GMC Yukon

You need to remove the top head light by unscrewing two bolts on top if the lighting assembly. once the head light is out of the way you pull out the turn signal lamp and replace it.

The 2012 GMC Yukon is 16 ft. 10 in. (202 in.) long.

The maximum tosing capacity of the 2009 GMC Yukon-Hybrid is 6200 lbs..

The gas tank on the 2007 GMC Yukon-XL holds 31 gal..

The 2001 GMC Yukon-XL has a 10 ft. 10 in. (130 in.) wheel base.

it is located below the oil filter, and points towards the passenger side. it takes a 13mm socket or wrech to remove.

On average, a train horn is 110 db on the engine. At about 500 feet away from the train, a train horn is 90 db.

the tow-haul switch usually stops working because the wire from the switch on the shift lever is broken. this can be repaired instead of replaced. use a piece of speaker wire to repair by soldering. also put a coil in the wire so it doesn't pull against itself if you have a tilt wheel. remove the cover from the bottom of the steering column and the wire from the shift lever will be exposed so you can get to it. solder in about a six inch piece of wire so it is long enough to be able to flex.

Provided the grade and SAE of oil is that recommended by the car manufacturer and a filter change is done too, it should be OK.
I don't recommend it personally. Many have had leaks after changing over. Also, it should never be used during break in period.

2003 and newer GMC Yukon models don't have cabin filters. Check out the following link:

http://www.boschautoparts.com/NR/rdonlyres/425B1A4D-5155-4064-A5E7-E07F8DB720C7/0/CabinAirFilterInstallation.pdf

Scroll down to #25 GMC on the PDF, it has the instructions there. Good luck.

You have to pull the gauge cluster out. On the back of the gauge cluster there will be little gray bulbs that twist in, turn them to the left and pull them out. Be carefull not to break the clips on the dash while removing it, or installing it.

Buy a recharge kit from an auto parts store. This will include a charging valve/hose, and cans of freon. It's best to get a charge hose with a pressure gauge on it. Screw can onto tap end of the charging hose, turn piercing valve clockwise until it stops. Attach quick connector to the low side outlet of the AC system (this fitting is foolproof. It will only fit on the correct connector). Turn vehicle on, turn AC on MAX with fan on high. Go back to the charging hose and turn the piercing valve counter clockwise to let the freon out of the can and into the hose, into the AC system. Make sure AC clutch is cycling to ensure movement of freon into the AC system. Do not overcharge the system, or you may burst parts. Most systems only hold 2 cans worth. To achieve best results, you must evacuate the entire AC system of all freon & pressure before charging.

had the same problem on a 2003. it was a bare wire.

The total unit needs to be removed first by loosening the Philips head screw on the side of the headlight (look between the headlight and the fender with hood raised). The turn signal unit can then be slid forward which will remove it. The socket can then be removed and the bulb replaced.

Have you checked your liftgate fuse? In my 2006 Yukon, when the liftgate fuse went out the rear ac wouldn't work nor would the electric locks for the liftgate itself.

Remove two bolts that hold the brake caliper on the hub. There might be two retaining rings that fit over the wheel studs. Once these are removed, the rotor should be able to be removed. Might require a slight smack from a hammer to loosen. Just reverse the process to install.

put a flat head screw driver in between the pan and transmission there will be a gasket there but u should need to replace it aneways if its not comming off just be carefull dont want to bend pan soft allunium k

i think one of your bulbs in another light are out. mine was blinking fast only on one side, so i checked them and replaced the burned out one and it blinked normal again.

Drain the oil, remove and replace the filter. Add 4.5 quarts. Start the engine and let it run for 2 minutes. Shut it off, wait 15 minutes. Check the level and top it off. You now know.

it should be the same as any other vehicle, disconnect the battery for about 10 minutes then reconnect it

The 2010 GMC Yukon runs on flex-fuel (FFV).

Window tinting runs at several different prices. While some places my offer a set price, you have some that charge by the vehicle or how many of the windows you would like tinted. A GMC Yukon may cost around $100.

Driver side, after converter.

The EGR valve is located on the front part of the engine on a 2002 GMC Yukon XL SLT. It is in front of the area where you add oil to the car.

5W30 weight in the winter time, Castrol GTX oil is a good oil to use.