Eagle Talon

Look in Related links

you'll need a new themostat, (preferably 180 degree) a new thermostat gasket, a 12mm socket with wrench and exstension. drain the coolant via the radiator, remove the two bolts from the thermostat housing, remove old thermostat, clean thermostat housing top and bottom, insert new thermostat(twist both ways and determine the center of operational clearances, generally bulk of sheat metal facing southeast if you are standing in front of the car) line up thermostat gasket on lower housing, place upper housing on lower housing, inset bolts and torque them to 20 psi.

Diamond Star Motors also known as DSM. The company consisted of Mitubishi Motors and Chrysler Corp. The talon was sold under the eagle badge by Chrysler to compete with Japanese imports. After Chrysler purchased American motors in 1987, the sisters, Laser sold by Chrysler and eclipse sold by Mitsubishi were manufactured. Eagle and Plymouth have since been discontinued.

You need to turn off the Overdrive switch.

No, Vtech is Honda's variable valve timing and lift system. The first Vtech systems came out in about 1992 and there are different versions of the system with different performance objectives. Vtech-E is designed to maximize fuel economy, where the vtech on a Si model is for performance. There are other systems which increase mid-range performance.

Turbo charging uses an exhaust gas driven pump to pressurize the air being supplied to the engine to increase performance.

It is located on the back of the intake manifold. You will see three ports...the one in the middle is the IAT. The other two are vacuum hose connections.

And instructions thanks to Autozone.com: Disconnect the negative, then the positive battery cables from the battery. For 1990-94 vehicles, remove the battery and battery tray from the engine compartment. For 1990-94 vehicles, detach the speedometer cable connector from the transaxle. Detach the starter motor electrical connections. Unfasten the starter motor mounting bolts, then remove the starter from the vehicle. Clean both surfaces of starter motor flange and rear plate. Install the starter motor onto the engine and secure with the retainer bolts. Tighten the retainers to the specifications shown in the accompanying figure. Attach the electrical harness connector(s) to the starter. If removed, install the intake manifold stay and tighten the retainers to 18 ft. lbs. (25 Nm). For 1990-94 vehicles, attach the speedometer cable to the transaxle. Install the battery tray and battery. Connect the positive, then the negative battery cables. Operate the starter to assure proper operation.

your starter is on the top of transmission there are two bolts and i ground wire is bolted to one just take the two bolts out and it will wiggle out

Yes, the interior covers for a 1995 Mitsubishi Eclipse should fit a 1996 Eagle Talon, as both vehicles share a similar platform and many components, including interior parts. However, it's always best to verify specific details like mounting points and trim variations, as there may be slight differences between models and production years. Checking compatibility with a trusted source or parts catalog can provide additional confirmation.

To remove the caliper on a 1994 Eagle Talon, first, make sure the vehicle is securely lifted and supported. Remove the wheel to access the brake caliper, then use a socket or wrench to remove the caliper mounting bolts. Once the bolts are removed, carefully slide the caliper off the brake rotor, taking care not to damage the brake line. Support the caliper using a hanger or bungee cord to avoid straining the brake line.

For a 1992 Eagle Talon TSi, high mileage is generally considered to be over 150,000 miles. Given the age of the vehicle, wear and tear on components can significantly impact performance and reliability. However, well-maintained models with higher mileage may still be in good condition, so service history is also an important factor to consider.

The fuse box layout for a 1993 Eagle Talon TSi is typically found in the engine compartment and inside the vehicle, usually near the driver's side. The engine bay fuse box contains fuses for components like the fuel pump, ignition, and headlights, while the interior fuse box manages power for items like the radio, interior lights, and power windows. For a detailed layout, it is best to consult the vehicle's owner's manual or a service manual, as it provides specific diagrams and fuse ratings for each circuit.

For a 1995 Eagle Talon Turbo, it's recommended to use 10W-30 or 10W-40 motor oil, depending on the climate and driving conditions. In colder climates, 10W-30 is preferable, while 10W-40 can be used in warmer conditions. Always consult the owner's manual for specific recommendations and ensure the oil meets the required specifications for turbocharged engines.

The 1990 Eagle Talon typically comes with either a manual or automatic transmission, depending on the specific model and trim level. The manual transmission is often a 5-speed, while the automatic version is usually a 4-speed. Performance-oriented models, like the Talon TSi, may feature a more advanced transmission setup. Always check the specific vehicle specifications for accurate details.

To change the alternator in a 1990 Eagle Talon, first disconnect the negative battery cable to ensure safety. Remove the serpentine belt by loosening the tensioner, then unbolt the alternator from its bracket. Disconnect the wiring harness and remove the alternator from the engine bay. Install the new alternator by reversing the steps, ensuring all connections are secure and the belt is properly tensioned.

In a 1995 Eagle Talon, the inertia switch is typically located in the passenger compartment, near the right side of the vehicle, often mounted on the firewall or under the dashboard. It is designed to cut off the fuel pump in the event of a collision. If you're having trouble locating it, consulting the vehicle's service manual can provide detailed guidance.

The brake fluid reservoir on an Eagle Talon is typically located near the back of the engine bay, close to the driver's side fender. It is usually a translucent plastic container with a cap labeled for brake fluid. To access it, you may need to open the hood and look for the reservoir near the master cylinder, which is mounted on the firewall. Always ensure the engine is cool and the vehicle is parked on a level surface before checking the fluid level.

In the 1995 Eagle Talon 2.0L Turbo TSI AWD, the turn signal and hazard flasher is located under the dashboard, typically near the steering column. You can find it by looking for a small, cylindrical relay that is often plugged into the fuse box area. To access it more easily, you may need to remove lower dash panels. Always refer to the vehicle's service manual for specific details and diagrams.

To install a blow-off valve (BOV) on an Eagle Talon, first, ensure the engine is cool and disconnect the negative battery terminal. Remove the factory intake piping where the BOV will be mounted, usually between the turbo and intake. Install the BOV according to the manufacturer's instructions, securing it to the piping and connecting any necessary vacuum lines. Finally, reassemble the intake system, double-check all connections, and reconnect the battery before starting the engine to test for leaks.