What are the rear end ratios on a 1976 nova 6 cylinder automatic transmission?
the ratio's varied the most common was a 360 an some of them were 383
The exhaust is different, and you will probably need a bigger radiator.
How do you remove the ignition lock barrel of a 1974 Nova without the key?
you need the key to get it out unless you a car thief.
What are the head bolt torque settings for a 1986 Chevrolet NOVA 1.6 liter 4 cylinder?
Your best bet is to purchase a Haynes Manual that is specific to your car.
yes you can do it, either buy a petronix conversion kit and use your distribuetor or go to the junkyard and get a HEI distribuetor off any V8 and install it.
Can the camshaft on a 1962 Nova 6 cylinder be removed with engine in car?
Yes it can but it is very time consuming.
What is the Normal Temperature for 1975 Nova Straight 6?
Operating temp is control by the thermostat. They range from 160 deg. to 195 deg. they force the engine to at least be that temp. The engine itself can reach as high as 210 deg. on it's own over even higher when working hard. Just normal running with a good 190 thermostat should run around 200 deg.
Can a 350 engine replace a 305 in 67 nova?
I don't see why not,in my book a 350 is a good motor and will fit in i don't see why not,if they put 350's in a s-10 pick-up than it should fit in a nova,i have a nova it has a 307,i'm going to one day put a 350 in it,mines a 72 nova.
What is the gear ratio of a 1972 nova straight 6?
probably a 3.08 ratio. you can jack up one wheel and spin it around exactly twice. count how many full rotations the driveshaft makes and it will be your gear ratio. jack up both wheels and spin them once for posi rearends. you could go to this site too: http://www.rustynutscarclub.com/novaaxlecode.htm
Why does my 1987 chev nova run rough until the temperature of the eng goes up?
There may be a vacuum leak or a stuck EGR needle. I cleaned the EGR valve on my 87 Chevy Nova and the idle straightened out. The EGR valve was allowing exhaust gasses to escape into the fuel mix at the wrong rpm. It is suppose to open at high rpm to cool the internal chamber and prevent high temperature chemical reactions that result in unwanted emission's.
Size of bolts on a Chevy water pump pulley?
smallblock chevys usually use studs for water pump pulley. the thread size is 5/16" dia. nf (national fine thread) on the water pump flange side and 5/16" course thread on the pulley side of stud. if you use bolts you will need 5/16"NF x 3/4" long.
What does it mean when the GEN light comes on a 1972 Chevy Nova?
it stands for your charging system i.e battery and alternator. u need to make sure your belts are tight because a loose belt doesnt help the battery recharge