Vauxhall

This answer applies to a 2005 Vectra with 3.2Lt V6 engine. The oil filter is on the front of the engine near the exhaust manifold and close to the radiator. It is a fixed canister type with a removeable lid which has a hex shaped head in the middle of it. Use a 15/16" socket to unscrew the lid. It unscrews anti clockwise (ie, it has a normal thread). Use a large flat container or plenty of paper on the ground under the car to catch the oil which will spill out of the oil filter. Once it is unscrewed, withdraw the filter lid complete with attached filter cartridge. Replace the filter cartridge making sure it snaps into place on the lid. Replace the rubber O-ring making sure it goes back onto the correct ring on the lid. Carefully position the lid and attached filter cartridge back into the cannister body - its more easily done by entering from under the car. Screw the lid back onto the cannister and tighten. Change the engine oil at the same time. To do this you'll need 5Lt of good quality 10W-50 engine oil and a torx-tip socket to open the sump plug. Safety notes:

- Never work under a car which is on a car jack or on unstable ground.

- Make sure the handbrake is on and at least one wheel is chocked.

- Beware of touching the exhaust pipe when it is hot - it can cause a nasty burn.

- Beware of hot oil which can also cause a nasty burn.

- If your skin is sensitive to engine oil, wear rubber gloves.

Yes.

Will it be safe or legal? Probably not.

If fitting vaxhall fogs, the wiring is already there, but you will need to do a Tec 2 program to get the lights to work.

Probably.

It may need adjusting.

The rear brakes may be excessively worn, and need replacing.

The rear brakes may be incorrectly assembled following (in-expert) servicing or repair.

A component in the rear brakes may have malfunctioned.

The most likely reason is that one of the hand-brake cables is broken.

As you may know the key can normally be re-programmed to the central locking by turning on the ignition and pressing either of the buttons. If this fails there are two common faults 1/ the battery holder inside the key has come off of the printed circuit board (if you pack the key with tissuse paper to hold the battery tight this gets over that problem. 2/ the key has lost its connection to the computer and will need to go to a vauxhall dealer to have it programmed, they use a machine called tech 2 and to programme that or any key they will need the immobilizer (security) code number. this was originally supplied with the car at time of purchase. If you have lost it a Vauxhall Dealer can get a new code but this is not cheap.

With 18" alloys its 33psi in the front and 30psi in the rear. Cheers.

Hi,if you trawl through the other posts you will find many questions similar to yours.The engine icon is for "engine electronics",it means there is a fault or fault with a sensor,that is monitoring your systems.I maintain that the cheapest cure is to run the vehicle to a garage,not necessarily vauxhall,as long as they have the diagnostic kit.Phone up and ask.I use a local private garage. Most times it is a sensor problem rather than a component.For instance,my daughter's corsa started throwing in large amounts of petrol,making black smoke and choking to a stop at junctions.I guessed it was the coolant sensor but still had it confirmed on the computer.The sensor was telling the ECU that the engine was cold so it put in the extra fuel.

i just did it today on my 98 vectra gsi.... it was noisy, sluggish and drinking fuel like there was no tomorrow.... changed the coil pack, ignition leads and engine coolant temperature sensor (ECT). now it runs a dream!

The near side front indicator bulb for a Vauxhall Corsa is typically a PY21W bulb. However, it's always best to check your vehicle's manual or consult with an auto parts retailer to confirm the exact bulb type, as specifications may vary by model year.

To turn on the headlights in a Vauxhall Corsa 1.0, locate the headlight control switch on the dashboard, usually found to the left of the steering wheel. Turn the switch to the right to activate the dipped headlights or to the left for full beam. Some models may have an automatic setting that will turn on the headlights based on ambient light conditions. Always ensure the ignition is on for the headlights to function.

For a Vauxhall Combo Crew Van 1.7D, the cambelt change is generally recommended every 60,000 to 80,000 miles, or every 5 to 7 years, depending on driving conditions and maintenance history. It's essential to consult the owner's manual or a qualified mechanic for specific guidance tailored to your vehicle's needs. Regular inspections can help ensure that the cambelt is in good condition and prevent potential engine damage.

The timing belt on a Vauxhall Corsa 1.2 should typically be replaced every 60,000 to 100,000 miles, or approximately every 5 to 7 years, depending on driving conditions and manufacturer recommendations. It's essential to consult the owner's manual for the specific interval for your model year. Additionally, if you notice any signs of wear, such as cracking or fraying, it's advisable to replace it sooner to prevent engine damage. Regular maintenance checks can help determine the appropriate timing for replacement.

To reset a Vectra warning light, first ensure the underlying issue is resolved. Then, turn the ignition to the "On" position without starting the engine. Press the accelerator pedal three times within five seconds, then turn the ignition off. Restart the engine to check if the warning light has cleared. If the light remains, further diagnostics may be needed.

You can tell your car engine has blown if you notice severe symptoms such as a loud knocking or banging noise, a significant loss of power, or excessive smoke coming from the exhaust. Additionally, warning lights on the dashboard, especially the oil pressure or check engine light, may indicate serious issues. If you experience engine overheating or find coolant or oil leaking, these can also be signs of a blown engine. In any case, it's best to have a professional mechanic inspect the vehicle for a definitive diagnosis.

To change the gear linkage cables on a Vauxhall Movano, first, ensure the vehicle is securely lifted and supported. Disconnect the battery, then remove any necessary panels to access the gear linkage assembly. Unclip or unscrew the old cables from the gear lever and the transmission, and replace them with the new cables, ensuring they are securely attached. Finally, reassemble any removed parts, reconnect the battery, and test the gear shifting to ensure proper installation.

The pollen filter on a Vauxhall Corsa CDTi is typically located behind the glove compartment. To access it, you may need to remove the glove compartment by unscrewing it or releasing any retaining clips. Once removed, you should see the filter housing, which can be opened to replace the pollen filter. Be sure to consult your vehicle's manual for specific instructions related to your model year.