0
Ford Falcon
Manufactured between 1960 and 1970, the Ford Falcon was a huge success for Ford, surpassing its rival compacts from General Motors and Chrysler. It was produced in various body styles, such as 2-door and 4-door sedans.
937 Questions
Who invented the two stroke engine?
The inventor of the two-stroke engine was an engineer named Dugald Clark. Clark was born in Glasgow, United Kingdom in March of 1854. His last name is also recorded as Clerk in some instances.
as far as i can remember, the six cylinder ba falcons don't have leads, they have individual coil packs.
What years was the Ford Falcon in production?
The Ford Falcon was in production from 1960 to 1963 which was just the first generation of cars. The second generation was in production from 1964 to 1965 when they stopped the production.
Diagram of 69 Ford Falcon fuse box?
You can purchase a diagram of the 1969 Ford Falcon fuse box at major auto parts stores. If the store doesn't have the diagram in stock, the associate can order it for you.
How do you adjust AU Ford Falcon steering rack?
1.Disconnect the negative battery cable and center the steering wheel. Pull off the lower instrument panel and uncouple the steering column shaft and steering gear pinion.
2
Lift and support the front end before removing the wheels. Unscrew the tie rod end nuts and use a ball joint press to detach the tie rod ends. Separate the stabilizer bar links and strut and spring assemblies.
- 3
Unhook the fluid cooler hose and drain the fluid into a clean container. Remove the heat shield, hose support clamp and power steering hoses from the gear. Jack the crossmember for support and remove the bolts before lowering it from the frame. Once you remove the floor seal and steering column coupling shaft, you call pull out the rack and pinion assembly.
- 4
Replace the pressure and return hose O-ring seals before you install the new gear. Tighten the gear fastening bolts to 59 foot pounds. Reattach the steering column coupler shaft and replace the original floor seal. Use pins to align the crossmember to chassis alignment holes and secure the crossmember with outer bolts tightened to 85 foot pounds and four inner bolts tightened to 148 foot pounds.
- 5
Remove the transmission jack and subframe alignment pins to reconnect the power steering hoses. Tighten the hose support clamp and replace the heat shield. Secure the support insulator to the transaxle center bolt with a torque of 37 foot pounds.
- 6
Connect the cooler hose and relink the stabilizer bars to the struts and springs (37 foot pound torque). Tighten the new tie rod end nuts to 35 foot-pounds and replace the wheels. You can lower the front end at this point.
- 7
Reattach the steering column coupling shaft and steering gear pinion with w new clamp bolt (21 foot pounds). Replace the instrument panel, refill the fluid and reconnect the battery. If you don't do a complete front-end alignment, you should at least make sure you properly adjust the toe.
Your Ford Falcon automatic transmission is stuck in 3 gear 1997?
that is called Limp Home Mode
this is caused by some sort of failure that the ECU has picked up
What do you do if you accidentally put laundry detergent in your Ford Falcon radiator?
You'll need to drain and refill the car's radiator. I might recommend flushing the radiator as well to remove all traces of soap. Most auto-parts stores carry a flush n' fill radiator kit for under $20, the only other thing you'll need is a bucket to catch the soapy antifreeze coming out and a garden hose to hook up to the radiator. The hose water blasts out all the rust (and soap) from the radiator system. Then you just refill it with 50-50 mix of antifreeze and water. Don't buy the premix; it's a ripoff. Mix it yourself. It's a good idea to do this anyway, every couple of years as maintenance. The Falcon is an older car, so it shouldn't have any surprises. Instructions are included with flush n' fill kits.
Is there a drive belt for an au falcon that bypasses the airconditioner compressor?
No, Have a look at the way the belt is. You cant just get a shorter belt and bypass the AC compressor as the belt would foul on the tensioner. u need a AC bypass pulley and bracket, and so far, i can only find these genuine
How do you remove a ignition coil on a el falcon?
Not an easy to get to 'job'! Best from below, on hoist or trolley-jacked then jack stand for safety; it's on the engine block just behind the distributor, 2 bolts 8mm that you'll need small ratchet with small extension to undo. Good luck getting another attached....mongrel of a job!
How do you get to the fuel pump on a Ford Falcon EL?
It's in the boot. lift the carpet and there will be a metal plate hekld dont by about four screws. lift that up and it will expose the access point to the fuel tank. to get the pump out you have disconnect the fuel lines, electrical plug and undo the clamp a little bit. you will need to make a tool to unscrew the plastic ring holding the pump in. once the ring is off, the pump will come out. just need to riggle it out. be careful because the fuel gauge level indicator is part of the fuel pump assembly.
How do you Adjust the band on the trans on Eb Ford Falcon?
the old four speeds have two band adjusters one on either side, but first is the car clunking shifting gears? if it is it the s5 shift solenoid inside the auto, common problem, only problem is there still about 150 bucks, to adjust the front band crack the 15/16 lock nut wind the centre adjuster till it goes firm, back of quarter of turn, then lock 15/16, the rear one is one and a half turns out, good luck
Which was the maximum speed of Ford Falcon convertible manual 6cyl 101HP 1962?
The maximum speed of Ford Falcon convertible manual 6cyl 101HP 1962 was 180 km per hour.
How do you set the ignition timing on a 6 cylinder ford ef falcon?
You can't the computer does it, just get electronic diagnostic check
How do you remove a 1995 Ford Falcon ignition barrel?
you have to remove lower plastic cover should be two screws this will give you access to barrel holder place the key in barrel and there is a small pin that you have to press in with a small pointy object I used straightened paper clip when you have pushed in the pin turn key to acc then pulling on the key barrel should remove hope this has been of help
I can't find the switch to disable my immobilizer on my a 1992 Ford Falcon?
why would you want to do that? the inhibitor switch is on the passengers side of the transmssion. it's the white bolt on thing which the selector goes through.
What is the red warning light on your dash that flashes after you turn your falcon off?
It's basically the smartlock function. it basically immobilises your car so without the key, you can't start the car. Also I believe it has something to do with central locking.
What is faster a Holden commodore or a Ford Falcon?
holdens suck they are the worst ever and they are faster than ford ford stands for first on race day
Where is the water temp gauge sensor located on the Ford Falcon EL motor?
Located just below thermostat
What is the tire pressure for a 2004 Renault megane 1.4?
Listed in your owners manual and on the vehicle somewhere. Look on the drivers door post, truck, glove box, console, etc. It is there somewhere.
How fast does a Peregrine Falcon go?
it is the fastest animal in the world and can reach speeds of 370 km/h (231.25 mph) when diving.
the world record is 440 km/h (275 mph)
also when flying verticaly it can go 144 km/h (90 mph)
Others out the diving speed at around 85 mph and level flight speed at 65 mph.
Is there a way to restore the brightness of EL Falcon headlights?
you can buy a kit from most auto shops to take out the yellow and restore plastic headlights
