0
Chrysler Concorde
Chrysler Concorde was a four-door, front wheel drive vehicle manufactured from 1993-2004 by Chrysler. The vehicle was designed with short overhangs and low slung windshield. Its wheels were effectively placed to the side of the vehicle to create a bigger passenger cabin than its competitors.
815 Questions
Do you have to remove the gas tank to get to the fuel pump on a 94 Chrysler Concorde?
Yes, fuel pump is locate in tank and must be removed.
No it isn't just access the pump cover in the trunk
How do you replace a wheel bearing on a 2004 Chrysler concord?
Jack up the Concord. Remove the wheel. Unbolt the brake caliper and swing it out of the way. Remove the dust cover for the axle nut. Remove the nut and slide the hub off. Replace the bearings and reinstall.
What are the most popular things to go wrong with your 1997 Chrysler Concorde?
Tie rods, water pump, all air conditioner components,....
How do you change a headlight for a Chrysler Sebring 2000 Convertible?
You must remove the headlight assembly to get working access to the bulb.
Remove the long top outside Torx screw (T30), and the short one.
Slide assembly forward. Use a very small screwdriver to bend back the 2 locking tabs to release the plug. Slide plug straight out.
Then rotate black plastic collar ccw to release the bulb. Bulb pulls straight out.
When installing the new bulb (9007 series), align bulb notches with housing, push it in, then lock in the collar clockwise. Replace that plug, and turn signal plug.
Avoid touching the new bulb with your bare hands. Also wise to replace the amber turn signal bulb at the same time, while you have access to it.
Where are the Spark Plugs on a 1999 Chrysler Concorde How do you replace them?
Most auto stores will check engine codes at no cost to determine which spark plugs need replaced. (Possibly Indicated By a "Cylinder Number # Misfire" Code being Returned.) On my wife's '99 Concorde I reasearched and was told the #1 plug is the farthest forward on the passenger side.
Odd numbers run toward the firewall. (1/3/5 on pass side, 2/4/6 on Drivers Side with #2 being the farthest forward.) The plugs are easy to find, and not bad to remove. Without removing any covers, brackets or supports, you will see 6 ignition coils (one per plug) on top of the engine.
1) Unclip the slide connector that connects the two wires to the coil.
2) Use a T20 (Size) torx bit to remove the two screws that fasten the coil to the block.
3) Lift the coil straight upwards. The spark plug boot, (which you would normally find attached to end end of the plug wire) is attached to the bottom of the coil and will lift off the plug.
4) Using a high pressure compressor, blow out the hole to ensure that when you remove the plug that no debris fall into the block
5) Using a Socket ratchet & long extension fitted with a spark plug socket, loosen and remove the plug. (The socket must be fitted with a gasket to grip the plug, other wise use a piece of tape
Where is the water pump for a Chrysler Concorde 1999?
It is inside the front of the engine. On the 2.7L it is chain driven. On the 3.5L it is belt driven.
It is inside the front of the engine. On the 2.7L it is chain driven. On the 3.5L it is belt driven.
Hi,
My '94 Concorde problem started exactly as you are describing. A total rebuild & 4 trips back to the shop & it's still not right. Found out that the transmission was replaced with a Chrysler Dealer rebuilt transmission years ago . Talking to the mechanic who rebuilt this transmission, he found out that the transmission was from an Intreped & not a Concorde. Don't know weather you are the original owner but this might help a little. They really had some big problems with transmission.
You need to find out what code is being set, then you can diagnose.
im an auto technitian and it might be your alinment is off on either sides or both
How do you change a headlight bulb on 2002 Chrysler Concorde?
The headlamp bulb is removed from the rear of the headlight assembly. You have to remove the front bumber fascia to remove the headlamp assembly on this model. There is a plug that needs to be removed (twist one way, then pull) and the bulb should come out with it. Installation is reverse of removal.
see the link below for more on removing te bumper to access the headlight.
How do you add Concorde onto fsx?
Go to "http://flyawaysimulation.com/downloads-file-1788-details.HTML" pay 5$ or 5$/month to sign up and just download it from there. or you can go to simviation.com and look up Concorde and choose
Really u can download it free from simviation.com and choose Concorde and read above the description and see if its for fsx
How do you replace oil pan gasket on a Chrysler concord?
sway bar must be disconnected so you can move it out of the way
Why wont the dome lights go off in my 1999 concord lxi?
That happened to me before, there is a dimmer switch that dimms your gauge panels. you might have that swtich turned all the way up.
What would be wrong with your transmission if it locks into second gear on a Chrysler Concorde?
That happens when the computer detects a problem.. You need to have the computer checked for trouble codes.
Where is bank2 sensor 2 04 Concorde?
In order to tell you where bank 2 is I must tell you where bank 1 is first . Bank 1 on ALL vehicles is always the same side as the #1 cylinder / spark plug . Bank 2 is the opposite side from bank 1 on ALL vehicles that have 2 banks. On a Concorde bank 1 is on the right (passenger) side and bank 2 on the left (drivers) side .
Oxygen sensors are numbered with #1 being closest to the engine and #2 further from the engine. #1 is generally before the catalytic converter and #2 is after the cat.
Why is a 1994 Chrysler Concorde not blowing hot air from the heater?
Low coolant?
Thermostat not closing completely allowing engine temperature to rise?
Plugged heater core?
Temperature blend door malfunction in the HVAC housing.
When you take the cover off the fuse panel there is usually a diagram on the inside of the cover that shows the fuse panel and what the fuse is used to power. It would take a while, but you could remove each individual fuse and see if any are blown. You can clearly tell a blown fuse as the metal wire inside will be split and most likely burnt.
Where is the turn signal flasher and relay located on a 1997 Chrysler Concorde?
the turn signal/hazard flasher is located under the dash to the left of the steering column between the brake pedal and the fuse block.
Water leaking from passenger side of motor has water pump gone bad in a 1993 Saturn?
this is quite possible. the water pump is the only soruce of water on the passanger side of the engine. there are the coolant hoses running to your coolant bottle that could be leaking, or your coolant bottle itself could be leaking. these are usually not the case. water pump installation is accually quite simple. you can follow these steps if you plan on doing the repair youself.
1. jack the vehicle up on both sides, use jack stands if possible.
2. Remove Passanger front tire, along with plastic splash shield
3. Drain coolant
4. With serpentine belt still installed, loosen the 3 bolts on the water pump pully, don't take them all the way off, just loosen them.
5. Use a 14mm wrench to reduce tention on the serpentine belt enough
so you can slide the belt off
6. Remove the water pump pully bolts, remove pully, or let it rest on the
pump shaft.
7. Remove water pump housing bolts (6 of them) and discard the gasket
8. reverse procedure to reinstall new water pump
How do you unlock transmission out of limp mode on a 1995 chrysler Concorde?
You have to fix the cause of the code that put the trans computer in limp in. That could involve a new trans.
Check all fuses and ground wire going to trans. I got lucky with my 98 and just had a bad gauge fuse (speedometer stopped working). Which also could have been a bad speed sensor (output) but the dash light which says what gear I was in was out to so.
Crans
