answersLogoWhite

0

Lincoln Mark VII

The Lincoln Mark VII is a rear-wheel drive luxury car manufactured by Ford from 1984 to 1992. It was offered in a two-door coupe body style, equipped with a four-speed automatic transmission and 108.5-inch (2,756 millimeter) wheelbase.

421 Questions

Where is the fuel pump located on a 1998 Lincoln mark 8?

inside the gas tank,to r&r the fuel pump the gas tank must first be removed.

How do you reset the air bag light on a 1990 Lincoln Mark VII?

Lincoln Mark VII Safety Air Bags need to be serviced by a professinal. Do NOT take chances with this. In the trunk left side ahead of the spare tire make sure the switch is turned on if it is and light is on you have an issue with one or more of the airsprings.

ha ha ha there you go again with the air springs! well i agree, if you are talking about air bag as in in the steering wheel etc, sure have it looked at by a pro, if your talking about air springs, and air ride issues, don't nessicarily listen to this guy, keep researching and you will figure out your air ride problem, any questions ask me, cllass@alloymail.com

If you have an "Airbag" light on on the instrument cluster where the speed o is it needs to be scanned by a pro... It probably was at one time in an accident and the bag deployed, they replaced the bag and didn't have it reset by a pro... It takes a special computer to do this and they usually charge a lot of money... I remember my days working in a body shop and we usually had to have this guy come out if the light stayed on he would charge us $60 and I'm pretty sure the ins co would pay us about $75? Now if it is the "Check Air Ride Suspension" light on the overhead cons it needs to be scanned also to see where to look for problems?

Door panel dis asembly for a Lincoln mark 7?

An Interior Door trim tool such as ( Lisle 3 piece body trim tool set 00947320000 | Model# 35440) ) that can be picked up at SEARS for about 25 bucks. Will make the disassembly a lot easier. Make sure to pick up the door clips that can be located at Autozone, Checker Auto Ect... | Sears Item# 00947320000 | Model# 35440)

How do you convert my 91 Lincoln mark 7 to coil springs from air springs?

I wouldn't recommend it. The ride quality is worse the springs are noisy and it is much easier and cheaper to replace the air springs with new air springs. You can replace all 4 airsprings in a couple hours or less. Message me and I can recommend someone who can install them for you if you don't want to tackle it. Hope this helps

Mark VII Heaven

Different strokes for different folks. When my 95 LTC air springs failed, a shop said the problem was the computer control (I think their diagnosis was wrong), and they quoted $1500 to replace the computer...when I asked what if I actually needed new bags (and possibly a compressor, as I've read compressors will burn out if leaking air bags are not promptly attended to), the shop quoted about $2200.

Instead I purchased a coil spring w/heavy duty shocks kit over the internet, and due to general laziness and lack of time paid a shop to install the kit. All told I was out about $600, and took care of bypassing the idiot light about the air suspension on my own.

Three years later, I am VERY happy with my maintenance free no hassle standard coil spring suspension. Not noisy. Not squeaky. Yes the ride is marginally different...it took me all of my 7 mile drive home from the shop to get acclimated to the springs.

Downside? If I put a couple 200+ pound adults in the back seat the ride will not auto-level. I can live with that!

So while Mark VII Heaven may not be pleased with the swap-out, as is his right, others such as me found it to be a suitable economical alternative to that of keeping the air...

Paul I-guess-that-makes-me-LTC-purgatory.

What would cause a 1988 mark vii LSC not to shift in to overdrive?

either the od is burnt out and needs to be replaced or the plastic grommet under the throttle plate is bad. this grommet connects your tv cable to your throttle linkage. the last alternative is that the hard bar(input shaft) is broken. if that is the case, then it will shift from 1-3rd and when it tries od, it feels like its going into neutral

Where is the air condition filter on a Lincoln mark vii?

sorry there is no filter on the mk vii. but ther is a orifice tube with a screen pressed in the liquid line it kina acts like a filter and a expansion valve

Will the rack and pinion steering system cause the rotors to warp or cause a shudder while braking?

Rack and pinion steering will not cause warped rotors. The tie rods, which are part of the system, can cause a vibration if the bushings on the ends are worn out. Warped rotors will do the same thing, and this will show up when applying the brakes.

