0
Chevy Impala
Launched in 1958, Chevy Impala is a full-size vehicle built by General Motor’s Chevrolet division. It is Chevrolet’s most expensive vehicle and US best selling automobile through 1965. It is distinguished by its triple symmetrical taillights.
4,997 Questions
How do you install a harmonic balancer on 2002 impala?
do the harmonic balancer have a seal for anti-freezer
How do you remove the radiator in a 2000 Chevy Impala police package?
FIRST YOU MUST REMOVE THE TWO DOG BONE MOUNTS(I THINK ITS FOUR SCREWS EACH). THEN YOU HAVE FOUR SCREWS ON THE FAN ASSEMBLY(TWO UPPER,TWO LOWER). THEN REMOVE THE TRANNY LINES, AND UPPER AND LOWER RADIATOR HOSES.
How much gas does a 5.7 liter LT1 engine consume?
i have a 1995 Chevy Camaro with the 5.7L LT1 and I've noticed around anywhere around 15-17 mpg in the city depending on how much you get down on it, and anywhere between 24-26 mpg on the highway with the cruise control set.
What electric problem would cause a 2008 Chevy Impala slow to crank?
It could be a weak battery or a bad ignition coil.
How do you lubricate the ISS on a 2005 Chevrolet Impala?
You do NOT lubricate it. You can clean it with a throttle plate cleaner that is made for that purpose.
Where is the AC recharge valve on a 2000 Chevy Impala?
i have the 3.4 liter 2000 impala and its up against the top of the firewall towards the middle of the engine
How do you remove interior door panel on 2000 stratus?
This answer applies to both 2000 Dodge Stratus and the 2000 Plymouth Breeze.
The door panel can be tricky to remove. You need to remove the following screws:
- Screws from behind the door handle lever
- One (1) screw in the top right area of the door panel on the side by the side mirror
- Two (2) screws behind the speaker grate panel
- One (1) screw in handle (under a small rectangular cover) below the door locks and swithces
What is the torque for the rocker arms on a 1998 Malibu And the torque on the intake bolts?
for the rocker arms bolts its-- 98 and later, step 1- 168 in-lbs. step 2-- rotate an additional 30-degrees. this is all for a 3.1 v6, the intake bolts are -- (lower) step 1, 62 in-lbs, step2, 115 in-lbs, intake manifold bolts/studs(upper)---18 ft-lbs,
Is the ecm the same on 95 impala ss as 96 impala ss?
no. In 96 GM switched to a OBD2 ecm setup whereas 95 and earlier it had a chip style OBD1 computer
What does an exclamation mark with a half circle around it on the dash of my 2006 impala mean?
This is the Brake System Warning Light. For info see page 3-30 of your "Owner's Manual, under Section 3: Instrument Panel - Warning Lights, Gages and Indicators...
What size carburetor was on the 1969 Chevrolet Impala SS 327?
It came with a Rochester 4 barrell Quadrajet.
To locate the fuel pressure regulator for a 2005 impala?
should bo on top of engine in the fuel rail by the injectors
Why there is a noise from air conditioner on your 2003 Chevy impala?
could be a bad bearing on the air conditioner clutch assembly.
probably a universal joint. Or a cv joint depending on what is applicable to your car
How do you change broken backdoor handle on 2001 Impala?
You should have access after removing door panel
Where is the blinker relay on a 2004 Chevy Impala?
It is integrated into the hazard switch on the dashboard
Why does your 2002 Chevy Impala 3.4 turn over but want start?
There are two likely posibilities:
1. No fuel reaching the spark plugs.
2. No spark.
Unfortunately there are numerous causes for each one. For instance:
1. No fuel...no gas in tank, bad fuel pump, blown fuse in fuel pump circuit, clogged fuel line, clogged injectors, water in gas tank, overheated fuel line (vapor lock), non-vented gas cap, and more.
2. No Spark....bad plugs, flooded engine, weak battery, bad starter, bad coils, bad wires, bad ignition module, and more.
There are more than the above two possibilities of course, but the rest are probably beyond the scope of a "in the driveway fix".
How Do you reset the Change Oil Light on a 2009 Impala after you change the oil?
First make sure all doors, hood, and trunk is closed. Go to oil life menu by pressing thr left arrow button on steering wheel. Then press left arrow and info button together. You are now in the service menu. "Oil Life Reset" should now be displayed. Hold the left arrow one more time for 3 seconds and "Acknowledged" should display and your done!
What would make your brake lights not work?
The most likely cause is a bad brake light switch (if none of the brake lights illuminate) but if its only one of the brake lights, try changing the bulb. Even if they still work as running or turn lights because they have a double filament and may still work partially, but not as brake lights.
How do you install a door on a 2000 Toyota Tacoma?
After taking the fender off, removing six? screws not including the mud guard screws. You will be delighted to find 2 screws at the front of the door, 1 at the door bar in the middle and to my accounts, never was good at math; that should be it, unless you have power accessories then you will need to carefully unhook all those wires.
