Ford Mustang

Parent Category: Ford
The Ford Mustang is a famous compact car built by the Ford Motor Company. The first manufactured Ford Mustang, a white convertible with black interior, was launched on April 19, 1964.
Relays are located in the engine compartment fuse panel
Look on the distributor cap there is a plug in for your tach. Answer That is not correct.... you will need to hook up four wires, actually three to make it work, but four will get the lights working too. Start by locating a good chassis ground and connect the black tach wire to it. The red tach...
If you mean for checking if you need new brakes, just feel it, if there's a lip around the outside that is getting pretty define your probably going to need brakes pretty soon
on the inside of the door, opposite of the mirror there is a plastic cover, remove the cover and the bolts holding the mirror on will be exposed.
Not a whole lot to be honest do you have Mods on the car hoe much weight it carries anything, is te engine cleaned out, is the tranny still good these are all questions you have to ask yourself if your local mechanic can also figure it out for you
2.0 marshal long block.............$2,529.79 2.5 marshal long block.............$2,584.79
I think you meant the Lamborghini Adventador. In that case, ithas 700 horsepower.
The 2007 Ford Mustang 4.0L V6 has 210HP. The 2007 Ford Mustang GT 4.6L V8 has 300HP
Depending on year.. as low as 145hp in the L65 in the mid 70's 295hp "gross" in the first in 1967 370hp "gross" in the original 1970 lt-1 405hp 1993 ZR-1 350 was the highest production 350 at 405hp
The stock engine, a 5.0 or in reality a 4.9 liter had approx 225 horsepower.
no it can't. the radiator core support on a 94-98 are the same, but ford changed over during the 99-04 model years to a design that angled back on the ends to accomodate the newer design headlight housings.
It has 300 horsepower if its a V8.. ---------------------------------------------------------------------------------------------------. The 4.6 L - SOHC - engine in the 2001 Ford Mustang GT is rated at :. 260 horsepower at 5250 RPM and 302 lb-ft torque at 4600 RPM
Answer . You remove them from inside the trunk. In the coupe anyway. I don't know about a convertible..
22.5 U.S. gallons ( 85.2 liters )
Too many variables to consider, condition, model, options, area being sold in. a good running, good condition, complete 66 Pony with a v8 and auto trans ought to sell for $10-20,000. Now I am not talking about some kids Frankenstein dream, this is a stock beauty with matching numbers and not a...
Clean vin means never salvaged or wrecked ( totaled ), and in many cases all frame, body and engine stamps match the original build sheet.
With many modifications yes. you must realize these are completely different sized engines, and the car is actually built around the engine and trans package. Smaller combo's got 4 lug wheels with lighter duty running gear while the v8's got a beefier one.
Answer . RH SIDE OF ENGINE AT END OF CRANKSHAFT
You first have to unbolt the engine from the motor mounts and unbolt the engine from the transmission. You then will remove the motor from the truck to make replacing the mounts easier. The mounts should each be held down by four bolts going into the frame. Remove or cut these bolts to remove the...
if by class, you mean breed .... mustang is its own breed.
can anyone tell me how to remove a transmission from a 1993 ford mustang 4 cylinder? Thanks sailtome69@yahoo.com
If you are interested in what events led up to the building of the first mustang you can check places like Wikipedia and Google. There you will find out how the iconic Ford Mustang came into being. Here are some links to get you started: - http://fordmustanghistory.org/the-history-of-the-ford...
if you cant get your theft light will not stop flashing rapidly your car will not start,it could be your keys are bad or your transceiver is bad your best bet is to take it to the dealership and they will pin point the problem instead of you replacing un necessary parts
On the 3800, its a simple optical gate, that reads the teeth in a toothed wheel. If you crack open most ball-mice, they work on the same concept.
All the fuses were located at the right of the steering column on the lower right flange of the brake pedal support bracket.
