Jeep Wrangler Sahara

She may b too heavy. Read your owner's manual and find out. if it is supposed to cut off, contact the dealer.

DOT 3

32rh

No sequence really.

Just use common sense, drivers side front is the shortest, so go with it first, then do the other front.

same for the back drivers side is shortest, then do the passengers side.

This way you won't leave any bubbles upstream of the last cylinder.

The AX5 5speed works nicely.

actually it will fit with some cutting and drilling. in about 30 minutes i had a yj top on my tj with a good seal.

The 2001 Jeep Wrangler has an inline 4 engine.

1. Adjust radio to desired station
2. Press set button twice
3. Press pre-set button desired for that station.

Yes that should fit.

Open the door, removed the limiting strap on the inside that prevents the door from opening too far. Remove the nuts on the bottom of both hinges of the door. Then the door can be lifted off the hinges. Note that its surprisingly heavy, about 50 pounds as I recall.

According to the factory manual for a YJ the toe-in is set at the following: 1/16 in or 1/16 out Cheers

Sorry but your question does not contain enough information to be answered. Ohms are a measurement of electrical resistance. Please specify the electrical component that you wish to know the Resistance of.

Most likely your crankshaft position sensor. Starts out fine, then dies after 30 mins or so? Sit for 30, then ok? 40 bucks autozone

Pretty easy, there are holes inside and in the back of the flare that match up with holes in the steel fender, mounting hardware is screws from inside the fender to plastic nuts inside the flare, but any nut and bolt that will fit through the hole will work, you may need washers on the flare side though.

I do not believe that will work, the jeep body changed quite a bit between those years.

All fuses are under the hood.

The steal plow was an important invention because it made farming in the Midwest easier. The soil there was sticky compared to the light and sandy soil of New England. John Deere made the first steal plow. Steal is a high polished material that essentially cleans itself as it cuts through the soil. This invention opened up the west for wide scale agricultural development: hence the more rapid and residential development expansion west.

J. Ode

Cycle ignition on, off, on, off, on and count the flashes of the check engine light. Two flashes, pause, two flashes would be code 22. Code 55 is end of message. When you get the codes you can ask a new question about the specific code number.

5 quarts 5w20

Newer model S-10's have two lower tabs that must be positioned in the slots. You can then push them back and the upper tabs project through the upper holes where you slide the keepers in place to hold the lights. Not aligning the lower tabs in the slots can result in your lights bouncing around and becoming misaligned again. Eventually they will settle down and an adjustment will hold but make take a few road trips.

Now that they are seated correctly, you can see one torx head internal and external ( internal / external = there is a female slot in the bolt for a torx bit as well as the outside of the screw being torx for a torx socket ) sticking out on the top of the headlight assembly for the Up/Down adjustment. Looking down through a hole in the frame above the light assembly you can see the Left/Right adjustment screw.

See Sources and Related Links below for bulb information.

The spare tire is mounted on the outside of the back door

no you cant you have to pull the transmission out(all the way out) to get to the slave cylinder theres no way around it sorry. i have a 95 cavalier myself and ive changed it twice. hope this helps

Do you mean the spark plugs are not producing spark? Or do you mean the engine turns over but does not start?

Check battery terminals, fuses, and the starter. I had this problem on my 98 wrangler. it was the starter selinoid. 1. get under your jeep 2. located the starter(passenger side on the side on the transmission near the engine block) 3. tap it with a wrench or a hammer(don't bang on it, just a solid tap) while someone tries to crank it. If it starts its your starter assembly. They are about $150-$200

It should. A 2005 wrangler hardtop fits a 1997 wrangler.

Yes, they both have the same 5x4.5 bolt pattern.