answersLogoWhite

0

Dodge Ram Van

The Dodge Ram Van, or Dodge B-Series, was a large van sold by the Dodge division of Chrysler Corporation. The van was launched in 1971 and continued production until 2003, when it was replaced by the Dodge Sprinter.

1,530 Questions

Why does your 88 Dodge Ram Van have a high idle when started?

There are several reasons for a high idle. A vacuum leak, dirty or sticking idle air control motor are a few. A gummed up throttle plate and a throttle position sensor that is improperly adjusted are a few more. If your check engine light is on, you will need to have it scanned for codes and procede from there.

Why would a 1994 Dodge van 250 3.9L sometimes have good oil pressure and go low after engine warms?

Bad oil pressure sending unit? Try replacing with a mechanical gauge Excessive engine wear? Do a compression test

What causes 1996 dodge to stall then start right up?

hi there,

i had the same problem with an 1989 b350 van. it would stall, then restart right away. however, the problem eventually progressed until it wouldn't start for up to 45 minutes. in my case, the problem was the magnetic pickup in the distributor. a good friend passed on that little tidbit of MOPAR "tribal knowledge". i swapped it out and the problem disappeared.

i have heard of stuck or impaired vacum diaphrams also showing similar symptoms; it's something easy to check with a $20 vacum test kit.

i hope this helps! Sandra

What is the ignition timing setting for a Dodge 360 gas engine?

5 degrees BTDC. remember to set the idle to 800rpm for automatic transmission and plug the vacuum advance ose before setting the timing.

On a G M 350 transmission which cooling line is the inlet and which is the outlet?

The lines are easy to find, they will be the only two steel lines coming from the area of the transmission to the radiator (just make sure you are looking at the radiator, and not the condenser - the steel lines going into the condenser are for the AC, and go from it to the compressor). The tranny fluid lines have threaded connectors that are easy to disconnect. First disconnect whichever one is easiest to get to, and then disconnect the main distributor wire, and have someone turn over the starter a few turns while you watch where you disconnected the tube. If tranny fluid flows out of the radiator, you have the outlet, if it flows out of the tube, you have the inlet (and if what flows out is not tranny fluid, you have seriously gotten the wrong one. If it is the wrong one, connect it back up, and disconnect the other one. Another way is to feel of the lines after you start the engine. The line that gets the hottest the quickest is the inlet. If you're feeling brave you can start it cold and drive it around the block and then feel which one is hot and which is cooler. The hot is the out and the cooler is the return line. One could assume the upper hose in a tranny cooler is the out and the lower the return but who knows how it was installed. I'd also check TH350 images in a google search and you might find a illustration with more detail...or ask someone selling one on Ebay. Think differently!

How do you find the small filter in a 1992 dodge ram van transmission?

You must drop the transmission pan. It is usually held in by 2 or 3 screws, which may be either Phillips or Torx head.

Where is blower motor resistor for a 2001 dodge ram van 3500?

Under the hood, on the passenger side. There is a 4 wire plug into the black housing. It is right there.

Under the hood, on the passenger side. There is a 4 wire plug into the black housing. It is right there.

How many miles on 2003 Dodge Ram Van?

You would need to be more specific with your question. You are not providing enough information to supply a meaningful answer.

Do you need to remove the coil spring to replace the upper control arm bushing on 1990 dodge ram van?

I have a '96 and I know they changed some things, but to my knowledge it's not necessary. I've completely removed my upper control arms without touching the coil springs. The coil spring goes from the lower arm to the frame, and the upper only connects to the steering knuckle.

What does diagnosis code 12 mean on a 1995 dodge ram van b2500?

Code 12 means that the computer has been reset.This code will always be ther no matter what you do.There is no getting rid of it.

How do you install a new radiator in a 1996 Dodge Ram Van B2500?

The question you ask is too involved for a proper answer. You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.

Where can you find the electric door lock module in a 1997 dodge ram van 2500?

On my 1997 Dodge B2500 van the door lock manual is directly in front of the radio at the center of the dash (below the windscreen glass).

Why does the blower motor stay running after key is turned off on 2003 dodge ram 2500?

I pulled apart the steering column and removed the harness that plugs into the switch and found some burnt terminals on the switch. Bought a switch for $20 at the parts store and replaced it. Problem solved. Got lucky and the harness was not damaged.

Where is the air filter 2001 Dodge Ram van 2500?

On top of the engine block. You'll need to remove the inside engine cover