Motorcycle Safety

used to be Santee Industries and I believe they were somewhere in Ca, but I can't find the company anymore

1 down and 5 up is traditional, however if its equipped with a GP shifter, it will be 1 up and 5 down

July.

The information is on the tire sidewall.

65.8368 kph ==

Not enough!!

5,958 a month

The Yamaha Raptor 700 typically requires about 1.5 quarts (1.4 liters) of gear oil for the transmission. It's essential to check the owner's manual for the specific model year, as recommendations may vary slightly. Always use the recommended type of oil, such as Yamalube or an equivalent high-quality gear oil, for optimal performance.

You must if you are a Temporary Permit Holder, or first-year endorsed operator

or a passenger, and during the test. Please check the details in the motorcycle manual (related link).

316, 800 ft/hr

115 MPH

You can wear a helmet at pretty much any age.

Depending on location and local laws, sometimes you don't have to wear a helmet once past a certain age.

2 mph

76 hp

Assuming the rate of 60 mph is constant, traveling 60 mph means you are traveling one mile per minute. Since 45 seconds is 3/4 of a minute, you have traveled 3/4 of a mile, or

3,960 feet

The cone penetration value gives information on the consistency of the grease. If the cone sinks deeper into the grease, the grease has a lower consistency and will flow more easily. The consistency of greases is divided into different classes by the NLGI. Customers use these classes as an indication of how fluent a grease is at 25 degrees Celsius. The cone penetration test is also used as a way to quickly confirm if the delivered grease is on specifications.

In the early days of grease testing the cone penetration test was thought to say something about the viscosity of the grease. However, since those days it was proven that greases do not have one viscosity but that this viscosity is a very complex variable among others dependent on the greases previous history, on temperature and on time. This is why for theoretical research the cone penetration test does not have a lot of value.

The inscribed angle is important in your life because it is used in architecture and construction. It gives the placement or location of adjoining walls. It is also important in astronomy.

Shifting gears on a street bike depends on two things: your desired speed/mode of travel, and the engine revolutions, in RPM, of your machine. There is a point where the RPM meter shows such a low rev, that shifting gears at this point will stall the engine, stopping the motor. Shifting to first gear, which is the largest and most powerful gear in your engine, should be the easiest, starting off at about 1,500 to 2,500 RPM, while slowly releasing your clutch.

Here's where the desired speed/mode of travel comes in: are you revving up for a fast ride, or are you just cruising slowly, taking in the sights? If you're on a race-track, or on a clear, safe, familiar highway, revving to a fast ride will mean accelerating to 8,500 RPM or more, before releasing the accelerator slightly, depressing your clutch lever, shifting to 2nd gear, and releasing clutch while revving up to 8,500 RPM or so, again to shift to 3rd.

If you are cruising slowly, changing gears at 2,500 to 3,000 RPM should give you a steady, comfortable cruising shift without stalling your engine. Remember: the higher the gear you are shifting to, the higher your engine revolutions should be.

about 76hp

It depends upon the weight of the car, the coefficient of friction for the brake linings, and the type of tire and contact with the road surface. A formula one car can stop in these conditions very quickly. See this link for further explanation: http://www.csgnetwork.com/stopdistinfo.html A calculator can be found here: http://www.oregon.gov/OSP/PATROL/stop_brake_distance_chart.shtml Using the calculations from this website's downloadable EXCEL sheet shows that a vehicle traveling 197 mph and weighing 4000 pounds would take 1764 feet to stop with a drivers reaction time of .5 seconds considering the coefficient friction value of .8 which would be considered an ABS brake system with excellent tires.

http://www.drivegreen.com/Motorcycle_Tire_Pressure/HARLEY-DAVIDSON.shtml

FXSTC is a Softail Custom with tire pressure 30 psi front tire and 40 psi rear tire. Heritage Softail is FLSTC WITH 36 psi front tire and 40 psi rear tire. Hope this is helpful.

teenage a stage where child comes to know about the things going on in the world.

a a child usually hates about being a teenager as parents usually tell him/her not to do this or that or not to sit here and there