Remove rear brake rotors on a 1980 model corvette?
there are factory rivets which have to be drilled out
I had the exact same problem twice in 3 years. I resolved it BOTH times by disconnecting the NEGATIVE side of the battery for approximately 5 minutes, then re-connecting it. The Corvette Rep told me to do so. It worked.
Bad aircon unit, of a bad engine problem Bad aircon unit, or a bad engine problem Bad aircon unit, or a bad engine problem
How do you pop up the head lights on a 1970 Corvette?
Open the hood and disconnect the vacuum hoses from the acuators at the rear of the headlight. Reach under the grill and push upward on the light housing. Pull the headlight door to its full open position. Never close the headlight doors by hand.
Where is the headlight fuse for a 1976 Eldorado they wont go on?
I believe it is integrated with the light switch, so you need to replace the entire switch.
Why oil pressure started recently reading 80 on a 1999 corvette?
First guess would be a bad oil pressure sending unit. here's my two cents. a common scenario would be the positive crankcase vent (PVC) past its usefull life. this six or seven dollar fix will bring the internal pressures into spec. Not replacing this cheap device can cost you some seals.. not a cheap fix there.... good luck
Can someone find you a vacuum diagram for an 1984 corvette also the cruise control vacuum diagram?
Even a Hayne's manual nowadays includes most vacuum diagrams for emissions control items. They vary, however, from engine to engine and are different for Federal or California emissions systems.
In the Related Links section are the diagrams you are looking for.
Where is the oil filter located on a 1995 corvette?
On a 1995 corvette the oil filter is located behind a shield at the bottom of the engine that looks to be held on by 4 bolts. This shield must be removed to locate the oil filter which will be obvious and located to the left side of the engine.
Is there a choke relay on a 1981 corvette if so where?
Yes, it's in the Center console under the radio.
How much is a 1987 corvette convertible worth?
good day.
what is it worth depends on a few things. Major things are klms,and condition.
a never accidented vette,with very low mileage,with original paint,and parts,can fetch up to $20,000,A higher mileage vette,with new paint,new top,tires,ecc...,may sale for around $8,000-,10,000
takecare
What is oil pressure c6 Corvette?
That is going to fluctuate a little bit depending on a few variables. Temperature, type of oil and how you drive the car all come into play. It could be between 20 and 60 lbs once again depending. Scoot on over to Smokinvette.com and read up on some of the other members oil pressures they have in their Vettes! Good luck!
Did Chevrolet make a 2005 Corvette zo6?
No, they stopped making the C5 generation Z06 in 2004 and started making the C6 generation Z06 in 2006
Your 1986 Corvette will start but shuts off right away?
My 86 vette was doing that ,was getting fuel and spark to the distibutor
, but had no spark to the fuel injector ,fixed fuse problem , started are away and stayed running
What is the difference between a Corvette roadster and a Corvette stingray?
A roadster is a convertible.
The Stingray was the 1969-1977 Corvette model. The 1968 was the same body style, but was not called Stingray.
What kind of fuel does the 2014 Chevrolet Corvette-Stingray use?
The 2014 Chevrolet Corvette-Stingray runs on premium unleaded (recommended).
Where can one find used Corvettes for sale?
Corvettes for sale can be found in various automobile stores depending on the location of the searcher. Additionally, one can go to Vettefinders is an official site that transaction solely on Corvettes.
What body style options did the C5 Corvette come in?
The original C5 Corvette hit the showroom in March of 1997 and offered only one body style, the hatchback coupe. In 1998 it was offered as a convertible and a year later as a 2-door hardtop.
How do you know if the cam is on compression or discharge stroke?
You can removenumber onespark plug, disconnect the coil wire from the distributor cap and ground it, stick your finger into the spark plug hole, have someone jog the starter gently, when air pushesby your finger you are on the compression stroke.
Another way if you are alone, is with the valve cover off you can turn the motor over by hand andactually see when the valves closed, and the harmonic balancer is at TDC/0 degrees.
Will the car run if the transmission solenoid is struck?
I had a popular AX4N front wheel drive Ford automatic transmission. When the(lock up) solenoid went bad the car would start and idle but stall as soon as it was put in gear. So, it would run but not in gear. There is a code for the problem. After the solenoid was replaced the trans. would still intermittently have a solenoid problem. After a few days of driving it started to work properly all of the time. I have put over 50,000 miles since with no problem. The trans. had about 100k when problem started. I suggest proper service with fresh fluid.to keep things from sticking inside trans.
How do you change blower motor on 2001 corvette?
Remove the wiring harness from the back of your 2001 Chevrolet Corvette blower motor. Remove the blower motor retaining bolts. Remove the blower motor fan. Reverse the process to install the new blower motor.
How do you replace water pump on Chevrolet V8 5.7 Liter 350?
Drain the water from your Chevrolet 5.7 liter engine cooling system. Remove the water pump return hose. Remove the water pump belt. Remove the water pump retaining bolts. Reverse the process to install the new water pump.
Where is the fuel pump relay on 82 corvette?
Behind Drivers Seat In Front Of Battery Between Battery and Carpet on floor at rear of seat
How do you open a 1979 Corvette w broken hood release cable?
I actually figured it out, with the help of a local vette guy. so let me pass on the knowledge pased to me. on the drivers side at the inner fender/rocker by the coffee can reach up & grab the lever on the release and pull it down. poof it worked. It's on fender side of the booster, aft. there may be a panel, 9/16 bolts (2) on inner fender (2) on rocker side. remove panel reach arm up and pull down.