For that you will need to get a chilton or Haynes manual, it was option on the Mustangs created after the actual car was built, people could have it installed as an add on. For that you will need to get a chilton or Haynes manual, it wasoption on the Mustangs created after the actual car was built...
its located right in behind and above the radio, underneath the dash. its a grayish color
OK. I hope you're ready for this.. Go to your hardware store. In the glue department is some metalized epoxy that is two solid sticks that you break off equal amounts and mix it together. Use this to fix the crack. Now comes the tricky part.. This crack will continue to spread. Heating, cooling,...
Looks like the Gt500 sold for about $5,995
supercharger is belt driven and turbo is exhaust driven. supercharger boost is based on rpm and turbo boost is based on load and exhaust volume.
that head unit does NOT have an internal amplifier so you MUST use external amplification. You cannot hook it up to your car speakers and get sound. It is a pre-amp head unit ONLY. No internal amp however makes for the cleanest purest audio source that could be had in that day so it is a superb head...
Yes, it is the exact same enging block and heads. Upper intak would need to be changed and possibly the exhaust manifolds.
Answer . \nTrouble? Noise maybe or a wild speedo gage? \n. \nUnscrew the cable at the dash side (from under the hood) and spray some WD40 inside the cable. Try that or replace the cable.
GT 172 hp, Thought if you're lucky enough to get your hands on a 2003 GS-R its 180HP
There may be no specific flat rate time for a repair like that, the cost will vary depending on the labor rate and how much time the technician takes to perform repair.
Answer . \nhaynes repair manuals are good but you can go to autozone.com and they have online repair manuels as well it a good site for a lot of information on repair work.
Answer . If you look in your owners manual it will tell you the steps to take. It's kind of a pain and the requirements are exact so you have to do it right or it won't work.
It is located on a tag attached under the coil mounting bolt, all 1964-1970 models had these tags. The tag included displacement, assembly plant, model year, change level, engine code (useful in identifying high performance engines) and date of production. These are easily lost or sometimes...
The 351 was not available in the 68, but the 289 was so just use those mounts, the 351W is a small block and is the same as the 289.
There will be differences with the input shaft, and possibly bell housing, it depends on the transmission model and engine you are trying to match up, not every 1990 had the same engine or transmission. Good news is that no matter what you decide you want there is a conversion kit available, just...
\n. \n Answer \n. \n. \none reason could be the clutch, or pressure plate dont buy any cluthes or cluth kits from autozone!!!!!!\n. \n Answer \n. \ncould be a blown fuse. fuse has to be working to get out of park.\n. \nDepends what you mean by "stick". There are two cables involving the...
Your alternator is not working properly
5 quarts total, 4 in the tank and one in the filter
change the light bulb. ^another poor answer, I need to give this guy a call.. The Left turn signal is flashing fast when turned on, its usually because there is Imbalance in the circuit. If the problem is in the rear, replace the front turn signal bulb. If it is working, there may be a short in that...
standard engine has about 280-345 horsepower ======================================================== A 1990 Ford Mustang 5.0 is rated at ( 225 horsepower from thefactory )
Phillip Clark The Original Mustang I Designer and Emblem Designer, Died in 1968 after his Designs were submitted to several of the TOP Car Companies. He was 32 at his death. www.ponysite.de/phil_clark.htm Phillips Daughter HOLLY CLARK carries on his legacy. More can be learned of Phillip Clark...
The steering is locked.What you need to do to unlock it is to just turn the wheel a little bit as you turn the key and the ignition and the steering wheel will free up.
Answer . I had the same problem. Took it in to the dealer - the little sprocket that turns the other wheels was worn out. They replaced it along with a new motor - covered by warranty..
check out the online repair manual for your car at autozone.com its free and it helped me find all the fasiners for the plactic bumper cover for my 1979 mustang when I was getting it ready for paint Most American cars remove the back seat by simply pushing the seat toward the back of the car and...
$150K-$600K, depending on condition and who you purchase it from.
Freeze plugs are located on the side of the block below the exhaust headers, and at the end of each cylinder head.
