0
Audi
Questions about the German car manufacturer Audi and their different models.
1,519 Questions
Is an Audi 1.8 engine the same as a Audi 1.8 turbo engine?
The 1.8 turbo is more powerfull. The turbo charger pushes more air and fuel into the engine.
How do you unlatch Audi floor mats i want to replace the carpet mats with rubber for the winter.?
The clamps are just like giant snap buttons, you just have to give a quick pull on them. They can be tuff some times!
What do electric thermostats do in an Audi 18t 2001?
No such thing. The Audi's thermostat has a wax impeller.
What is the maximum speed of Audi rs4?
A gentle electronic limiter draws a close on this headlong rush at 155mph. The gearing and power suggests that without this limiter, 180mph would be fairly easily achievable. ....it's about new model Shame i got up to 210 at the Neuberg in Germany ;)
Where is the thermostat on an Audi?
answer
the thermostat is located between the radiators and the engine in an Audi.
Where is the thermostat on a 93 Audi 100 cs?
The thermostat housing is located on the passengers side of the engine block, behind the timing belt.
How much will auto insurance cost for a 16-year-old boy?
About $200.00 a month is the average.
With that being said, my son who is only 16 found coverage for less than $100 from 4autoinsurancequote.com, and some of his friends pay even less. You simply need to shop around until you find the best rates.
That noise you're hearing is most likely the wheel bearing. The noise stops because the bearing isn't in motion. As soon as you put the wheel in motion the noise returns due to the bearing being bad. It's a common problem across the board on most Audi's!
How do you replace the thermostat located on a 1992 Audi 100?
I Paid $45 cdn dollars for the thermostat And paid $120 cnd Dollars for the installation. I was with my mecanic when he did the job and it looked pretty easy 45 min for $120cnd not bad ...
you can actually manage to pop the thermostat's cover behind the timing belt and get to the thermostat, but it does take some pulling and pushing agains the timing belt so.. the down side is that if you push the timing belt of its pulley you better konw what you're doing at that point. I guess what I'm trying to say is that you should not pay too much to have work done in this kind of car because if you get a good mechanic you really shouldn't pay more than what I paid.
45min= $120 not bad if you ask me. Just remember that it can be done. Get your hands dirty a litle.
How do you bleed a hydraulic clutch on an Audi 5000S?
The best way to bleed the system is to make sure the pedal is up off the floor, and the resevior is full, remove the slave from the trans, open the bleeder screw push the rod into the slave, close the screw, let the rod move back out slowley,,, repeat this until the rod is feels solid. Now open the bleeder screw and slide the slave into the trans all the way, then close bleeder screw and install the pin. top of fluid....
What is Frank Martin's company car in Transporter 3?
The car he drives in Transporter 3 (2008) is an Audi A8 L 6.0 W12.
How do enter code on radio if it's in lock mode?
The radio code should be on a credit card which is in the car's documentation
If you don't have the code then contact your local Jaguar dealer, they should be able to look up the code on their computer using the VIN
Once you have the number......
Turn the key in the ignition until the warning lights shoe
Switch on the radio by turning the on/of knob clockwise
The radio should be blank
Enter the 4 digit code using the preset buttons.
If an incorrect code has been entered......
Hold the CATS button for at least 3 seconds, the number should disappear
Enter the correct number
You only have 3 goes to get it right - if you've entered 3 incorrect numbers you'll need to contact your Jaguar dealer to find out how to release the radio,. This may involve:
- disconnecting the battery
- reconnecting the battery
- running the car for at least an hour
- repeating the steps above
How do you find out the last registered owner of a car?
DMV also for repairs, everyone should have a manual for their vehicle, and the library should have a professional shop manual available in the reference section for FREE to make copies of...read up and fix like a pro!! :) Dave
What Audi was in the film et in 1982?
1980-1982 USA spec Audi 5000 (4 square headlamps, updated bumpers, amber rear indicator lenses)
http://imcdb.org/movie_83866-ET-the-Extra-Terrestrial.html?PHPSESSID=ddd038b78870c4e8ec41a7c612d83dca
From: Internet Movie Cars Database http://imcdb.org
How do you remove and install a distributor for a 1988 Audi 90?
