Where is the thermostat located on a 1993 Mitsubishi Eclipse 1.8L?
Follow the upper radiator hose to the engine to find the thermostat cover.
How do you tell if your synchros are bad in your transmission in a 1996 Mitsubishi eclipse?
It would be hard to get into gear and would make grinding noises when shifting.
Why wont your Mitsubishi eclipse start after the check engine light came on?
The computer doesn't allow to start the engine. Check the error code.
Timing belt broke on 1997 GST How much damage?
i can answer this question with one word...
allot.
Answeryou could have bent some valves but you really don't now until you open it upIt really just depends... More than likely you bent most/all of the valves, and any valves that did bend will more than likely tear the valve guides up getting them out, also you more than likely will have to replace the valve stem seals. Not that big of a job, I had all of my exhaust valves burned and had to replace them in my eclipse spyder and I was able to do it all my self, and lap the valves in. The tricky part is putting the timing belt back on and bolting the engine head back on and setting the timing.
I would check the relay, and the turn signal switch. Take off the upper and lower covers on the steering column, disconect the connector that goes to the switch on the left side of the seering wheel, remove the two screws, and pull the switch out. The relay is located under your stereo.
Can lifters be replace on a 01 eclipse gt?
If you mean trunk gate lifters then the answer is yes. You can get more durable ones for less money from brand called "Strong arm" or something like that.
How much horsepower does the 2005 Mitsubishi eclipse?
A 2005 Mitsubishi eclipse have 210 hp in the gt model
How do you change the transmission fluid on your 1996 Mitsubishi Eclipse?
jack it up, check the bottom of the tranny and find the bolt, unscrew it, drain, pour in new fluid from the top into the pipe(reservoir)
Is cylinder 1 on 2000 Mitsubishi Eclipse 4-cylinder on the right or left side of car?
under the hood of the car
How do you add transmission fluid to a 2003 Mitsubishi Eclipse?
Fill it through the dip stick spout using a special long tube funnel you can get at any auto parts store.
Do you have to reprogram 2001 eclipse after changing battery?
Usually you are not supposed to reprogram anything. Just connect the battery and drive the car, it will take about 100-250 miles for ECU to relearn sensors.
How do you replace a headlight bulb on a 2000 eclipse?
On the back of the light when u lift the hood you'll see a rubber boot on the back, reach inside the boot and release the metal latch holding the bulb in place. Good Luck
How do you fix the horn on a 2001 Mitsubishi Eclipse GS?
Horns generally can not be repaired but replaced. On a 2001 Mitsubishi Eclipse the horn is located inside the front bumper. To replace it disconnect the mounting bolts and remove it. Replace with a new horn.
Where is the distributor cap on 2002 Mitsubishi eclipse?
you dont have a distributor cause it is electronically distributed wich means that the computer does it
Are high RPMs bad for 2000 eclipse gt?
If you do not reach the read zone in your RPM scale, you are fine. Just make sure that you are using a good coolant and thermostat.
I would even use low opening temperature thermostat if you like to drive with high RPMs often.
What is the correct way to install the thermostat on 2001 Mitsubishi eclipse?
If there is a hole: top. Temperature sensor bulb goes towards the engine.
What kind of car battery does a 2003 Mitsubishi Eclipse require?
A size 86 is stock but a size 26 battery will fit.
How do you put the anti-theft code in the stereo on a 1999 Montero Sport Limited?
We have a 2000, and all you need to do is push the radio channel buttons underneath the screen of your radio. When you do this, the blanks will turn to numbers in ascending order. Just push the button until your code is up, then hit the AM/FM button. You should be ready to go.
How do you change the camshaft sensor on a 1996 Chevy Tahoe?
its in the distributor 2 screws hold the cap on then pull the rotor again 2 screws the electrical connection going into the distributor is the cam position sensor, its held in with 2 more screws. turn the engine over until it lines up so u can get it out and ur done! about a 20 minute job.
How do you replace the door speaker in a 2001 eclipse?
You have to pop off the door panel which to do so you go aound the edge of the interior of the door and pull cause its on clips and when it comes off you simply unscrew and unplug the old speakers and screw in and plug in the new ones and when you put the door panel back on you have to hit it with the palm of your hand firmly