difficult creature you've got... I hope you have a manual, because if your planning on keeping it, you'll need one. Ok.. Vacuum leak Bad Timing if it's missing check all ignition components try a new fuel filter check the fuel pressure(too high or too low) good luck d
It sounds like the battery is ok so check the wire connections at the battery and make sure they are tight and clean, do the same for the starter. If this does not help the starter may be going bad.
Can you swap 2jz gte engine in a 93 gmc sonoma?
Yes, you can swap a 2JZ-GTE engine into a 1993 GMC Sonoma, but it requires significant modifications. This includes custom engine mounts, alterations to the drivetrain, and possibly modifications to the wiring harness and ECU. Additionally, you will need to address cooling, exhaust, and fuel system compatibility. Overall, while it’s a challenging project, it can be done with the right skills and resources.
How do you change fuel vapor sensor on a 1997 gmc sonoma?
To change a fuel vapor sensor on a 1997 GMC Sonoma you need to disconnect the wires that are holding it in place. Next, remove the old sensor and replace with the new one.
Where is the ground wirers on 2000 gmc sonoma?
On a 2000 GMC Sonoma, the ground wires are typically located in several key areas, including the engine block, the battery, and the chassis. You can find the main ground wire connected to the negative terminal of the battery, which usually runs to the engine or frame. Additionally, there may be smaller ground wires attached to various components, such as the alternator and the firewall. It's important to ensure all ground connections are clean and secure for optimal electrical performance.
Where is the oil sending unit on a 1993 4.3 gmc sonoma?
The oil sending unit on a 1993 GMC Sonoma with a 4.3L engine is located on the engine block, typically near the back on the driver's side. It is mounted above the oil filter and can be accessed from underneath the vehicle or from the top with some maneuvering. Make sure to disconnect the battery before working on it to avoid any electrical issues.
Where is the oil sending sensor located on a 1999 gmc sonoma 2.2 liter?
On a 1999 GMC Sonoma with a 2.2-liter engine, the oil sending sensor is typically located near the oil filter, on the engine block. It is usually positioned on the driver's side, towards the back of the engine. To access it, you may need to work around other components, as space can be tight in that area. Always ensure the engine is cool and the battery is disconnected before attempting any repairs.
The fuel pump relay switch would be found under the hood, on the firewall, drivers side, near the power brake booster. The oil pressure sending unit would be found under the hood, in back of the engine, on top, very close to the distributor.
How do you change the front disc brakes on a 1997 gmc sonoma?
Take the front wheel and tire off after you have the front end jacked up. Then you will wanna look at the brake caliper that is holding the brake pads, which you will see two bolts at the top running through. Take those bolts out and the caliper will come off and then you just pull out the brake pads and make sure to use a c clamp to push the brake cylinder back in so you can put the new pads in then just put that caliper back on and tighten those two bolts and put the wheel and tire back on. Make sure you pump the brakes before you start to drive the truck so the pads are back where they need to be close to the brake rotor.
How do you open the hood when the inside latch is broken?
The best way to do this is to use a ratchet with a long extension and from underneath the vehicle remove one of the mounting bolts that hold the latch bracket. This will allow you to pull up the hood a few inches to get to the latch assembly and open the hood. I have had to do this myself and it worked.
How to remove instrument panel on 96 gmc sonoma to get to heater core step by step?
If you are a novice get ready because you are going to be mad by the time you get done first get the book which if i am correct list labor time as 10 hours that is strait time me and bro did it in 4.5
Best spark plug 2002 gmc sonoma?
AcDelco platinum plug
it is already pre gapped to .060 so there is no need to gap them if you have the 4.3 engine.
DO NOT USE BOSCH
How do you replace the fuel pump 1996 GMC Sonoma 4.3L?
Easy way, is to pull bumper and unbolt bed than slide back out of the way. Fuel tank is then very easy to work on no reason to have to drop tank.
Where is the fuel pressure regulator on a 2003 gmc sonoma 2.2 liter?
on my 2001 2.2 I removed the left inner fender and tire , it is in all that mess on the left side of engine, I think it was bolter to one of the lower intake botls.
What is bolt pattern for 1994 2.2 GM Sonoma?
will the 2.2 crossmember on a 1994 GMC sonoma fit on a 1994 GMC sonoma 3.4
Where is the oil filter located on a 03 gmc sonoma?
The oil filter is in a compartment in front of the truck under bumper.