0
Chevrolet
A brand of vehicle, Chevrolet or Chevy was produced by General Motors Company (GM). The car was named after Louis Chevrolet and was set up to sell a variety of mainstream vehicles to compete with Model T by Henry Ford.
6,429 Questions
What is the address for General Motors headquarters Detroit MI?
GM
P.O. Box 33170
Detroit, MI 48232-5170
Will the crankshaft and heads from a 1973 Chevy fit a 1990 block?
Chevy in 1977 changed the rear main oil seal to a one piece seal. the older crankshaft wont work.
What is the bed width of a 2000 Chevrolet pickup?
62.5 Inches by 80 Inches. I loaded a Qween Sized mattress in a 2004,1500 series,4 Wheel Drive and it fit
What is the payload capacity of an lmtv?
The Light Medium Tactical Vehicle (LMTV), specifically the M1083 model, has a payload capacity of approximately 5,000 to 7,000 pounds, depending on the configuration and equipment. This versatile military vehicle is designed to transport troops, cargo, and equipment in various terrains. Its robust design ensures reliability and performance in demanding conditions.
Where is the throttle position sensor located on a 1995 Astro van?
The TPS Sensor is located on the pass side of the throtle body the electric plug, plugs into the top of it and it has to small torx screws holding it on
How Do you Obtain a Title to an Abandoned Car in AZ?
Call AE Recovery in Glendale, AZ. They can help answer all your questions regarding the abandoned vehicle titling process. Check out their website. http://www.aerecoveryandtowing.com. They helped me get a title for the car that was in the backyard for 13 years. Hope this helps!
What is the FACTORY code for delco car stereo model 09394159 to unlock the raido?
you will probably have to take it to a Chevrolet dealer and have them unlock it
What engine is in a 1991 Chevy c1500?
there could be any of at least three engines in that vehicle. The first and probably most likely is a v6 which i believe is a 4.3L, The second is a V8 305 or 5.0L and the third is a v8 350 or 5.7L. There is also the possibility of the 454 but it is unlikely you wouldn't know that's what you had. If someone has modified the engine it could be a 383 stroker. But I wouldn't get my hopes up. Count the spark plug wires. If it has 6 its a v6 if it has 8 its a v8.
Even better if you radiator shroud is intact and the stickers are still on it, it should say what size engine came with the truck.
1-8-4-3-6-5-7-2 Distributor rotates clockwise.
What is the hp for a 1983 454?
210 hp and 340 ft lbs of torque according to haynes manual and chiltons.
Is there a 60-70's Chevy vehicle with disc brakes which will fit on a 66 Biscayne's spindle joints?
I don't know exactly, but check a mid seventy's half ton van. ya may get lucky
What is the firing order Chevy lumnia 3.1?
The firing order for Chevy Lumina 1996 with 3.1 engine and 6 cylinders
is: 1-2-3-4-5-6 in acordance to HAYNES book: Chevrolet lumina & Monte Carlo
1995 thru 1999 all models. Chapter 2 part A ( 2A-1) page. 3.1L V6 engines.
George C.
Is a 427 Chevrolet engine a 6.0 liter engine?
No; a 427 is approx. 7 liter. 1 liter is approx. 61 cubic inches.
Can you take the lug nuts off a car while its on the ground?
Yes but do not take them all off. Leave at least two on the wheel opposite each other before jacking it up. You can loosen those two but do not remove.
How do you identify th350 trans from th400?
This link helped me, try it out. http://www.stevesnovasite.com/forums/showthread.php?p=195904 /Stephan
How many lugs does the Chevy 1500 4x4 have?
The 1500 has 6 lugs as where the 2500 has 8 lugs per wheel>
If you have the money, you can do anything
They do it all the time. 600+ HP.
How many quarts of oil does a Chevy 400 small block take?
5 quarts, same as all the rest of Chevy small blocks
Did a nv4500 transmission come in a 1994 Chevrolet 1500 pick up with a 4.3 engine?
There is a chance, but a slim one at best.
The easiest way to tell is the shift knob reading (L 1 2 3 OD).
The next way to tell is if the transmission casing is iron.
Also, there should be a door on each side of the tranny held by 6 bolts if it's the 4500
Will a starter from a Chevy small block work for a Chevy big block?
Yes. But, here is a bit of closely gaurded information for you. The starters that require a spacer to bolt up the selenoid to that arm that just sticks out of the starter, as opposed to the ones that do not require the spacer. The ones that do, are a higher torque model, or big block version. That is why that arm is further out. Bigger armature.
