0
Jeep Cherokee Laredo
The Jeep Cherokee Laredo was manufactured from 1985 to 1992 as a full-size SUV. Its earlier models had a 2.5-liter engine while the four-liter engine came out after 1987. It was designed primarily for the North American market.
1,043 Questions
How do you read the ac fault codes of a jeep grand chrerokee 2000?
With a scan tool.
Using a scan tool is one way to get the HVAC system fault codes.
In the 99/04 Jeep Grand Cherokees, you can also read the fault codes from the dashboard heater control module without a scan tool.
To read the fault codes from the dashboard heater control module:
1. Turn on the ignition switch.
2. Turn on the AZC system. The temperature settings should be displayed for both sides.
3. Simultaneously hold down the AC and the Re-Circ buttons.
4. Then turn the driver's side temperature (Left) control knob to the right (CW) one click.
5. Then release the AC and Re-Circ buttons.
If there are no fault codes, the "00" display value will remain in the window.
If there are any codes, each will be displayed for one second in ascending numerical sequence (note: no effort is made to display faults in the order they occurred). The left side set temperature display will be blanked and the right side set temperature display will indicate current and historical codes (8 historical max) presently active.
Once all codes have been displayed, the system will repeat the fault code numbers. This will continue until the left side set temperature control is moved at least one detent position in either direction, by pressing both the A/C and Recirc buttons at the same time, or the ignition is turned off.
Where is the fuse box on 1991 jeep Cherokee Laredo?
There is one on the inside of the hood to the left of the engine, and one under the console of the drivers side to the left of the brake peddle, hope you get your fuses fixed!
Why does your 2001 Jeep Cherokee fishtail?
Try This : Install a bigger, firmer aftermarket anti-roll bar. I have not yet done it to mine (2000) - but I hear of good results.
How many quarts of transmission fluid should go into a 93 Plymouth sundance?
CAPACITIES
Automatic Transmission, Initial Fill..........4.0 quarts[1]
Automatic Transmission, Total Fill
A404..........8.4 quarts
EX A404..........8.9 quarts
Manual Transmission, 4-SPD..........3.8 pints
Manual Transmission, 5-SPD..........4.4 pints
1. With engine at operating temperature, shift through all gears.
CK level in PARK and add fluid as needed. Hope This Helps.
How do you reset the Check Engine light in a 2002 Jeep Grand Cherokee?
you have to hook up a scaner and press code reset or a auto zone store will do it for you
Where is the crank sensor located in a 1991 Jeep Laredo?
The Crankshaft Position Sensor (CKP) is secured by special shouldered bolts to the flywheel/drive plate housing. It is preset in its mounting at the factory and is non-adjustable in the field. The sensor senses TDC and engine speed by detecting the flywheel teeth as they pass during engine operation.
How do you replace the shift console light for 1999 Jeep Grand Cherokee Laredo?
You can't. There's a circuit board connected to the shifter with LEDs on it. You have to replace the whole shifter. P/N # 52104149AC
How do you replace the dash speakers on a 2007 Jeep Cherokee Laredo?
The speakers were all recalled due to a vibration in them. Take it to the Jeep dealership and they will replace all the speakers in the car at no charge.
How do you change the stop light fuse on a 2002 Jeep Laredo?
Press brake pedal down to the fully applied position. Rotate switch about 30 degrees in a counterclockwise rotation then pull rearward and out of bracket. To install pull plunger out fully. Press brake pedal down fully. Insert switch into mounting bracket and align the locator tab on switch with the notch on the bracket. Rotate the switch clockwise about 30 degrees. Release the break pedal then pull forward to adjust switch. You will hear a clicking sound while it is adjusted.
