0
Chrysler 300 Series
The 300 “letter series” are high-performance cars manufactured in the US by Chrysler Corporation from 1955 to 1965. The cars are available as a two-door coupe and a two-door convertible.
1,224 Questions
How do you change upper and lower ball joints on a Chrysler 300?
What year, if it has upper it has to be pre 1989
The red lighting bolt light indicates a failure has been detected in the electronic throttle control system. The engine computer stores the code.
300 Chrysler 2005 5.7 where does the crankshaft position pick up it's location?
The crank sensor target is on the crankshaft inside the engine on a 5.7L Hemi.
How wide is the 2011 Chrysler 300?
The 2011 Chrysler 300 is 6 ft. 3 in. (75 in.)12 Months of provided satellite radio service wide.
What is the curb weight of the 2006 Chrysler 300?
The curb weight of the 2006 Chrysler 300 is 3712 lbs..
Where is the body control module on 1999 Chrysler 300 m?
It is on the back side of the under dash fuse box.
Where is the shift solenoid in a 2001 chrysler 300?
Inside the transmission, on the valve body.
Inside the transmission, on the valve body.
Where is the water pump on a 2005 Chrysler 300?
The water pump on the V6 engines are inside the front of the engine driven by the timing chain or belt. The water pump on a V8 is in the front and center of the engine.
Where is the PCV valve located on a Chrysler 300 2.7 ltr engine?
passenger side valve cover under the intake plenum
It is inside the transmission, on the valve body inside the pan.
It is inside the transmission, on the valve body inside the pan.
Where is the oil drain plug located on a 2013 Chrysler 300 3.6l?
The drain plug is on the bottom of the oil pan on the bottom of the engine.
Is the new 2013 Chrysler 300 srt8 coming out with the optional supercharger kit?
Not from the factory.
Not from the factory.
Where is the crankshaft sensor located on a 1999 Chrysler 300?
Somewhere by the crankshaft Facing the 3.5 engine from front of car, left rear. Sensor is connect to housing seem on transmission where connect to motor. It has a three prong clip and a 10 mm bolt securing sensor to housing. Best access is from bottom of engine. If you have a lift, it takes about 10 minutes to replace. Good Luck.
Does the cyclone vortex work in car air intake?
Research indicates that the Vortec Cyclone can slightly improve both mileage and horsepower by improving air flow through the system and by creating additional turbulence in the combustion chamber. However, do not expect huge mileage or power increases--averages are 1-2 MPG and 5-12 HP.
Chrysler 300m 1999 trouble code p0420?
Trouble code P0420 means:Catalyst system efficiency below threshold
Why does a propeller shaft have a slip joint?
Slip Joint
The propeller shaft has to meet both of the changes i.e., the angular change coming between the gear box and differential and the change in length of the distance between the gear box and differential. The propeller shaft is also not on the same line as the gear box output shaft but it runs to the rear axle at an angle because the level of the rear axle is lower than the gear box.
- ¾ To adjust 'angular motion', universal joints are provided.
- ¾ To adjust for the change in length of the propeller shaft, a slip joint is provided.
How many horsepower does the engine in the 2008 Chrysler 300 have?
The 2008 Chrysler 300's engine produces 178 hp @ 5500 rpm.
How do you replace the brakes on a 2006 Chrysler convertible?
take it to an auto shop and pay them to fix
it that is how you replace the brakes on a 2006chrysler convertable
How hard would it be to remove and then install a window regulator in a 2000 Chrysler 300M?
I have had two windows regulators replaced on my 1999 Chrysler 300M. There is a lot of precise calibration that has to be done so the window forms a tight seal with the weather striping but at the same time, the force pushing up the window can't be so great that the window breaks. Its best to have a certified machanic replace them.
What type of oil does a 1999 Dodge Stratus 4 cylinder 2.4l use?
It all depends on your driving conditions. Colder weather places (-20s) require a somewhat heavier weight 5W-30 and hot weather places (0 and above) require a somewhat lighter weight 10W-30. And it all depends on the mileage of the car, if it has close to 100,000 miles I would put a high mileage oil because they come with certain addatives to restore engine wear and help the engine last longer.
Why does a Chrysler 300 have a battery in the trunk?
It keeps it away from the engine heat, and it wouldn't fit under the hood.
