answersLogoWhite

0

Chevy Camaro

This category covers general questions about the Chevrolet Camaro, a pony car manufactured by General Motors and sold through its Chevrolet division. The Camaro was designed to compete with the Ford Mustang. Production of the model began in 1966.

4,208 Questions

How do you troubleshoot and repair the powered rear hatch pulldown assembly on a 1988 Camaro?

First you need to check for power (12 vdc) at the contact connector with a volt meter. If you don't have power, you need to trace back till you find where the 12vdc stops and fix the supply problem. If you do have 12 volts, make sure the contacts are in good shape and making proper contact when the hatch closes. If it still does not work, some camaro parts sites have GM replacement parts to rebuild the electric motor. Hope some of this info helps.

The replacement motor parts are available at www.hawksthirdgenpart.com

What tire and rim sizes can be put on a 1988 Oldsmobile Ciera?

14 inch rims are the spec size. You can use P185/75/R14 , P185/70/R14 , P185/70/R14 , or P185/75/R14 all will work with no problems. I have an 88 olds cutlass Ciera and have used these with both winter and all season.

How many 1997 Z28 were made with LT-1?

All 1997 z28 and ss were made with the lt-1 engine. They swapped to the ls-1 in 1998.

Correct! However there were about 100 that were fitted with an LT4 motor which was a suped up version of a LT1

What is the problem if you have water in the oil?

Water in oil is a strong sign of a blown head gasket. If you notice any white smoke coming from your tail pipe or, if you take off the radiator cap, after the car has been running it will "gurgle"-another sign of a blown gasket.

Is it necessary to loosen the engine mounts when changing an oil pan gasket on a 1996 Nissan 200SX 1.6L engine?

You will have to remove the mounting bracket that holds the engine up. It is more than a motor mount, it is the brace under the car that the engine rests on. For about 80 bucks, you can buy a frame that sits where you hood normally does to hold the engine up when you remove this brace.

Where is the turn signal flasher located on a 1999 sienna?

The flasher on a 99 Toyota Sienna should be beside the instrument panel fuses under the steering column. You will probably have to remove the driver's side knee bolster to get at it, which is kind of a pain.

How do you replace the ignition control module on a 1983 Z28 camaro with Cross Fire Injection?

you remove the distributor cap and the module should be underneath make sure you get the right one there are 5 prong and 7 prong modules also make sure you put the heat dispursing grease on very thick this will keep it from over heating and rendering your car usless for about 5-10 hours

Can you wire a 350 tpi fuel injected engine in a 1989 camaro?

Short answer is Yes. If you got the 350 out of another car, it would make it alot easier if out of that car you also take the wiring harness from it. Otherwise you'll shell out big bucks for an aftermarket harness. The engine mount and bolt patterns should match right up though.

How much would it cost to change a transmission gasket on a 2000 camaro?

There are several different ones.

Low end is pan gasket for less than $100.00

High end is pump gasket for $500 to $1000.00

Why is your airbag light on in your 97 camaro?

something wrong with one of the airbag sensors.

How many 4speeds made in 1980 camaro Z28?

There's no way to truly tell for sure but they were pretty rare

How do you release pressure from the fuel presure system in a 1991 camaro rs?

valve stem at back of intake press and it will release the pressure make sure to pull the relay to fuel pump

How do you replace the drivers side window motor on a 1994 Camaro?

It will be best for you to buy a Haynes Manual at a parts house or bookstore. It will give you full details and pictures. They have them that are specific to your car so you are not buying information on something you do not need.