0
Jeep Liberty
Also known as the Cherokee, the Liberty is a compact sport utility vehicle (SUV) manufactured by Chrysler for its Jeep division. Manufactured since 2001, this 4-door SUV is available in four-wheel drive (4WD) and rear-wheel drive (RWD) layouts.
1,621 Questions
What kind of oil is used in the 2002 Jeep Liberty axles and transfer case?
axles ue 75w90
t-case uses ATF
Where is the Iat sensor in my 2007 liberty?
The IAT sensor is usually located within the air cleaner. Use the owner's manual to learn how to locate the airÊcleaner and any other part.
Where is the oil filter located on a 2001 Jeep Liberty 3.7 L?
you must mean a 2002 Jeep Liberty, but it's on the right hand side as you face the engine with the hood up. look down between the drive belt, and it's behind the belt.
You need to replace the blower motor resistor. It is a circuit that uses different resistors for different speeds. They routinely burn out....
How do you disable the alarm without the remote key on a jeep liberty?
If you no longer have the remote key you will need a transponder (chip) key. You can get one from the dealer, or there are some other places that sell them. You will have to use that key in the Drivers door to unlock the door and this will disarm the alarm.
Where is the CD fuse on a Jeep Liberty?
Not indicated on the fuse panel, may be powered by the body control module.
Fuse Panel Description
- 1 15 Amp Blue Horn Relay, Power Sunroof Relay, Power Window Relay
- 2 10 Amp Red Rear Fog Lights (Export Only)
- 3 20 Amp Yellow Cigar Lighter
- 4 10 Amp Red Headlight Low Beam Right
- 5 10 Amp Red Headlight Low Beam Left
- 6 20 Amp Yellow Body Control Module/Power Door Locks
- 7 10 Amp Red Left Park Light/Left Tail Lamp/License Plate Lamp
- 8 Spare
- 9 10 Amp Red Right Park Light/RightTail Lamp/License Plate Lamp/ Cluster
- 10 Spare
- 11 15 Amp Blue Flasher
- 12 15 Amp Blue Stop Lights
- 13 10 Amp Red Body Control Module/ CMTC/Cluster/Pass. Airbag On,Off Indicator, Auto Daylight Mirror/Light Bar Switch (Renegade Only)
- 14 10 Amp Red PDC Fuel Pump/AC Clutch, Starter Relay/Engine Controller/Transmission Controller (Diesel Only)
- 15 Spare
- 16 20 Amp Yellow Power Outlet (Rear)
- 17 15 Amp Blue Rear Wiper
The fuse panel diagram is in your owners manual, if you don't have one, go to Jeep.com and download it for free.
How do you remove gas tank on 2004 jeep liberty limited?
To remove the gas tank on the 2004 Jeep Liberty Unlimited, you will begin by draining the tank completely. Remove the battery cables from the vehicle so that there is no chance of spark. Then, remove the gas tank straps from below the vehicle.
How do you remove floor console in 2002 liberty?
Start with the silver cover in the center by the shifter, it pops off by hand. Unbutton the boot for the four wheel drive shifter, remove the screw that is hidden and the whole boot comes off, remove power window assembly in the front from the front, a small screwdriver will help- wiggle it back through the entire plastic assembly. the rear power window assembly will get unplugged and the cover in the front. Now there are a few screws left to remove, two under the CD storage area and one by the shifter that are easily visable. After this your ready to pull up from the back seat area and get the entire console to come up and out- it may require shifting the four wheel drive gearshift and pulling up on the emergency brake- after some working it will come out.
How do you put a 2005 Jeep Liberty into 4 wheel drive?
You pull the transfer case level towards you....
Code 41-Charging system circuit, check the alternator and wiring. The engine computer is also the voltage regulator.
Not sure where PCV valve is on Jeep Liberty, but it is usually located on the valve cover. It is recongizable by the hose that connects to it. Most PCV valves just slide out when pulled and are replaced the same way. PCV valves are not expensive and esasy to replace. Dealership probably asking $45 for parts + labor. Cheaper if you do it yourself.
The PVC valve is located on the side of the oil filler cap (where you add oil). Just pull the rubber hose off the back of it and turn it counter-clockwise to the six o'clock poition. Pull it out. They seem to get sticky even though you change your oil on time. Spray it out with carburetor cleaner and shake it out. The steel ball in there should move back and forth as free from grim as possible.
Trouble code P0700 means:Transmission control system malfunction
Firing power diagram for 2005 Jeep Liberty 3.7 liter?
dodge ram engine diagram The 2006 Dodge RAM 3.7 liter (226 CID) six-cylinder ... The firing order is 1-6-5-4-3-2. The engine serial number is located at the right ...
DIAGRAM IS HERE: http://landcruiser.grundahl.ca/Toyota%20Manual/L%20L2%20L2-T%20Service%20Manual/Toyota%202LT-%2006%20Starting%20System.pdf
How many miles per gallon does a 2007 Jeep Liberty get?
15 city
20 highway.. but 21 if you dont have 4 wheel drive
The computer thinks the liftgate is open.
When you replace the a/c compressor did you also change out the receiver drier as well ?
To recharge the a/c system the cost would be in the area of around $125.00 dollars if it was done by a professional a/c shop.
How do you know if it is the water pump or thermostat going bad in a 2004 jeep liberty limited?
It would help if you said what the problem is. - Thermostats usually either work or don't. If they don't it takes a long time for the engine to get warm, -this has nothing to do with the water pump.
Water pumps sometimes leak, you lose water and can see this in the rad. -there is no repair, -you change it for a new one. -This problem has no similarity to any thermostat problems.
What are the largest tires you can get on a Jeep Liberty?
20" tires are the largest tires for your car if you of course don't have any lift kits..
Quoth http://www.aa1car.com/trouble-codes/page3.htm :
"THROTTLE POSITION TROUBLE SENSOR (TPS) CODES
These include P0120, P01210, P0122, P0123, P0124 P0222, P0223, P0224, P0225, P0226, P0227, P0228 & P0229, and can be set if the TPS sensor readings are too high or too low (out of range), if the signal is lost, or if the signal does not correspond to the MAP sensor's readings. The TPS sensor monitors the position of the throttle so the computer can add more fuel when the engine is accelerating or under load. The computer may also need to know when the throttle is at idle or wide open to control other functions. A bad TPS can cause driveability problems such as hesitation. The sensor's resistance changes as the throttle moves, causing the return voltage signal to vary. Look for a change in the voltage output as the throttle opens and closes. No change or skips in the output would indicate a faulty TPS sensor. Also note: the idle voltage is adjustable on some TPS sensors and must be set within specifications for accurate operation. If the voltage adjustment is not within specifications, it can adversely affect performance and throttle response."
