0
Jeep Cherokee Laredo
The Jeep Cherokee Laredo was manufactured from 1985 to 1992 as a full-size SUV. Its earlier models had a 2.5-liter engine while the four-liter engine came out after 1987. It was designed primarily for the North American market.
1,043 Questions
What can you do to supe up your 95 jeep grand cheroke Laredo?
You can add ground effects or new and larger tires to soup up your 1995 Grand Cherokee Laredo. You can also add grill or headlight covers, a chip to give your engine more horsepower, or even a lift kit to this vehicle.
Where is the diagnostic port located in a 1988 jeep?
By your knee under the steering column.... right hand side if your driving the RH steering version
Where is the fuse to your headlights for your 1997 Jeep Grand Cherokee Laredo?
Most headlights are not fused they are wired direct thru the headlight switch... Is your switch bad??
Will a transmission out of a 1994 Thunderbird 4.6 v8 fit in a 1995 Thunderbird 4.6 v8?
yes it will they are just a year apart they are for the same motor but you can always call your local shop to find out for sure.
On a 1991 Chevrolet what would cause brake lights to remain on when car is switched off?
Check the brake switch located on your brake pedal shaft. May have to be replaced.
How do you fix a plugged ac drain line on passenger side floor of 1997 jeep grand Cherokee?
The drain is inside the frame of the Jeep. The only way to clear the drain is to drill a hole from the inside. I was lucky, in my used '97 jeep someone had already done it and I just had to remove the screw and use a piece of coat hanger to clear the line. Pull back the carpet on the passenger side front under the dashboard. the drain is behind the center of the round plastic drain. Be prepared with something to catch the water after you drill. It will all come spilling out. Slide the straight length of coat hanger in the hole and it should clear the line. If it works the backed up water will start pouring out of the frame at the front of the Jeep. Use a screw with a large head and some caulk to close the hole. What a stupid design. I will never ever own another Jeep. I had the same problem with my 95 GJC, I couldn't get the wire to clear the clog. I used the same procedure and used an air compressor, 150psi, with a blow gun to clear the clog. I have found I need to do this about every other year. Hope this helps.
Be sure to push the wire straight through towards the firewall. If you push up at an angle you will enter the drain channels ahead of the clog and not clear the drain. Push straight through and it will have a better chance of getting to the clog. ANSWER
This is a very common problem that has resulted from typically poor engineering. On traditional vehicles the AC condensor box drains to the ground via a black rubber tube. Because the condensor pulls nasty air out of the passenger compartment in the form of humid, dirty air the condensor box gets full of really dirty stuff which clogs up the drain hole. Because the Jeep is a unibody the condensate (dirty water) drains into a frame member which denies access to blow the hose out when it gets clogged with "mung" (the official word for nasty pasty smelly stuff). Yes, you can do as others have suggested and drill a hole in the bottom of the evaporator box and hope for the best but this is not fixing a problem but rather putting off the inevitable: pulling the dash completely out in order to clean the evaporator box and replace the styrofoam liner inside the box. Be aware that if you decide to do this repair down and dirty with a drill there is also the heater core in that box and if you puncture it you're really screwed. Because the correct repair will cost you over $1500.00 at an AC repair shop it might be best to consider the economics of keeping this vehicle and then the ethics of selling it to some unaware schmuck during the non-AC season. There are some really good in-depth postings about this issue, several by me, here in Wiki that address this issue technically and without snarky remarks. Check out the archives.
The window brake light on your Mitsubishi Galant ES stays on after your car is turned off?
try turning the switch off
Why would the tail lights of 2003 Mercury Mountaineer stay on after car is shut off?
I've had that happen on my 02 moutianeer. I got back in and hit the brake and it went out. You could have one of the sockets on your back lights burning out. THat includes the the top tail light also.
What transmissions are interchangable for a 1997 Grand Cherokee Laredo V8?
No transmissions are interchangable in this model.
Where is the input speed sensor on a 2008 Jeep Cherokee Laredo?
in the valve body which is inside the transmission.
