0
Ford Aspire
The Aspire is a fuel-efficient compact car that replaced the gas-thrifty Ford Festiva. With Mazda-made components and Kia-produced body, the Aspire is available in three variants including the two-door hatchback SE and the base two- and four-door hatchback.
551 Questions
What does a 1995 ford aspire weigh?
The 1995 Ford Aspire has a curb weight of approximately 2,200 pounds (around 998 kg). This lightweight subcompact car was designed for fuel efficiency and urban driving. Its compact size and low weight contribute to its nimble handling and economical performance.
Is a 1994 Ford Aspire crankshaft bolt right or left hand threaded?
Spin the bolt to the left to loosen as normal. You will need a powerful impact air tool.
1995 Ford Aspire it turns over but it won't start could that be the distributor cap?
Check fuel pump,filter,relay switch,fuses,etc. or spark plugs,wires and distributor cap.
Where is the Relay for Cooling Fan on a 1995 Ford Aspire?
There is a high pressure switch in the front on the ac line near the drivers light.(right on the ac line) disconnect the wire plug and use a bobby pin or simular(cotter pin) and put it in the plug. turn on the ac abd the fan should come on. I actually have mine taped up in the summer because my ac doesn't seem to put out cold air when my car is a a red light or stop sign. you will see this really works . Also i bougt 5 new relays ay a junk yard and it still did the same thing so i just jump the plug and tape it up real good and mt ac works fine.
could be the timing belt if it is broken it will turn over all day but wont start could also be fuel pump and filter it the pump is bad or the filter is severly clogged you will have the same problem
Need a emergency flasher unit for 97 Ford Aspire?
An emergency flasher replacement can be purchased at any auto parts store. Some auto parts store you can visit are AutoZone and NAPA.
Why the 95 Ford Aspire headlights keep blowing the fuse?
Fuses That "Blow" Repeatedly
Without being able to "hands on" troubleshoot the circuit served by the repeatedly blowing fuse, none of us can identify the specific defect which is causing your problem.
Therefore, the following generic answer can be applied to any electrical circuit, whether in a vehicle, or in a building, or whether alternating current [AC] or direct current [DC].
Fuses [and Circuit Breakers] are safety devices designed and installed in electrical circuits TO PROTECT the conductors [wires] and other components from short circuit conditions and/or overload conditions which cause an extremely large flow of electrical current [measured in Amperes], which causes overheating of the conductors that results in damage to the insulation and the conductors.
And in a worst case scenario, the probability of a FIRE which could destroy the vehicle, house, or other structure in which the circuit is located.
When a fuse or Circuit Breaker [and replacement fuses, or repeatedly "tripping" Circuit Breakers] "blow," especially if it happens repeatedly, is an indication of an UNSAFE CONDITION in that circuit, usually a short.
The fuse or circuit breaker is doing what it was designed, intended, and installed to do, that is to protect the conductors and components of the circuit which it serves.
The proper "fix" for this issue is for a qualified technician, who knows what he or she is doing, to troubleshoot the involved circuit, find and identify the defect, and make proper repair [s], BEFORE replacing the fuse again [with the properly sized fuse or before resetting a circuit breaker].
Some ignorant few people will suggest installing a larger fuse or breaker to solve the problem, BUT that will only increase the hazard, not correct it.
Do not follow "bad" advice by installing a larger fuse in a misguided attempt to correct the problem. To install an oversized fuse would almost guarantee damage to the wiring and the probability of an electrical system fire.
How do you remove valve lifters in Ford Aspire?
The "lifter" is part of the valve rocker arm / cam follower. It is in the tip over the end of the valve stem. If your Aspire ticks briefly during start-up, the lifter/ lash adjuster is remaining collapsed until the oil pressure builds up.
Why won't 1995 Ford Aspire start?
check your engine fuse under the hood, test to see if you have spark, and if both those are good check the fuel shutoff behind a panel on the drivers side of the trunk. that should solve your issue.
Where is an egr valve located on a 1997 Ford Aspire?
It is located between the engine and the firewall at the right side of the engine approximately the same heighth as the bottom of the valve cover. There is two vacuum hoses attached to it and it is held on with two bolts. It also has a plug with wires attached to the top of it, is round on the top of it about 2-1/2 inches in diameter.
Why does your Ford Aspire blow steam out the tailpipe?
Very likely you have a blown head gasket. Condensation is a possibility, but this sounds new. There are commercially available head gasket testers. Check your coolant level and oil condition. Low coolant indicates a leak that you can't see aka steam.
How do you change the front brakes on a 1997 Ford Aspire?
Take a 14mm socket. there are 2 back bolts on the back use this socket on them. pull the calliper off, then there is going to be a keeper spring that is hooked to the brake pads. Very carefully take it off don't break it. Then there is another keeper in 2 pins take that one off also. Pull the pins and the pads will fall off. Push the caliper piston back into the caliper body using a C clamp or similar. Replace in reverse order. This job is done best when referring to the Haynes or Clymer manual for the vehicle.
