Mazda 6

Yes, the fuse for the rear wiper on a 2007 Mazda 6 TS is separate from the fuses for other components. You can find it in the fuse box, typically located under the dashboard or in the engine compartment. It's important to consult the owner's manual for the exact location and specifications of the fuse to ensure proper identification and replacement if necessary.

The body control module (BCM) on a 2004 Mazda 6 is typically located under the dashboard on the driver's side. It is usually mounted near the steering column or behind the fuse box. To access it, you may need to remove some panels or covers. Always consult the vehicle's service manual for specific instructions and safety precautions.

To reset the maintenance light on a 2010 Mazda 6, turn the ignition to the "ON" position without starting the engine. Press the gas pedal three times within five seconds. After that, turn the ignition off and then start the engine to ensure the maintenance light is reset. If the light remains on, repeat the process.

To reset the immobilizer on a 2003 Mazda 6, first, ensure you have the working key for the vehicle. Insert the key into the ignition and turn it to the "On" position without starting the engine. Leave it in the "On" position for about 10 minutes until the security light turns off, then turn the key to the "Off" position and repeat the process two more times. Finally, turn the key to the "Start" position to start the engine. If the issue persists, consult your owner's manual or a professional mechanic.

You might have Mazda 6 starting problems because your battery is bad or because you have a damaged starter. You might also have problems if you have no gas in the vehicle.

no

It is different for every car and usually involves disassembling the dash to some extent

There is a button in the glove compartment that disables the remote releases for the trunk. I would check there first.