To remove and replace the distributor on the 1988 Audi 90 proceed as follows:1: First remove the cap.2: Take a picture or make a note of the position of the rotor.3: Next before loosening or removing the hold-down bolt, mark the position of the distributor base by scratching or scribing a line from the distributor flange to the engine block. (this will be useful as the approximate location to install the new one).4: Remove the hold-down bolt or nut which ever is used.5: Tap sideway lightly on the distributor housing to break it loose from it bore. Then remove it from the block using care in regards to the oil that may be dripping from the gear at the bottom end.
Installing the new distributor.
1: Place the distributor into the bore while holding the rotor in the position of the old one. (you made a note this of earlier).
2: Be sure to install it so the flange at the bottom of the ditributor housing bottoms on the engine block surface.
3: Install the hold-down clamp and loosly tighten it to hold the distributor from spinning.
4: Install the cap. and you ready to perform the ignition timing adjustment.
I hope this info was helpful.
Where is the Bose amplifier in 2005 Audi allroad?
On my '04 Allroad, it's in the trunk on the right side. There's a panel that gets removed (easily) and it's under there...hope this helps.
Audi A4-1.8T quatro Problem code P0303Any suggestions whats wrong?
P0303 Cylinder 3 missfire detected.
How do you replace the fog light bulb on an 2001 Audi?
take off the cover or look under ur bumper where ur foglights are located abd unclip it
I found this tutorial helpful (has lots of photos). It's for a 2002 but the procedure is likely the same: http://www.jmaguire.com/blog/2008/09/15/
How do you replace the rear brake caliper on 1999 Audi a6?
dissconnect the handbrake cable, remove the flexi brake pipe, remove the 2, 13mm bolts from the sliders and take off the caliper. when fitting the new one you must wind back the piston back as far as it will go.put in your brke pads fit your caliper tighten up your 2 13mm bolts fit pipe and hbrake cable and bleed the system,
How can you reset the service warning on Audi a3 2004?
A combination of pulling and pushing the 2 speedo buttons at the same time
How do you change oil on Audi A3 2005?
--->To change your oil, put the front end of your car up on ramps so you can get underneath your car. Before you get underneath though, unscrew the oil cap on the top of your engine (this will allow the oil to drain much faster once you unscrew the oil pan nut underneath the car).
--->Climb under your car and remove the skid plate, it's easy to do (the skid plate blocks your access to the oil pan and oil filter, hence necessity of removing the skid plate) -- There are about 8 Allen screws holding it in.
--->Once you have the skid plate removed and out of the way, locate the oil pan, it should be aluminum and halfway between your front two tires... There is a (i believe) 19mm nut, maybe 3/4"...but that is what you unscrew to allow your nasty oil out...careful, there is a washer on that bolt that can fall into your oil drain pan when the nut comes out and oil gushes. The washer is brass and a magnet won't find it in your spent oil pan.
--->The oil filter is located halfway between your wheels, but towards the front of the car JUST behind the radiator fans. Once you find it, on the bottom of the filter housing is a cap that unscrews, unscrew it with your hands. You will see a small nipple that has a hole in the center. Put your Allen wrench in there, push IN and to the RIGHT. This will bleed the oil filter of remaining oil with less mess than just unscrewing the oil filter housing. DO THIS GENTLY BUT WITH ENOUGH FORCE TO ALLOW THE BLEEDER TO OPEN! If you break this part it is about 100 dollars and lots of time and trouble.
--->Put your new filter in (There's an o-ring that comes with your new filter--make sure old o-ring is out, and use the new one with your new oil filter). Reset the filter housing bleeder nipple to its normal position CAREFULLY! Put your new filter on, screw on the filter housing, screw on the bleeder cap.
--->Make sure you have the correct oil for your car, and fill it up with new oil. Make sure you do NOT overfill! You can destroy your engine by overfilling.
--->I usually put a half quart less than the recommended level, then check the level on the dipstick... JUST err on the side of not overfilling. Check the dipstick, if it's low, add the remaining half quart and you should be good.
--->Reattach your skid plate under your car.
--->Put your oil pan nut back in (might use some anti-seize on the bolt to avoid future problems removing it again), give it a good tightening.
Change rear brake pads on Audi a6 2005?
a special scanner called a v.a.g. has to be used to retract the electronic e brake system, and will also retract caliper piston..DO NOT TRY WITH OUT TOOL !!!!!