Why don't the fog lights work on a 1999 Jeep Cherokee Sport?
i had the same problem with my jeep. it ended up being the switch, but there are many other problems that can cause your fog lights to not operate properly. check first to make sure they are not burnt out. then i'd check all your connectors to make sure there is no corrosion and that they are making good contact. next step is to put a meter on it and see if you are getting power to the lights. if not you've obviously got an open or a short in your wiring somewhere. check for a broken wire, faulty switch, etc.
How do you manually retrieve fault codes on a 1993 Jeep Grand Cherokee Laredo?
Turn key to off-on-off-on-off-on within 5 seconds and watch the odometer. It will display all of the codes flash "end" at the completion. A 1993 will flash the check engine light in two digit code numbers. The odometer trick didn't start until about 2001.
How do you change the pcm in a 1997 Jeep Cherokee Laredo?
the pcm is located under the hood on the driver side inner fender, you can recognize it by all the wires connected to it and a little vented cover over it, disconnect the battery completely, then while the battery is disconnected try to start the vehicle to drain the system of any remaining electricity, disconnect all the connecters, unbolt the pcm and replace it with the other one. reinstall in the reverse order
How can you fix a broken heater in a Jeep Grand Cherokee or Laredo?
The HeaterTreater is an after market kit that solves heater and AC blend door malfunctions for the Jeep Grand Cherokee and Laredo. It is much cheaper than the dealership fix and is easy to install. For diagnosis and info, check out www.heatertreater.net or search eBay for "heatertreater".
What is the best oil viscosity for a 1989 Jeep Cherokee Laredo?
The best oil viscosity for a 1989 Jeep Cherokee Laredo is 10w-30. This type of oil is designed to give a good balance of lubrication and protection.
Do you have to have the driver door closed for windows to go down in a jeep grand Cherokee Laredo?
No. If this is a 1999-2004 model you may have partially broken wires in the harness going to the driver side door.
No. If this is a 1999-2004 model you may have partially broken wires in the harness going to the driver side door.
Is there a trick to putting a Jeep Cherokee in 4-wheel drive?
Shift to 4-wheel drive on the go and let off accelerator for a few seconds and go back on the accelerator and it will shift in about 5-10 seconds ..
What is the firing order of the 1996 Jeep Grand Cherokee Laredo 4.0L L6 FI engine?
Cylinder order front to back is 1-2-3-4-5-6. Firing order aka the order in which the plug wires are connected to the cap on the distributor in clockwise rotation/order is 1-5-3-6-2-4. Begin by verifying on the "compression stroke" by removing #1 plug and stick finger to the hole and feel for outbound pressure or compression stroke. Check the timing marks on the harmonic balancer once the piston reaches max height in the cylinder for indicating Top Dead Center (TDC or ZERO). Remove the distributor cap slowly and just enough so as to see which wire or post the rotor is pointing at. Make a tick mark with a marker on the cap at that wire indicating it should be the #1 wire position. From there in a clockwise rotation the subsequent plugs wires should be connected starting with the #1 cylinder plug wire, followed in "clockwise" order by the #5, then #3, then #6, then #2 ending with #4. Of course there's the coil wire as well in the middle.
Barring the distributor having been R/R wrong this should do it. The computer will adjust timing automatically. Always replace each pluig/wire one by one. Mark the cap's #1 wire position for future reference....Good luck!
What is the maximum trailer weight of 1992 Jeep Cherokee Laredo?
YOU CAN GO TO WWW.KBB.COM (KELLY BLUE BOOK) & PUT IN YOUR VEHICLE INFO LIKE YOU ARE RESEARCHING IT. WHEN IT FINALLY TELLS YOU THE VALUE OF YOUR VEHICLE GO TO VEHICLE SPECIFICATIONS ON THE LEFT SIDE OF THE PAGE. THEN GO TO TECHNICAL SPECS & IT WILL TELL YOU IT'S MAX. TOW.
The engine will turn over with spark or no spark. Your's turns over I assume and has no spark. Check the coil pak. or ign. module if equipped.
Out of adjustment. Adjust the mounting of the switch so the brakes lights are off until you press the brake pedal.
Where is ecm located on 98 Jeep Grand Cherokee Laredo?
pasenger side on rear fire wall three wire clips silver box looks like computer
How do you adjust the TPS on 2002 Jeep Grand Cherokee Laredo 4.0L with automatic transmission?
You don't adjust it. You buy a new one and replace it.