How do you install heater core in 88 Lincoln mark 7 lsc?

you must remove the steering column and dash board and disconnect the a/c and heater hoses from the firewall. it might help if you remove the upper intake to provide you easier access/but the dash has to be completely removed. hope this is helpful

Where is the horn located 1999 Lincoln continental?

driver side front fenderwell. Remove the wheel and tire and remove the inner fender

How do you remove the alternator from a Lincoln mark vii?

as with any alternator remove the bolts holding it to the engine then it should come off easily of course removing the belt is recommended. then either replace or service the alternator. On older marks an easy way to check the alternator just hold a screwdrivers tip to the rear center of the alternator, if it sticks the alternator works. if it doesn't replace it

How do you bleed air out of pipes?

In a boiler system you raise the static pressure via the fill valve to 25 psi (on a 30 psi system) and circulate the fluid. If there are air eliminators in the system, you would crack them to allow the air to escape.

How do you convert anti-lock brakes to regular brakes on a 1990 Lincoln Mark VII?

you need to take off the master cylinder and the accumulator and replace it with a master cylinder from a non antilock vehicle like a thunderbird or cougar from about 1985 to 1988.

Where is heater blend door actuator on 88 Lincoln mark vii?

it is behind glove box and yes the dash must be pulled sorry. it is in the heater box betweenthe heater core and a/c evaporator book time is 11 hrs i know guys who complete the job in four but be prepped to replace heater core and maybe evap if signs of leaks are present and age heat box was revised because hinge pin would brake of blend flapper plastic door

How do you adjust the ride height on your Lincoln mark 7?

The front suspension ride height or C dimension is adjusted be moving the front LH and or RH lower sensor attaching stud. (There are 3 adjustment positions provided on the bracket.) Loosen the attaching screw and adjust up or down as required. One position change will yield approximately 12.7 mm (.5 inch) change (up or down) to the C dimension.

How do you remove the front air springs on 1988 Lincoln lsc mark 7?

Replacing the front airsprings or any of the airsprings is actually very easy. First off turn off the suspension switch in the trunk behind the spare tire.Next remove the wheels .Below airspring remove retaining clip by sliding forward. On the top of the airspring there is an electrical plug in the airspring solenoid remove that next. NOW THIS IS VERY IMPORTANT turn the solenoid counterclockwise ABOUT A QUARTER INCH ONLY TILL IT CLICKS INTO THE FIRST SLOT and air remaining in the airspring is expelled If you turn it too much the solenoid could pop out and hurt you or cause damage BE CAREFUL!!! Now once air is expelled completely you need to turn the solenoid another turn till it comes out the upper slot Now you can remove the airline by pushing down the coller on line and pulling line out.Now release metal clip on airbag by pushing down once done you can turn airspring to remove. Install front wheels lower slightly till tires touch ground but don't put all weight on springs. Turn on suspension switch put charger on battery and turn ignition on dont remove jack till springs are completely filled

How do you bleed brakes on 1987 Lincoln mark VII?

same way as non abs start from the furthest wheel from master cylinder which is r/rear then l/rear the r/ front then/l front make sure car is running because it has a electric brake booster,bleed until no more air and cleen fliud come from each wheel of order I described

Is a 1991 Lincoln mark 7 lsc special rare in all black black rims leather the car itself and what are the production for it?

The Special Edition LSC was available in 1990, 1991, and 1992. The Special Edition packaged consisted of a monochromatic paint treatment which covered bumpers, window trim, mirrors, door handles and tailight trim and Special Edition badges. In 1990 the Special Edition could be ordered in black, red or grey. In 1991 and 1992 only black and red were available. Black was probably the most popular Special Edition color and is the most sought after by collectors today.

Fuel pump relay location Lincoln Mark VII 1988?

where is the starter relay located on a 1990 Lincoln mark 7

How do you reset air bag light on golf mark 3?

That depends on the circumstance.

If the airbag was deployed in an accident a new will need to be installed and the light reset by a factory computer.

If has come on for no obvious reason then the problem will need to be addressed such as seat belt switch or the air bag itself and the light will go out on it's own.

Having the code read by a computer loaded with the enhanced Honda obd set up will tell you a whole lot more. Messing around with the air bag system is dangerous and should only be attempted by an authorized technician