How do you remove door pannle on GMC Yukon?
Not sure what year you are working but generally you would start by removing the trim around the door handle. A putty knife works well for releasing the tabs. Then comes the screws which hold the arm res in place followed by several screws near bottom of panel. Idealy, you have a tool for removing the plastic inserts that hold the panel to the door, but a wide blade screwdriver can be used if done carefully. Then it is disconnect the wires on the backside of the panel. These can be tricky, but usually you can see where to squeeze to release them.
Turn off the passenger side airbag in a Yukon?
you put your key in the opening where the pasanger on of switch is and turn rigth you shul have turned it off
Where's a diagram of the firing order for a 1999 gmc Yukon?
i need the firing order for the the spark plug wires for a 1999 gmc Yukon
The firing order for the 1999 GMC Yukon is 1, 6, 5, 4, 3, 2. The number one cylinder is found at the front right of the engine.
How do you program garage door opener in 07 gmc Yukon Denali?
how do you program my garage door opener in 2009 gmc yukon
What is the front track of the 2002 GMC Yukon-XL?
The front track of the 2002 GMC Yukon-XL is 5 ft. 5 in. (65 in.).
What is the base engine size of the 2001 GMC Yukon-XL?
The 2001 GMC Yukon-XL has a 5.3 L base engine size.
Where is the fuel pump fuse on a 2000 GMC Yukon XL?
fuel pump fuse should be in the fuse box underneath the dash on the drivers side
How do i fix a 1994 gmc suburban door latch that's stuck and the door won't shut?
Remove door panel and replace latch mechanism
How do you release emergency brake on a 2002 GMC Yukon XL with broken cable release?
My 2002 Yukon XL emergency brake cable just shredded this week. The cable is only a couple feet long and connects the release latch to a lever just above the emergency brake pedal (while depressed). The lever can be manually released by hand but be careful to guard your face as it could be in the path of the rising brake pedal. It may require 2 or 3 manual trips of the lever to get the brake pedal released to the highest position.
I am still trying to determine where I can buy a replacement cable (other than GMC dealer) and whether I can replace it myself.
What kind of coolant goes in 1996 GMC Yukon?
50% mixture of Dex-Cool and water.
Other 'universal' extended-life ethylene-glycol based coolants are also acceptable but do not use 'green' coolant with silicate based corrosion inhibitors.
Will a 1990 GMC rear end fit a 1994 Yukon GMC?
you would have to check the code in the glove box and call the local parts store and have them tell you what rear end goes on the Yukon and then find out what rear end the 1990 rear end is and if they are the sam gear ratio then they ar enter change able .
How do you remove wiper arms 2002 gmc Yukon?
Sometimes there is a bolt holding the arm to the armature of the wiper mechanisum or you stand the arm up away from the glass;(some arms have a little holder that has a little tab on it to slide it into position to hold the arm up. If you have one of thses in the basr of the arm you'll see it) using a block of wood between the glass and part of the wiper arm that in pressed onto the armature you use a prying tool to lift the base from the arnature. The base is spring loaded so watch out; it'll jump when releasing.
Go buy a Haynes Automotive Service Manual for your vehicle and check your local library for On-line resources for auto repair info.
Just in case you meant wiper blades (blades and frames) rather than wiper arms (actually attached to the spindle)... See sources and related links below for wiper blade installation videos.
Where is the oil drain plug located on the 5.3 liter engine in a 2008 Chevrolet silverado?
Center rear of oil pan, It is a cast alumium pan the oil filter will be just left and up from it.
15mm bolt.
Why does my steering wheel shake on a 1998 gmc Yukon?
if it happens when braking, check the stabilizer bolts. both mine were broken
When should you change your fuel filter on your 2004 GMC Yukon Denali?
Every 50,000 miles or whatever your owner's manual lists.
Just completed this job. You'll need to remove the HVAC control head, not too hard a job...just remove dash trim, pull control head by releasing side tabs, remove electrical connections at the rear. Once out of the dash, there is a black switch that sits behind the blower speed control. there's plastic piece that must be removed before you can remove the switch. replace and reinstall. You should be able to find the replacement part on Amazon for $15 or so. Good luck.
How does a serpentine belt go on for a 1999 GMC Yukon?
THERE SHOULD BE A DIAGRAM ON A STICKER LOCATED UNDER THE HOOD, USUALLY ON TOP OF THE RADIATOR. THERE SHOULD BE A DIAGRAM ON A STICKER LOCATED UNDER THE HOOD, USUALLY ON TOP OF THE RADIATOR.
Can antifreeze leak from engine head of Chevy suburban or is it coming from somewhere else?
It means that your water pump is about to sh!t the bed. COnsider changing soon. My 1997 Suburban had the very same symptom, slow fluid leaks. Then, one day there was a sudden gush of antifreeze fluid coming from underneath my engine. LUCKILY, I was parked at a service station. Rob N.
sounds like the water pump went possible blown head gasket
Average repair bill for speedometer for 2004 GMC Yukon?
Graff Chevrolet quotes approx. $550 parts and labor.