1965 and 1966 Gt350's had a 271 hp 289, modified to produce 306 hp. . 1967 and 1968 Gt350 had the 289 with a COBRA aluminum hi-rise. . A GT 500 was added, equipped with the 355 horsepower 428 Police Interceptor. Carrol Shelby stopped production of his 2 seat Cobra sports car in 1967, the...
Remove the center bolt for the C/V joint... remove rotor and brake caliper, there is 4 bolts that holds it on, remove the bolts and it will come off and install in reverse order. ============================================================== This isn't true for say, a 1989 Acclaim which has the...
The 1992 Mustang LX 2.3 liter, 4 cylinder engine had an increase of horsepower to 105 due to two sparkplugs per cylinder. The V8 model had a rated horsepower of 225.
transmission's dont have drain plugs......... the metal they are made out of are to thin to tap threads...... to drain a trans. you have to lossen the pan bolts. once the car is on ramps start with the boltsw that are lower than the rest... since the pan will be at an angle go from one side the the...
Ford Motor Company has been producing the Ford Mustang since Aprilof 1964 for the 1965 model year. The Mustang is still in productionas of August of 2014.
Maybe 10 on its own. With other mods like a bigger throttle body and exhaust it will help out more.
Bad blower motor or bad fuse. Check the fuse first it is a cheap fix it is the problem. I Have 1996 Mustang and mine was blowing out the defrost and it ended up being vaccum line. 1/8 vaccum line located on the firewall I followed it across the engine to find, it broke from the boot it was plugged...
I believe that's 4.5 quarts with engine oil filter change for the 1965 Ford Mustang. 200 cubic inch straight 6 cylinder engine
A practical speed of 160 mph (257 km/hr) has been reported, and "flat out", it will do about 186 mph (300 km/hr). For 2010, the 5.4 liter DOHC has been increased to 540 horsepower, with a redline of 6250 RPM. The fifth and sixth gears have ratios of .74 and .50, down from .84 and .63, so the top...
the library has chilton repair manuals,i just copy the page,pages that i need for .10 cents a copy
It's under the hood.Lift ur hood,stand at the front of the passanger side and look straight down.It has a ball shaped top..unlike a curl or loop..so,many people can't tell that it's a dip stick.
Answer . \nCheck out this website. This pertains to late model GM and Ford vehicles.\n. \nhttp://www.a1electric.com/grandam.htm
You didn't say what engine, be a little clearer, is a 9-C1? or a civilian car, a 6 cyl perhaps? jr
132 mph (211 km/h) 0-60 mph (0-96 KM/H) 7.0 sec
According to the 2006 Ford Mustang Owner Guide : With engine oil filter change : The 4.0 liter SOHC , V6 engine takes : ( 4.7 liters / 5.0 U.S. quarts of 5W-30 )
My 1991 Ford Mustang LX 5.0 L ( 302 ) was rated at 225 horsepower
Ford Mustang 1964 1965 Factory GT FFor 1964 to 1966, the car has fog lights, dual exhaust, stiffer suspension, and front disk brakes. All of these things could be added "aftermarket" and since there is nothing in the car serial number there is no way for sure to tell if the car is a "factory...
As far as I know the GEM ( Generic Electronic Module ) controls the 4x4 on the 1995 Ford Explorer and I believe that is in the center stack of the dash behind and to the left of the radio
Answer . \ncheck the coils .they might be bad. Answer . \nI'd try plugs/wires and fuel filter first. If it backfires when revved up while running rough, probably a spark problem, plugs, wires, or coils. But could also be a fuel problem (filter or water in gas).
well some 65 fastbacks came with a straight 6, some came with a 289, and some where shelby's , you didnt say which one ? i never seen a 96 chevelle ss 396, so i ll go with the mustang by default
The drivers side of the engine
No, but it's VERY close behind the '10 GT. The new 2011 V6 only has10 horsepower less. Sends chills down my spine knowing it can getmax fuel economy of 48 miles per gallon and this performance!
*~*~Fuse Diagram~*~* . \nGo to: www.veryuseful.com/mustang/tech/engine#Diagrams\n. \nGood Luck!
Answer . \nRemove the oil pan. This will give you access to the pump.