several things, 1st check and make sure the wheels are balanced properly, 2nd your shocks could be bad, my guess would be, improper balance of the wheels,or you have a loose wheel, (lug-nuts) make sure all your wheels are tight.
