0
GMC Envoy
The GMC Envoy is a mid-sized sports utility vehicle (SUV) from the GMC brand of General Motors. It was launched as a luxury counterpart of the GMC Jimmy in 1998. The car features a front engine and four/rear-wheel drive.
1,161 Questions
How can you fix your gas gauge on a 1995 Mazda b2300?
Is it not working due to bad fuse?
if so what fuse is it.
i do not have the diagram.
Does the gmc 2004 envoy have an oil pump?
As far as I know ALL cars have an oil pump. Every car I have ever worked on has had the oil pump INSIDE the oil pan.
Hi. I found this on another page. Hope it helps Peter P1123 Oxygen Sensing Adaptation Area 1 (Cylinders 1 - 3) - Lean Threshold P1125 Oxygen Sensing Adaptation Area 1 (Cylinders 4 - 6) - Lean Threshold
Your key is stuck in the ignition in your 2003 GMC Envoy is there a key release button?
My envoy did this also when the battery died. installed new battery and key came out.
How much does a smog check cost in California?
Standard California Smog Fee of $8.25 plus the dealer may not charge more than an additional $50.
From www.bar.ca.gov on 2/9/2010:
How much does a Smog Check cost?
Smog Check prices vary in different areas. Prices for Smog Checks are not regulated, so you are encouraged to shop around. For a list of stations in your area, visit the search page or call (800)952-5210.
Where is the Ect sensor envoy?
If it's the 4.2L 6 cylinder, it's located on the passenger side of the engine block, all the way back just above the exhaust manifold.
Why does your 2004 GMC Envoy make a grinding sound when you accelerate?
I know this sounds silly, but check your e-brake. It will often do that when you have no tires on the wheels.
How do you change the front and rear sway bars on a 95 windstar lx?
to do the frt one's put a jack under the sub frame and then undo the sway bar links remove the two rear sub frame bolts and let the jack down slowly you may have to unhook the exhaust at the flex pipe remove the four bolts from the sway bar bushings and the bar should come out.
2006 gmc envoy Denali will not blow air out of main dash vents anyone know what the cause may be?
The mode door actuator has gone out. www.trailvoy.com
Where is the ambient temperature sensor located on an 02 Chevy Trailblazer?
Its Under The Top Radiator Shroud near the Radiator Mount. You May have to remove the grille to get to it.
Hope this helps.
What is the right spark plug gap for a 2003 gmc envoy?
The recommended spark plug gap for a 2003 GMC Envoy is typically between 0.040 to 0.060 inches, depending on the engine configuration. It's always best to consult the owner's manual or a service manual for the specific engine type to ensure the correct gap. Proper gap settings help optimize engine performance and fuel efficiency.
Where is the speed sensor on a 2003 gmc envoy located?
On a 2003 GMC Envoy, the speed sensor is typically located on the transmission. Specifically, it can be found on the driver's side of the transmission case, near the output shaft. It’s often mounted to the transmission with a single bolt and connected by an electrical connector. Always refer to the vehicle's service manual for precise location and removal instructions.
Is the Yukon the same 6 bolt pattern as the envoy?
Yes, the GMC Yukon and the GMC Envoy share the same 6-bolt wheel pattern, which is 6x5.5 inches (also known as 6x139.7 mm). This means that wheels designed for one vehicle can typically fit the other, provided the other specifications such as offset and diameter are also compatible. However, it's always advisable to double-check specific wheel and tire requirements for each vehicle model.
Where is the ecm fuse located on a 2004 gmc envoy?
The ECM (Engine Control Module) fuse on a 2004 GMC Envoy is typically located in the under-hood fuse box. To find it, open the hood and locate the fuse box on the driver's side near the battery. The specific fuse you need to check is usually labeled in the fuse box cover, often referred to as the "ECM" or "ECU" fuse. Always consult the owner's manual for precise information regarding fuse locations and specifications.
Can a p0495 error code cause p0128 error code gmc envoy 4.2?
Yes, a P0495 error code, which indicates a problem with the secondary air injection system, can contribute to a P0128 error code, which signals that the engine is not reaching the proper operating temperature. If the secondary air system is malfunctioning, it can affect engine performance and efficiency, potentially leading to insufficient heat generation. This could result in the engine taking longer to warm up, triggering the P0128 code. It's advisable to address both codes to ensure optimal engine function.
Where is the low side recharge port on the 2003 gmc envoy?
The low side recharge port on a 2003 GMC Envoy is located on the passenger side of the engine compartment. Specifically, it can be found near the rear of the engine bay, on the A/C line that runs from the evaporator to the compressor. The port is typically marked with a blue or black cap. Always ensure to use the correct refrigerant and follow safety precautions when recharging the A/C system.
HOW TO REMOVE HEADLINER 2002 GMC Envoy?
To remove the headliner from a 2002 GMC Envoy, start by removing any trim pieces and grab handles that may obstruct access. Next, carefully detach the sun visors, dome light, and any other components attached to the headliner. Once these are removed, gently pull down the headliner from the roof, taking care not to damage the adhesive or retainers. Finally, slide the headliner out of the vehicle, ensuring that you maneuver it around any remaining obstacles.
What type of oil is required for a 2002 GMC envoy rear differential?
For a 2002 GMC Envoy, the rear differential typically requires a gear oil with a viscosity of 75W-90 or 80W-90. It's important to ensure that the oil meets the API GL-5 specification for proper performance. Always consult the owner's manual or a professional mechanic for specific recommendations and any updates to the required specifications.
How much does it cost to repair an idler pulley bearing in a 2008 gmc envoy?
The cost to repair an idler pulley bearing in a 2008 GMC Envoy typically ranges from $100 to $300, depending on labor rates and whether you choose to use OEM or aftermarket parts. This estimate includes both parts and labor, with the idler pulley bearing itself costing around $20 to $60. Labor costs can vary significantly by location and shop, so it's advisable to get quotes from local mechanics for a more precise estimate.
