Mitsubishi Eclipse

I would check the relay, and the turn signal switch. Take off the upper and lower covers on the steering column, disconect the connector that goes to the switch on the left side of the seering wheel, remove the two screws, and pull the switch out. The relay is located under your stereo.

If you mean trunk gate lifters then the answer is yes. You can get more durable ones for less money from brand called "Strong arm" or something like that.

A 2005 Mitsubishi eclipse have 210 hp in the gt model

jack it up, check the bottom of the tranny and find the bolt, unscrew it, drain, pour in new fluid from the top into the pipe(reservoir)

You can try the EDZ 2.4l

under the hood of the car

It is in the fire wall behind the heater box.

Fill it through the dip stick spout using a special long tube funnel you can get at any auto parts store.

Usually you are not supposed to reprogram anything. Just connect the battery and drive the car, it will take about 100-250 miles for ECU to relearn sensors.

On the back of the light when u lift the hood you'll see a rubber boot on the back, reach inside the boot and release the metal latch holding the bulb in place. Good Luck

Horns generally can not be repaired but replaced. On a 2001 Mitsubishi Eclipse the horn is located inside the front bumper. To replace it disconnect the mounting bolts and remove it. Replace with a new horn.

you dont have a distributor cause it is electronically distributed wich means that the computer does it

If you do not reach the read zone in your RPM scale, you are fine. Just make sure that you are using a good coolant and thermostat.

I would even use low opening temperature thermostat if you like to drive with high RPMs often.

If there is a hole: top. Temperature sensor bulb goes towards the engine.

A size 86 is stock but a size 26 battery will fit.

We have a 2000, and all you need to do is push the radio channel buttons underneath the screen of your radio. When you do this, the blanks will turn to numbers in ascending order. Just push the button until your code is up, then hit the AM/FM button. You should be ready to go.

its in the distributor 2 screws hold the cap on then pull the rotor again 2 screws the electrical connection going into the distributor is the cam position sensor, its held in with 2 more screws. turn the engine over until it lines up so u can get it out and ur done! about a 20 minute job.

I think it has 222hp for the non turbo.

160 turbo models have 210

You have to pop off the door panel which to do so you go aound the edge of the interior of the door and pull cause its on clips and when it comes off you simply unscrew and unplug the old speakers and screw in and plug in the new ones and when you put the door panel back on you have to hit it with the palm of your hand firmly

No, it will not.

If you have upgraded turbo and fuel injectors, the motor is trying to start with too much gas pumping; it just needs more spark.

Cooling fan not functional/low coolant/bad thermostat. Start there.

Look in a removable housing at the engine end of the upper radiator hose

ok..i have a 2000 eclipse v6 my thermostat was located..look the bottom hose of the radiator follow that hose that goes to your engine it should be there ..kkkk..