0
Dodge Avenger
Originally introduced as a 2-door coupe in 1995-2000, the Avenger is a front wheel drive car built by Alec Warner and Josh Goodman for the Dodge brand. It was later reintroduced to the market in 2008 as a 4-door sedan.
817 Questions
What does p2270 code mean for dodge avenger 2008?
Trouble code P2270 means: O2 sensor signal stuck lean bank 1 sensor 2
My car is smoking what could the problem be.?
If it is white smoke, it could be leaking coolant into combustion chamber by a leaking head gasket, cracked block, or warped or cracked cylinder head. If it is black smoke, the engine is running to rich. (too much fuel going into engine). If it is blue smoke, engine is burning oil,(valve seals or rings).
How do you know if you have bent valves on a 1995 dodge avenger?
Do a compression test of cylinders. 100 psi average. Any thing lower than 75 psi should be considered bad.
It could, along with numerous other items. You need to have the codes checked.
How do you change front wheel bearing on 1998 dodge avenger?
Jack up the front, and remove the wheel. Unbolt the brake caliper and move it to the side, using a coat hanger or similar to hang the caliper and stop it from swinging on the brake line. Slide off the caliper. Remove the wheel nut dust cover, and the cotter pin. Remove the nut and the hub will slide off. Change both wheel bearings, the races is replaceable, then re install all components.
What amp fuse is used for the radio in 2000 dodge avenger?
The fuse for the radio in a 2000 Dodge Avenger is 10 amp.
How do you change rear turn signal 08 dodge avenger?
Very carefully. The hardest part is pulling the light out to get to the bulbs. If I can do it anyone can do it.
floppysgirl
How do you replace the turn signal controls on a 1998 dodge avenger?
Its really pretty easy, I just got back in the house from doing just that. lol. Well the only tool I needed was a Phillips screwdriver. one the under side of the steering colum is 3 Phillips screws. Take them out, then slightly squeeze the bottom part of the plastic and it will pop lose from the top half. the there are 2 more phillps screws to take out and 2 plugs for the wires, squeeze the raised parts of them for them to release. and then just reverse to install. hope that helps.
What is the gross vehicle weight of the 2012 Dodge Avenger?
The gross weight of the 2012 Dodge Avenger is 4600 lbs..
What does check engine light mean on the dashboard of a dodge avenger?
It means that the engine computer has detected a malfunction and set a trouble code.
Where is the fuse panel on a 1997 Dodge Avenger?
Two that I know of- first one is inder the hood, also has fuseable links as well as fuses. It is on the driver's side, next to the air filter. Second one is inside, driver's side, under dash next to foor/door. It is fuses only.
What if your rotor on your 1998 dodge avenger wont come off?
they will come off you will need to spray around the rotor with WD 40 to loosen it up then take a rubber mallet and hit the rotor from behind and it will come off
What ground clearance does the 2014 Dodge Avenger have?
The ground clearance of the 2014 Dodge Avenger is 0 ft. 6 in. (6 in.).
When to replace Dodge Avenger timing chain?
It will last the life of the engine. It shouldn't need replaced.
97 Avenger stalling when idle?
I have a 97 Dodge avenger and it was doing the same thing until when I had to change the IAC Valve it cost $100 but its worth it. it is located behind your throttle body.
(Idle Air Control Valve) you can do it on your own, to save $200. or locate the old one remove ti then spra6y it with Carburetor cleaner. Good Luck
Manual transmission for a 95 dodge avenger 2.5L V6?
yes if you take manual transmission from eclipse 2000 2005 it will work its the same engine ...almost
Were is the tire sensor of a 2008 dodge avenger located at?
Attached to the valve stem inside the tire/wheel.
Attached to the valve stem inside the tire/wheel.
Do you have to replace the intake mainfold gasket when you replace the spark plugs on a 96 2.5l v6?
If money is an issue, you can probably get by without replacing the gaskets (provided they don't tear when you remove the intake). But for cheap insurance, I'd replace the gasket regardless. Make sure the mating surfaces are very clean, and don't nick the aluminum when you're cleaning it. Being careful with a razor blade scraper tool, a rag and some carb cleaner should have the surface looking like new. With the new gaskets, I'd recommend a spray-on gasket sealer on both sides of the gasket. Permatex sells a nice copper spray which should help seal it up. I've learned that a gasket alone is not enough to make an effective seal. When you install the intake, make sure you torque the bolts to OEM specifications.
Where is the cabin air filter 2008 dodge avenger?
Behind the glove compartment. open the glove compartment push inward on the sides of the compartment, this will allow you to remove the glove compartment. Then remove the instrument panel. Then you can replace the cabin air filter. The shop I went to, wanted me to replace it for almost $80, but i went to a part store and the nice brand was only $35. It was easy to replace!
Will a eighteen inch rim fit a 2008 dodge avenger se?
yes 18's will fit. I have some on my avenger right now and they dont rub or anything 19 will even fit. If you want to put 20's then you will need to either get spacers or get it lifted a little bit
Where is the power steering pump in a 2000 dodge avenger 2.5v6?
it is the topmost pulley on the serpentine belt, to the left of the engine bay
