0
Volvo 240
Introduced in 1974 along with the 260 series, the Volvo 240 was a mid-size executive car manufactured by Volvo. This model was manufactured in six variations, namely 242DL, 242L, 244GL, 244DL, 245DL and 245L.
653 Questions
How do you replace refrigerant in a 1989 Volvo 240?
89 Volvo is R12(Freon).You need to go to a qualified tech to have it checked.A good idea is to have it converted to R134(have to have old R12 vacummed out first,and change charging valve)then you can refill yourself.but be aware,that the valve is behind the compressor,and not easy to get to.
What is 1989 Volvo spark plug gap?
Most of the Volvo 240's FM 1983 -1991 use .028.....but just call any auto parts store and they will be glad to help.........
Where to find parts to 1989 Volvo 240 dl wagon?
Europartsdirect.com is also a great source for '89 240. Sometimes cheaper than IPDUSA.
How many amps does a 1989 240 dl Volvo have?
The 1989 Volvo 240 DL typically has a generator output of around 70 to 90 amps, depending on the specific model and any optional equipment. The alternator's amperage rating can vary slightly based on factors such as the vehicle's electrical system and any modifications made. Always refer to the vehicle's manual or specifications for the most accurate information.
How do you remove 1993 Volvo 240 center console?
1993 Volvo 240 WAGON 5spd manual transmission.
there are two screws on iether side of the console. then its just a matter of disconnecting wires.
How can you test a 1986 Volvo 240 dl fuel pump relay?
To test a 1986 Volvo 240 DL fuel pump relay, first locate the relay in the fuse box. Use a multimeter to check for continuity by applying power to the relay terminals while listening for a click, indicating it's functioning. Additionally, you can bypass the relay by connecting the fuel pump directly to the battery to see if the pump operates. If the pump runs with the bypass but not with the relay, the relay is likely faulty.
Where is the fuel pump relay located on a 1990 Volvo 240 DL Sedan?
The fuel pump relay on a 240 is in front of the passenger's knees, against the firewall, just above the thick fabric footwell cover. It's white, part number 3523608. They used the same relay from 1985 until the end of the run in 1993. It's the same relay as the 740 & 940 most years also. It has a date stamped on it & it should be replaced if the date is more than approximately 10 years ago even if it's still working. It just pulls out of the connector & the new one pushes in.
Is there a fuel injection computer in a 1990 Volvo 240 dl?
yes, it is located on the sidewall under the glove compartment. Remove the three tabs holding the cloth covering just over where the passenger's knees would be and the hard plastic one to the right of it. A silver box labeled Jetronic should be mounted to the sidewall.
What is the firing order for a 1979 Volvo 242gt?
1 - 3 - 4 - 2
The distributor rotor turns CLOCKWISE
The marked # 1 position on the distributor cap faces to the FRONT
The engine cylinder locations are numbered 1 to 4 , from front to rear
Where are the relays for the heated seats on a 1990 Volvo 240 wagon?
Right under the driver dash,
Buy a Haynes manual and it'll give you the full diagram
Where would the voltage regulator be located on a 1987 Volvo 240 GL?
The VR is on the back of the alternator.
How do you change power steering belt on Volvo 240?
To change the power steering belt on a Volvo 240, first, disconnect the negative battery terminal for safety. Loosen the tensioner bolt and the mounting bolts for the power steering pump to allow for adjustment. Remove the old belt and install the new one, ensuring it's properly seated on the pulleys. Finally, tension the new belt by repositioning the pump, tightening the bolts, and reconnecting the battery.
Where is the thumb screw for setting the idle in 1983 Volvo 240 DL?
on the intake manifold, right next to where the intake hose attaches, in front of the TPS
How change the coolant sensor on a Volvo 240 dl?
it's on the radiator, just pull the wires and unscrew it.
How to replace a 1988 Volvo 240 dl starter?
it's just got 2 bolts holding it on, going through the bell housing and label the wiring .
Why Volvo 240 1993 indicator lights stay on when ignition is off?
If the indicator lights on a 1993 Volvo 240 remain on when the ignition is off, it may be due to a faulty ignition switch or a short circuit in the wiring. Another possibility is a malfunctioning relay or a stuck switch that fails to turn off the lights. It's advisable to check the vehicle's electrical system for any issues or shorts that could cause this problem. If the issue persists, consulting a professional mechanic would be beneficial.
Why won't the headlights on my 1984 Volvo 240 turn on?
I dont know, wish i did, i have the same problem goin on
nice to find out tho
1981 240 volvo #5 fuse blow when i try to start the car....
What is the torque and sequence for tightening the cam bearing cap bolts for a Volvo 240?
For a Volvo 240, the torque specification for the cam bearing cap bolts is typically around 15-22 ft-lbs (20-30 Nm). The recommended tightening sequence usually starts from the center and moves outward to ensure even pressure distribution. It's essential to follow the specific pattern outlined in the service manual for your model to avoid warping the cap. Always double-check the specifications for your engine variant, as they can vary.
