answersLogoWhite

0

GMC Vandura

The GMC Vandura, also marketed as the Chevy Van, was a full-size front-engine van manufactured by General Motors from 1971 to 1996. It was available as a 3-door van, 3+1 door wagon and 4-door van.

426 Questions

Where do I look if my 1995 GMC Vandura 2500 has a water leak?

Water Pump? Start by inspecting your hoses first it may just be a clamp.

How do you replace the Heater Core in a 1992 GMC Vandura 2500?

You disconnect the hoses. Then remove the heater core cover from the engine compartment (oblong black thing bolted to the firewall on your left hand side, looking in). Wrestle that off and extract the heater core...swap out your new core and replace it all. It is that easy. I put in a coolant flush kit while I had it apart...flush your coolant system every few months for nothing. Good luck

Where is the alternator on a 1993 GMC Vandura?

with hood open=Front left side of engine. I allways take my air intake tube off to allow more access.

How do remove and replace vent window latch on 1995 GMC Vandura?

I believe, if its like my GMC Jimmy, that the latch is connected to the vent window and has to be replaced as a whole assembly. I recently broke my vent window and got one from the local junk-yard, complete with latch. Now my problem is drilling out the rivets that hold the latch to the frame under the inside plastic, and the rivets that attach the front side (leading edge) under the weather-stripping to the inside of the door jamb.

What causes a 1991 GMC Vandura 2500 to flood out and stall while driving?

I would start with replacing the fuel filter if you haven't already done so. Then check the fuel pump.

What type of van is the gmc 2500 verdura?

The GMC 2500 Van is usually used as a work van. The Van does not column with rear seating, nor rear side windows.

1991 GMC VanDura 3500 If the master brake cylinder is leaking fluid can you replace the seal or must you replace the entire unit?

you can purchase a rebuild kit for master cylander. usually is easier and cheaper to buy replacement cylander.cylander has to come completely out of vehicle no matter which way you choose to repair it.you also need to know what you are doing if you go the rebuild it yourself way.then after repair ,the whole brake system will need bleeding When my master went on my 2500 the replacement was $40CAD, just buy a new one and save the hassle

Where is the ignition coil located on a 1990 GMC Vandura Van?

Assuming you have a distributor (my 1989 does), remove the console and doghouse, the distributor cap is the round component at the back of the engine on top that has either 7 or 9 wires on it depending on wether you have the 6 or 8 cylinder engine, the wire in the center leads to the ignition coil which should be very close to the distributor cap. I have also seen where the coil is installed on the top of the distributor cap so in this case there would not be a wire leading to it but I think this configuration is on older models.

Disconnect the battery, remove the coil and replace.

How do you replace the fuel filter on a 1994 gmc vandura 3500 small school bus?

If it's a gas engine, there's an inline fuel filter which runs alongside the frame rail. If it's the 6.5 Detroit Diesel, it's a spin on fuel filter.

What can cause ware the of the right rear tire in the inside of a 91 gmc vandura van?

maybe a wheel bearing is bad. Jack up the rear end and spin the tire in neutral and shake the tire to see if there is any play.

How many cans of freon does it take to fill a 1990 gmc vandura van with dual ac?

There should be a sticker under the hood that says refrigerant capacity in pounds and ounces.

Wiring diagrams vacuum gmc?

The wiring diagram for the vacuum system of a GMC car or truck can be found in the Chilton's manual for that vehicle. You can find those manuals at most auto parts stores.

How do you remove door panel from 93 gmc vandura?

it's held on with little barbed, plastic posts, best way to get it off is by prying it, try to pry as close as possible to the post so not to damage the panel, also I have found that using a fast prying motion as opposed to the slow prying motion also prevents damage to the panel

94chevy c1500 new 350 backfires thought the throttle body when you put it in gear?

Need to make sure the Timing is correct. Make sure the plug wires arent crossed.

Are you sure it's wired right on the cap, and the Distributor is in correct.

Need to check those things again FIRST.

Where is the fuel filter on 1988 GMC vandura?

On my 1989 it is attached to the inside of the frame just behind the rear axle, I think it's on the passenger side. It's a brass cylinder about the size of your hand and pretty easy to get at and remove.

How do you bleed brakes on a 1995 gmc vandura 2500?

Are both resivoirs supposed to have brake fluid in them? Because the container where you refill brake fluid is as full as it is supposed to be. So are you supposed to open the cap of empty resivoir and pour directly in? My brake light came on a couple weeks ago and i also have a spongy brake pedal. Thank you, Darin

How do you adjustment the idle on 1992 gmc vandura 1500?

Through the carburetor or advance or retard the distributor by turning the distributor cap barely left or right. If you cant turn it then loosen the bolt holding the distributor on to the intake with a wrench then turn the distributor til the engine sounds like its not missing or not to where it's about to turn off.

Where is the cruise control located at for a 96 ford thunderbird?

There is a relay in the FUSE BOX in the engine compartment next to the battery. The relay is the square one closest to the firewall, and closest to the drivers fender. They're about $8 at auto zone.

How do you find out if your 1992 GMC 2500 Vandura van is EFI or carburetor?

take doghouse off, remove air-cleaner lid and look down into carburetori if you see a pair of injectors with electric wires going to them, its EFI

You have broken Hood latch cable on a 1989 GMC Vandura How do you open the hood Thank you?

where your latch is broken at you can use a pair of pliers and pull the exposed cable wire and it should open best thing when u open it replace the cable wire