0
Honda CRX
The Honda CR-X, formerly the Honda Ballade Sports CR-X in Japan, was a small sports car built by Honda. Re-launched in 1988 and manufactured until 1991, the CRX became popular for its performance, good fuel economy and quick handling.
595 Questions
How do you replace the thermostat located on a 1989 Honda CRX?
Youve just redone the thermostat
Just a note: I had a buddy who wanted to help. so he tightened the thermostat housing and cracked it. the torque specs for my '90 was 13 ft/lbs or so. It should be around the same for the 89. Just don't reef on the housing bolts.
How do you replace the master cylinder on a 1990 Honda CRX?
Hello,
Here is a simple walk-through on replacing the master cylinder on a '90 CRX:
Disconnect the negative battery cable and disable the SRS system (if equipped.) At the top of the clutch pedal, remove the cotter pin and pull the pedal pin out of the yoke.
Remove the nuts and bolts holding the clutch master cylinder and remove the cylinder from the engine compartment.
Disconnect and plug the hydraulic lines from the master cylinder.
Installation is the reverse of the removal procedure. Bleed the clutch hydraulic system.
How do you replace the license plate bulb on a 2004 Honda cr-v?
how to replace the license plate bulb on a 2004 Honda cr-v
Is Honda 89 crx 1.6 dohc engine interference?
yes it is, if you broke the timing belt there is about a 90% chance you bent a valve
Does a Honda crx have clutch fluid?
The Honda CRX features a cable type clutch and therefore does not have fluid. The CRX Del Sol however features a hydraulic assembly and does.
Will a 1988 Honda CRX motor fit a 1987 crx?
Yes with a little bit of you work. go to Honda-tech.com you can find every thing you want to no there.
Where is the main relay Honda CRX del sol?
Under the dash, drivers side by the fuses. Held on by screw?
Does it ruin the engine if a timing belt breaks while driving a 1988 Honda CRX si?
Yes, It will. HF and the Si versions are interference type motors! It won't kill your entire engine but you will have too rebuild the head because of the bent valves!!!
How do you know if a head gasket is blown on a 1991 Chevy cavalier?
check engine oil for water and check radiator for oil
What is the correct 1991 Crx head torque specification and sequence?
hondahookup.com has manuals u can download with the info u need
Can you put a Honda type r engine in a Honda CRX?
Yes they are fairly easy to bolt in with the required parts and knowledge.
If you research enough online then you will find out it is not too hard.
How are crx si engine cylinder sleeves removed?
To remove the cylinder sleeves from a CRX Si engine, first, the engine must be disassembled, including removing the cylinder head and other components. Once access to the cylinders is achieved, the sleeves can be pulled out using a sleeve puller or a similar tool, applying even pressure to avoid damage. It's important to heat the block gently to expand the metal, which may help in loosening the sleeves. Finally, ensure all surfaces are clean and free of debris before installing new sleeves.
How do you adjust the clutch on a 1985 Honda CRX?
To adjust the clutch on a 1985 Honda CRX, first locate the clutch cable adjuster near the firewall. Loosen the lock nut and turn the adjuster to either tighten or loosen the cable tension, ensuring there’s about 0.5 to 1 inch of free play at the pedal. After adjusting, tighten the lock nut and test the clutch operation to ensure smooth engagement. If necessary, repeat the adjustment for optimal performance.
Firing order of spark plug wiring for 1990 Honda CRX?
The firing order for the 1990 Honda CRX, which is equipped with a 1.6L engine, is 1-3-4-2. This means that the spark plugs should be wired in the sequence of cylinder 1, followed by cylinder 3, then cylinder 4, and finally cylinder 2. Ensure the ignition coil is connected properly to maintain the correct firing sequence for optimal engine performance.
Where is the radiator fill cap located on an 82 gl1100 Honda goldwing-interstate?
On the 1982 Honda Gold Wing GL1100 Interstate, the radiator fill cap is located on the top of the radiator, which is situated at the front of the engine. To access it, you may need to remove the front fairing or side panels, depending on your model's specific configuration. Always ensure the engine is cool before opening the cap to prevent burns from hot coolant.
How do you make my 1986 Honda CRX faster?
To make your 1986 Honda CRX faster, consider upgrading the engine with performance parts such as a cold air intake, a high-performance exhaust system, and a larger throttle body to improve airflow. Additionally, tuning the ECU can optimize fuel delivery and ignition timing. Reducing weight by removing unnecessary components and upgrading to lightweight wheels can also enhance acceleration and handling. Lastly, consider installing performance suspension components for better traction and stability.
What year was the first year that the Honda CRX was available in the US?
The Honda CRX was first available in the United States in 1984. It was introduced as a sporty, compact hatchback and quickly gained popularity for its fuel efficiency and fun driving experience. The CRX was part of Honda's Civic lineup and continued to be produced until 1991.
2002 trailblazer Battery Died Now Car Will Crank But Wont Start?
If your 2002 Trailblazer cranks but won't start after the battery died, it could be due to several issues. First, check if the fuel pump is functioning and whether there's fuel in the tank. Additionally, inspect the fuses and relays related to the ignition and fuel systems, as they may have been affected by the battery issue. Finally, ensure that the battery is fully charged and that the connections are clean and secure.