1995 Jeep Cherokee oil capacity?
4 cylinder holds 5 quarts. 6 cylinder holds 6 quarts. V8 holds 5 quarts.
sounds like you blew a (some) fusible link in the light circuit. Check the harnesses to see if the wires are chaffed or shorted. Bottom line is you let the smoke out and its bad (just kidding). Hopefully you will find something in that order, good luck.....................Mike I concur. I would say with 90% certainty that if you look at your fusable links you will find one that has burned out. In my own experience (with a '90 Cherokee Laredo) I discovered one night that I had no lights whatsoever except turn signals and dome light. After thoroughly checking the fuses, I "accidentally" discovered that a fusable link (under the hood on the passenger's side, about a foot from the battery) had completely fried--the insulation had even melted totally off the wiring. Unfortunately, if yours is the same one as mine, you'll be looking at junk yards to try to replace it--I had no luck finding a new one (and I sure wasn't going to the dealership!) Best of luck. MOAIS \\
Is the power window regulator the same for a 1998 Jeep Cherokee and a 1998 Cherokee Laredo?
The only differences are between a regular Cherokee and a Grand Cherokee.
Where is spare tire stored on Jeep Cherokee Laredo?
Depends on what year. Some are mounted on the rear door. Some are mounted inside the rear of the Jeep. Some are under a cover in the floor of the rear. Some are mounted under the rear of the Jeep.
How do you disarm the alarm system on a 1998 Jeep Cherokee Laredo SE?
Remove the fuse under the hood its in a fuse box on the passenger side under the hood
Water on the floor that is not coming from the heater core is coming either from rain water leaking around a windshield seal or one of the firewall seals where hoses, wires or other components enter from the engine compartment.
A; If this happened after a over "Rev" situation ( where the engine RPM went too high ). Replace the bend push rods, if the engine still missfire do a cyl blowby check, If there is leaking valves remove the cyl head and check for bent valves, If it was not reved too high, remove the cyl head and do the clearance of the valve guides. On some engines they tend to slowly build up carbon and cause the valve to stick specially in the decellerating mode. After the engine cool down the valves will seem to be loose again. Clean the lifters and put them back after the head has being done. Frik
When should the timing chain on a jeep 2.5L engine be replaced?
It's debatable when the a chain and gears need to be replaced on these I4 and I6's. There are several thing to consider. If you have a 4 or 6 cylinder (the 6 tends to be stronger longer), if you off road in it (at all) and also how many "hard" miles you have on it. If you have 250,000 miles on it, but only drive it to the store and back at 35 mph, that set will probably last forever. If you have over-sized tires and have been off-roading for the same 250,000 Miles, you probably should have changed them 150,000 miles ago... But to answer your question, changing them at 150,000 miles seems to be pretty routine. My 2.5L has 170,000 on it and it needs one bad, and plan to change my timing set next week.
ALSO!!! Get an Pan gasket too, because you have to remove the pan to get to the chain tensioner bolts.
Gear set, gasket sets and oil your looking at about $200 in parts; and for amateurs like me, a nice uninterrupted 18hours to do it; correctly.
BTW: Look on Ebay for the Gear set, the Zone had the best deals on gasket sets, Advanced have the best oil w/ Filter deals, and the best part... they all take Paypal! Hope this helps.
What is the Difference between 5w-30 oil and 10w- 30 oil?
The main difference is cold flow ability. The 5w30 will flow better when cover over the 10w30. Once operating temperature is achieved, they are virtually the same.
How do you fix a leak from the AC on a 2000 Buick LeSabre?
Un plug the drain which is on the firewall behind the right front tire.
What would cause the odometer light to stay on after you shut off the car on a 97 dodge stratus?
The odometer light will stay on if the headlights are on a 1997 Dodge Status. Be sure to click the lights off even after shutting the vehicle off.
How do you get a 1990 Jeep Cherokee out 4 wheel drive?
There is a lever just to the right of the driver's seat left of the e-brake/shifter. You have to move the lever to the right and up to get it out of 4 wheel drive.
Where is the fuel filter on a 1994 Jeep Grand Cherokee Laredo located?
The fuel pump is located in a unit inside the fuel tank. It is called a "fuel module" which contains the pump, sending unit, float etc allin one unit. The fuel has to be removed, the fuel tank dropped, and the entire module has to be replaced. I had mine replaced on a 1993 Jeep Grand Cherokee Laredo 4.0 and it cost aboput $800.
