Toyota Matrix

No, the Infinity 3.0L engine has a timing chain.

It does not have one. It has a chain. its located at the front of the engine , behind the fan blade pullys and water pump and a front cover . i would get a book somtimes they are helpful .

The EPA range estimate for the 2012 Toyota Matrix is 343.2 mi. in the city, 422.4 mi. on the highway.

The 2003 Toyota Matrix's turning circle is 35.5 ft..

Yes. The six-cylinder engine uses a belt to run the camshafts. Replacement is recommended at 90,000 miles or ten years whichever comes first.

you need a serpentine belt remover. Its $20 at autozone...The pulley on the bottom left will pull up if you use the tool..its the small pulley on the bottom left...very easy with the right tool....takes three hours without it:] and a lot of cussing...

5x100

NO, it depends on the version / trim of Matrix or Pontiac Vibe. Some changed to 5x114 in 2009, such as the XRS, GT, and AWD version....go to Tirerack.com, put in your Make/Year/Model/Version, click Wheels and it'll show you the bolt pattern.

The ground clearance of the 2011 Toyota Matrix is 0 ft. 5.8 in. (5.8 in.).

The 2008 Toyota Matrix has a drag coefficient of .32 Cd.

Check if there is a trunk release lever on the left side of the drivers seat by the gas door release lever.

you have a belt tensioner you need to put a big socket wrench on it and push down on it and it will lift it up to release the tension on the belt. do the same thing to put it back on

timing CHAIN

170249 is Naeem Khan's roll no. and has falied

buy the manual, follow the steps. First check the compression to assure no valves are bent, tight valve clearance is a major issue.

13 or 14 inch rims. Check on the tire for size.

You can lease a Toyota Matrix at any Toyota dealer in your area. Because I don't know your location I can not tell you exactly where to go, but your local yellow pages should have a list of the Toyota dealers near you.

I just got a complete overhaul on my brakes and a week later they started squeaking so I called the shop and he said the brake pads need to be sanded with an abrasive disk or flexible honing brush.

Stay away from the additives they are not needed. Run the oil in your Matrix until Toyota says you should change it. After that Switch to a Good Synthetic. As to the fuel cleaning additives I put 2 oz's of [http://www.amsoil.com/storefront/api.aspx?zo=1163284 Amsoil's P.I. Performance Improver Gasoline Additive] in every tank to keep my injectors clean. Good Luck and Remember.
Change Your Mind, Not Your Oil.
Use the First In Synthetic Motor Oil's.
See My Bio For more information.

Follow the big hoses, its in a black box near the engine, with 4 clips holding it down, two in front, and two hinged clips in the back. Its best (and easiest) to disconnect the air hoses before opening the air filter box.

when you buy a replacement belt buy a kit that also contains idler pulleys. its best to change them all at once. it should have drawings to show you proper routing and installation instructions.

There are a few things that can cause no pressure within a gas tank. One thing that could be causing it would be the seals are worn on and around the gas tank, pump and filter.

If you go to autozone and get the duralast with the lifetime warranty its about $20

look for a black cable, looks like the plug end of an extension cord, should be near a headlight or in the front bumper some were , if you don't see it , the car doesn't have one

The 2013 Toyota Matrix has an inline 4 engine.

The 2010 Toyota Matrix runs on regular unleaded.