0
Chevy Corvette
Launched in 1953, Chevy Corvette is a sports car manufactured by General Motor’s Chevrolet division. Harley Earl designed its first model, a convertible. It is Commonwealth of Kentucky’s official sports car.
4,587 Questions
How do you remove headlight switch 84 corvette?
Remove guage cluster trim bezel, remove center guage air vent trim bezel, remove 6-8 screws including 2 long ones in the defrost duct, pull CAREFULLY dash pad towards you.
Access is now gained from the top.
The factory service manual has a diagram for clarity !!
Did chuck conner own a 1953 corvette?
Chuck Connors was a writer, actor, and professional athlete. He passed away in 1992, but there is not mention of him having a 1953 Corvette.
When was the overdrive button on 1985 corvette moved from console to shifter?
The move was made from the console to the shifter some time during the 1985 production run. It was moved to the top of the shift knob.
Where is fuse panal on 1974 Corvette?
The Fuse Panel in a 1974 corvette is located to the left of the brake and clutch pedals under the dash near the kick panel.
Will the 5.7 engine from a 1999 GMC fit into a 1976 Corvette?
Yes.
Make sure you also get all the computer stuff, wiring harnesses and everything else you'll need to make the newer engine run.
Where is the horn relay on a 1986 Corvette?
The horn relay is mounted behind the instrument cluster display. This display is the one that has the overdrive, parking brake, security, service engine soon, etc. readouts.
How do you replace the fuel pump in a 1986 Corvette?
ITS LOCATED INSIDE THE GAS TANK, YOU HAVE TO REMOVE THE TANK ITSELF. I don't Think That's the correct answer. I believe the pump is in the tank, but it's verry easy to remove. Open the tank lid and remove the bolts on the plate around the filler tube. Dosconnect all the fuel and vent hoses and lift the plate straight up. the pump, filter and assembly are on the bottom of the suck tube.They will all come out in one piece.
How do you change the backup light switch on a 1989 Corvette with a manual transmission?
I just changed the switch on my 1985, if you have the 4+3 transmission the switch is located almost behind the shorter gear rod (reverse) on your transmission. Mine was tough, but after getting a small pair of vise grips on it (because I could fit a 7/8 wrench on it) I broke it lose and it basically came out with my fingers. Putting in the new one in I used the 7/8 open end and snugged it in place.
How do you program a key fob on a 2000 corvette?
Programming Transmitters Turn the ignition to ON. Turn the radio to OFF. Press the RESET button in order to clear any IPC warning messages. Press and release the OPTIONS button on the DIC to scroll through the display options until the IPC display is blank. Press and hold the RESET button for 3 seconds. Press the OPTIONS button until FOB TRAINING message is displayed. Press the RESET button in order to begin the programming sequence. The message HOLD LK + UNLK 1ST FOB will be displayed. Simultaneously press and hold the LOCK and UNLOCK buttons on the first transmitter for 15 seconds. The IPC will indicate when that transmitter is programmed and when to proceed to the next. Repeat this procedure for each additional transmitter or press the OPTIONS button to exit.
Where is the turn signal flasher located for a 1976 corvette?
It should be located behind the dash panel on the passengers side.
How do you install a starter on a 1967 Corvette?
Bolt the starter into the starter position. There will be three starter retaining bolts. Connect the cables to the front of the starter.
Check pigtail connection at alternator (possible loose), or voltage regulator going out in alternator, take to autozone or other and have tested, replace.
Will 1990 Corvette rims fit an 1985 Corvette without any changes?
Yes,but you'll need to purchase wheel adaptors ,1984-1987 has different offset than 1988-96 Corvettes .- Calderone-Online.com
How do you open c4 Corvette hatchback?
Depends on the year. The earlier cars had three hatch switches, one on the rear edge of each door (only visible when the door is open) and one inside the glove box in the console.
The passenger door switch was eliminated in the early '90s and I think the driver's door switch was also eliminated later.
How much money does a 1955 Corvette cost?
It can cost as little as $15,000 for a parts car to as much as $250,000 or more. Depends entirely on condition and originality. Chevrolet only built 700 Corvette's in 1955 so they are very rare.
When were passenger airbags installed in corvettes?
Driver's side became standard in 1990, driver/passenger became standard in 1994.
What horsepower did the 1965 corvette 327 engine come in?
The '65 Vette varied in HP from 300, 350, 365, 375 and the big block at 425. What's amazing is that the 425 HP upgrade only cost $292 more.
How can I unscrew a stuck oil filler cap on a 99 Corvette?
You can unscrew your stuck oil filter with an oil filter wrench. If the oil filter wrench does not work, punch a metal rod through the oil filter. Turn the oil filter off with the metal rod.
Can you find a brake diagram for a 1967 Chevy Corvette?
A 1967 Chevrolet Corvette brake diagram can be obtained from most Chevrolet dealerships. Many auto-parts stores, that specialize in automobile restoration, will have the brake diagram.
