Mitsubishi Endeavor

How do you disable the DRLs on a 2005 Mitsubishi Endeavor?

3 just on top of the engine,u can see black cap with screw and wire,other 3 under the intake.

If there is one installed it should be behind the glove box. It is sitting on top of the blower inside the blower box

The O2 sensor bank 1 location on a Mitsubishi Endeavor is next to the top hose of the radiator on the motor. The sensor is slightly below where the top radiator hose connects to the radiator and on the top of the motor.

Take 2 screws out and pull light straight back, it will come over, replace bulbs and put back on and replace screws

What is the average transmission repair cost for Mitsubishi Diamante?

I have a 2004 endeavor, it might be the same set up. You can try it, Pop open the hood. Their is a gray cap that holds the light in place on each side, located right behind the headlight. You need to turn it to get the cap off. Then the light is clipped in it so you need to press in the tabs to release the light. Snap in the other light and put the cap on but the cap is spring loaded so it is tricky to get on. I found that by using just a little pressure it will go on easier then pushing it full force on to the other piece, it will take a couple trys. Be careful not to touch the glass on the bulb, Good luck, hope it helped!

With proper maintenance probably around 150,000 Miles

Fazelli Mitsubishi in Plano quoted me $335.00 for timing belt replacement on a 2004 Endeavor. Some say it is also good to replace the water pump at the same time. I don't know if that price includes water pump replacement. Probably not.

right (passenger) side - behind the cat conv.

right side of engine, follow the bottom hose from the radiator to the thermostat housing. There are three bolts in a triangle pattern. It is not easy to get to, you might have to remove the front cover of the air filter plus the hose from it to the carburetor. Also you will see a black plastic piece coming from the top of the motor to the housing, unbolt this it is attached to the thermostat housing. Also when buying a new thermostat be sure you get the rubber o-ring for it , it does not use a traditional gasket. You will see when you remove the old one. Good luck.

Just about in the dead center of the firewall. It has one small tube and one slightly bigger tube connected to it. You will also see and Allen bolt in the middle of it.

all five tires have a sensor in the stem check pressure in ALL five tires including the full size spare located in the back of the truck, if that doesn't work then a sensor could be bad and needs replacment

Loosen the four bolts that hold the ignition coils to the valve cover gaset. Then pull each coil out and the spark plug wire attached to it. Pull each wire off each coil and replace with new. Reinstall coils and wires. Reinstall ignition coil bolts.

The power steering pump is located(looking at engine from front of car) on the bottom of the engine on the left side.

To change a door handle on a 2004 Mitsubishi Endeavor, remove the 2 screws of the face plate. Then remove the 2 screws on the knob plate. Remove the door handle and replace with new.

Hello,

Do you want to replace entire rear bumper or bumper cover? Are you doing it yourself or having shop do it? You can buy a new bumper cover (primed, so you'd have it painted too) for about $200. You can surely pick one up by hunting junkyards or sites like upullourparts.com

Mike

They recommend 5W 20. You can use 5W 30 if you live in a warm climate. I wouldn't use 10W30 unless you live in a climate where it never go below 32F

basically an oil your happy with. Royal purple is excellent for racing.Available at PEP BOYS. Just remember all oils life is 3,000 on the highway and 500 on the race track. I would probably use a combination of slick 50 and my favorite oil. not sure that all racing sanctions will allow oil additives or not ,better check rule book at the event you are pertisipating in.

I recently paid

My 2005 is a five seater, and I don't believe they have ever changed that 2004 thru 2009.

My 2004 Endeavor does not. However, I like the idea, and the lights turn off when the ignition switch is in the lock position, so I leave the headlights on all the time.

fill tires to proper air pressure. light will not go out until you drive it a short distance.

The bulb or the entire housing? The bulb you have to go in the engine compartment. Find where the rear of the bulbs are and you twist or unscrew off the top that holds down the bulb. It's just like taking the top off a 2 liter soda. Then you either pull the bulb out or twist and pull out.