0
Ford Fiesta
The Ford Fiesta was a front-wheel drive subcompact or supermini automobile. It was manufactured and marketed by Ford Motor Company worldwide, including the Americas, Australasia and Japan, selling more than 12 million units since 1976.
1,492 Questions
Where is Ford Fiesta 1.6s water themostat housing?
Looking at the engine, it's on the right hand side of the engine, It's silver, has a small diameter pipe coming out of the top and a large diameter pipe going into the side of it
What oil should you put in your fiesta zetec s?
according to haynes manual and several forums ive read up on they say 5w/30
Where is oil filter on 1.4 diesel fiesta?
The oil filter on the 1.4tdci is mounted on the right-hand side of the engine block (as you look in under the bonnet) and is in a black plastic housing which unscrews to expose a replaceable paper element filter. The filter housing points upwards at a slight angle, and looks like a fat black bottle with a hexagonal cap.
Does the Ford Fiesta have a carburetor?
Festivas had a carburetor on the manual transmission models until 1990. After that all Festivas were Multipoint Electronic Fuel Injection. The automatic transmission Festivas were MP-EFI from 1988 on.
^^^I've got a 1.1 1996 fiesta and its running on a carb...so not completely true^^^
engine rebuilds can be costly more than a fiesta mk4 may be worth!
you may be better going to you local scrap yard/breakers and buying a used engine. some yards may even remove yours and replace it with a good one for a minimal cost.
They will keep your alternator, power steering pump etc, just replace the main block.
Either way its going to cost possibly more than the cars worth!
How do you remove an airbag Ford Fiesta?
How do you remove the bottom front right airbag on a 2011 ford fiesta.
How to repair broken seat latch fiesta?
The cable mechanism consists of two separate bowden cables ( rather like bike brake cables) connected to one nipple at the seat latch end. It's best to remove the seat back from it's base to avoid frustration. Remove seat from car, detach any plastic trims at bottom of back. Be careful not to damage seat tensioner mechanism which can be triggered unless car battery disconnected first, then wait 2 minutes before removing the plug under the seat, press plastic release latch on plug to separate. Seat back angle knob levers off with a couple of screwdrivers. Remove 2 size 50 Torx bolts to separate seat back from base. Seat cover can be released by pulling plastic hook strips apart, not too difficult and gives more space to work on release latches at base of seat back.
Latch handle at top of seat is separate from cable unit. Cable unit has a plastic end which locks into hole in seat interior by 90 degree twist. The visible seat latch handle clips onto this using a plastic latch which can be seen from outer edge of the seat if handle is prised away from the upholstery (remove one long screw on passenger side handle) Press this latch inwards to release the handle from the cable unit. I broke mine not knowing how they were attached ...it cost £18 to replace doh.... Disconnect cable ends from seat latch before attempting to remove handle else cables will hold handle in place. Use a bit of string on old cables to pull new ones into place feeding down from top of seat. Fit new handle to cable before re-attaching cable ends to seat latches, there is not much slack in cable. Note routing of old cables before replacing new ones. Also note how cable ends fit onto latch mechanism.
Repair shops charge £70 upwards for this job which is probably justified by it's fiddly nature. It's not too difficult once you have figured out how all the plastic trims fit together. NOTone of Fords better designs.......
What is the Difference between door jam and door frame?
A door frame is the rough opening that the door and door jam go in to. Door frames are part of the framing of a house and the door jam is the out side frame that the door sits in.
Cylinder head torque specs Ford Festiva 1.3?
Cylinder Head Bolts for 1988-1997 Festiva and Aspire 1.3L I4 Engine
Step one: 35-40 foot pounds
Step two: 56-60 foot pounds
How does a heater valve work in a Ford Fiesta?
the heather control valve in in the engine bay. It has 2 hoses going into it, 2 hoses going out and into the heater matrix. When you turn your heater on you will need the Heater control valve to get hot air. If your HCV is faulty you will not get any hot air from your fans (inside the car)
This is common item in a fiesta to go and replacing it is a piece of cake! even if your new to mechanics...
also if your fan speed only works on '4' (highest speed) it means your resistor Is gone (another common fault) Resister is secured by 1 screw, its under the passengers dash, and has 1 cable going into it. Its about the size of a 'sushi'
What exactly did you want to know?
How do you change the cylinder head gasket in a 1998 Ford Fiesta?
buy a haynes manual mate. big job. total engine overhaul. head skimming. head gasket kit with new bolts etc. etc. if car is still running try kalimex to seal the gasket
Where is Ford Fiesta diagnostic plug located?
On the kick panel under the glove box next to the door in the passenger's footwell there is a little plastic cover, it is moulded to the shape of the panel. Pull this off and you should find the socket under there. It is on mine anyway.
Hope this helps
Ford Fiesta front rear wipers do not work HOW TO FIX?
water comes out of rear but dose not come out of front ones
you need to check your shock absorbers on the front/back as one may be leaking oil (there oil filled) i had the same exact problem with my ford fiesta 98 and had to get them changed. its great now, no more banging when you go over speed bumps.
Where is the fuel cut off switch located on a 1993 Ford Fiesta?
on all fords ive dealt with ist behind the plastic banel by your right foot when your sat in the drivers seat and its just a little red button you push back in if its been activated it will have popped out
What are the torque setting for a Ford Fiesta 1993 head bolts?
30 Nm + 90 degree's + another 90 degree's
What are the Common faults with Ford Fiesta zetec 1.4?
i have had this car 4 a year in it simply doesnt go wrong and i have driven it hard
Do all 1996 Ford Fiesta 1.3 encore have power steering?
Yes, ..96 have power steerings
No not all 1996 Ford Fiestas have power steering!
How do you adjust the handbrake Ford Fiesta mk5?
THE FORD GUY SAYS` remove leather gater from handbrake, you will see a 10mm nut, give it a few turns and try, and a few more and try again till its about 4/5 clicks, that's it good luck
Your car heaters wont blow warm on your Ford Fiesta?
if you look to thte left of your pedals you will see the cover which is attached to the radio and dashboard etc, pull it off and you will see the wire and the bit of plastic it attached to , the wire will have come loose but you can adjust the heater to cold or hot from there but you have to keep the cover off.
i hope this helped.
