0
Infiniti J30
Known as the Nissan Leopard J Ferie in Japan, the Infiniti J30 was a mid-size luxury car produced between 1992 and 1997. This rear-wheel drive, 4-door sedan featured a 3.0 L VG30DE V6 engine and 4-speed automatic transmission.
213 Questions
Does the valves bend when the timing belt breaks?
On a 1998 Nissan sentra 4 cylinder when the timing belt breaks does it bend the valves
How do you fix a car door that won't open from the outside on a 1993 infinity J30?
If you can open it from the inside then just take off the door panel and plastic lining. There will be 2 linkages coming form the outside handle 1 for the lock and the other for opening the door. Sometimes the linkages can stretch. Where the link connects to the actuator there is plastic bushing with height adjustment. Turn the bushing to the height that works if not bend the link slghtly. Remember to grease everthing with wd40.
Answer: I had a similar problem. The front driver door was locked permanently. So I opened the rear driver side door. From the rear door I drilled out the bracket which the doors latchs onto. This allowed me to open the driver side door. After that I was able to take off the panel and replace the power door latch assembly.
Where is 1993 Infiniti j30 alternator located?
It's on the passenger side of the vehicle. When you look at the crankshaft pulley, the Alternator belt is the innermost (closest to the engine) belt.
Where is the air intake located on a 2000 Nissan Frontier 4X2 4-cylinder?
The initial air intake is a small hole in the driver's side front fender. From there it goes into a box that filters water then on to the air filter and down through the bottom of it into the motor. The MAF sensor is part of the intake on the motor.
Where is the location of a infinity j30 fuel temperature sensor?
is the intake air temp sensor in the mass air flow on a 19196 j30 infity
Where are the spark plugs on a 1998 Infiniti I30?
check were the headers are or they will be under the spark plug cover on the engine cover one of these spots
How do you replace the water pump on a Infiniti J30?
How do you remove/replace a water pump on a 1996 Infiniti J30? Remove radiator hoses. Remove induction tubing for the air filter. Remove the fan and all belts. Remove timing belt cover. Remove and replace thermostat at same time as pump. The water pump is BEHIND the timing belt. The timing belt will need replacing at this time to obtain access to the pump. I tried to replace mine on the side of the road in emergency situation by prying the timing belt out of the way. It worked, but I damaged the belt and the tensioner. And thusly, had to go back and replace those too. But common sense in the labor department: Replace the thermostat, water pump, fan blades and fan clutch, ALL radiator hoses, bypass hoses and clamps, radiator and belts at the same time. I have 250k on my J30, and these have all needed replacing eventually.
Is obd11 used on a 93 infinity?
Should be one. OBD2 didn't start in any models as far as I know until 94.
What Fuse is for the stereo in a Infiniti J30?
driverside left kickpanel fusebox cover will state size of fuse[amp] and device they serve for example[headlights,dome int. light,radio ,etc.
Where do I find the oil cap on an Infiniti J30?
Read your owners manual. It will show you where your oil cap is and it will tell you what kind of oil to use...among other things about normal maintenance for your vehicle.
How do you reset the air bag and sit belt lights on Infinity J30?
To reset the airbag and seat belt lights on an Infiniti J30, first, ensure that the ignition is turned off. Then, locate the airbag diagnostic connector under the driver's side dashboard and use a jumper wire to connect the two terminals. Turn the ignition key to the "On" position without starting the engine, and the lights should reset after a few seconds. Remove the jumper wire, turn the ignition off, and then start the engine to check if the lights have turned off.
Where do you plug in a code reader on a 1998 tracker?
On a 1998 Chevy Tracker, you can plug in a code reader into the OBD-II (On-Board Diagnostics) connector, which is typically located under the dashboard on the driver's side, near the steering column. You may need to remove a cover to access the connector. Once plugged in, the code reader can communicate with the vehicle's computer to retrieve diagnostic trouble codes.
Where is the fuel pump relay located on your 1994 Infiniti J30?
The fuel pump relay on a 1994 Infiniti J30 is typically located in the engine compartment fuse box. You can find the fuse box near the driver's side of the engine bay, close to the battery. The relay itself is usually labeled, so you can identify it easily by referring to the diagram on the inside of the fuse box cover. If you're having trouble locating it, consulting the owner's manual can also provide specific details.
