0
Hyundai XG350
The Hyundai XG350 is one of the versions of the midsize luxury car Grandeur XG, the third-generation model of Hyundai Grandeur. The XG350 is powered by a 3.5-L Sigma V6 engine, and features heated seats and moon roof.
175 Questions
Why did my Alarm siren on Hyundai 2005 xg350 stop working?
I would suspect that the alarm system is not arming. Typically this is caused by a missing hood switch bumper.
How do you change the low beam bulb on your 2004 Hyundai XG350?
In a lot of newer cars, you pop the hood and twist off the bulb-holder from behind the headlight. Then, you remove the old bulb, insert the new bulb, and twist the bulb-holder back into the headlight. In some cars, you have to replace the whole headlight.
Where is the oil filter located on a Hyundai XG350?
The Oil Filter is located behind a black protective plastic guard on the Passenger Side directly behind the radiator. Use the appropriate socket wrench and remove the three screws that hold the guard in place. Fully remove the plastic guard and place it somewhere safe. The filter is a Purolator 14459.
How do you change cabin filter Hyundai xg350l?
To remove existing filter: 1. Open the glove compartment, locate and remove the spring-loaded stop cord on the right hand side of the glove compartment. This is done by slightly pulling the cord into the glove compartment then feeding it back through the hole. It is spring loaded but will park in an easily reachable position. 2. Locate and remove the rubber stoppers on each side of the glove compartment and remove by pulling them out on the leading edge and slide them toward you. 3. Swing the glove compartment door down to the floor. 4. Locate and remove the 10MM bolts one each side of the lower portion of the panel behind the glove compartment. 5. Locate and remove the Phillips head screws one on each side of the upper portion of the panel behind the glove compartment. There is also one on the lower right side.
6. Locate and remove the 10MM nut located in the center portion of the panel. 7. Carefully pull out the glove compartment panel releasing the two locking clips and disconnect the two electrical connections. 8. Remove the bottom panel by carefully releasing the two locking clips and a tab that hooks onto the front lip of the blower housing. 9. Locate the filter access door and remove by pulling down and outward on the bottom lip. 10. Pull the dirty cabin filter out by the small handle located in the center of the filter. 11. Install the new filter paying close attention to the airflow directional arrows. 12. Reverse the procedure to complete assembly
Ac evaporater filter Hyundai xg 350l?
Find it in a compartment/slot behind the glove box housing. Replace about every 12,000 miles give or take depending on environment.
How do you change rear wheel bearing in Hyundai xg350?
To change the rear wheel bearing on a Hyundai XG350, start by lifting the vehicle and removing the rear wheel. Next, detach the brake caliper and rotor to access the hub assembly. Use a bearing puller to remove the old bearing from the hub, then press in the new bearing. Reassemble by reversing the steps: reattach the hub, rotor, and caliper, and finally, replace the wheel.
How do you change a lower control arm on a Hyundai xg350l?
To change the lower control arm on a Hyundai XG350L, begin by safely lifting the vehicle and removing the front wheel. Next, disconnect the control arm from the steering knuckle and the frame by removing the necessary bolts and nuts. Once the old control arm is removed, position the new control arm in place and secure it with the bolts. Finally, reattach the wheel, lower the vehicle, and ensure everything is tightened to the manufacturer's specifications.
